A new knockout tournament seeding method and its axiomatic justification

2016 ◽  
Vol 44 (6) ◽  
pp. 706-711 ◽  
Author(s):  
Alexander Karpov
Author(s):  
Sengshiu Chung ◽  
Peggy Cebe

We are studying the crystallization and annealing behavior of high performance polymers, like poly(p-pheny1ene sulfide) PPS, and poly-(etheretherketone), PEEK. Our purpose is to determine whether PPS, which is similar in many ways to PEEK, undergoes reorganization during annealing. In an effort to address the issue of reorganization, we are studying solution grown single crystals of PPS as model materials.Observation of solution grown PPS crystals has been reported. Even from dilute solution, embrionic spherulites and aggregates were formed. We observe that these morphologies result when solutions containing uncrystallized polymer are cooled. To obtain samples of uniform single crystals, we have used two-stage self seeding and solution replacement techniques.


Author(s):  
A. Vovkohon ◽  
V. Nadtochiy ◽  
G. Kalinina ◽  
O. Hrebelnyk ◽  
N. Fedoruk ◽  
...  

The article highlights comparative research results of milk quality indices obtained from the milking in specialized milking halls with such milking units as «Parallel», «Carousel» or in stalls with the milking unit «Molokoprovid». The fat and protein mass fraction, dry matter and fat-free dry matter, density, titratable and active acidity, heat resistance and freezing point have been determined according to the accepted techniques. The electrical conductivity of milk has been determined by using the analytical device MD-20 MAS-D-TEC. The total amount of milk bacteria has been determined by reductase reduction test and by seeding method in Petri dish. The milk quality has been investigated by the fermentation and rennet fermentation tests. The higher indices of the fat mass fraction, the protein mass fraction and the dry substance concentration of milk, obtained in specialized milking halls, have been established. This is not statistically significant. Milk, obtained from the milking unit «Molokoprovid», has higher index of titratable acidity, lower thermal stability in comparison with milk, obtained from specialized milking halls with milking units «Parallel» and «Carousel». It has been determined that there is the bacteria insemination increase in milk received from milking cows in stalls in comparison with milk, obtained from milking in specialized halls. Milk, obtained from the milking unit «Carousel», indicates the subclinical form of mastitis in cows or «Carousel» operation violationif there is in 1,8 mS/cm conductivity increase above average index 4,6 mS/cm. Key words: technology, quality and safety of milk, milking, milking unit, milking hall, bacterial insemination.


1978 ◽  
Vol 58 (2) ◽  
pp. 549-550 ◽  
Author(s):  
J. M. CLARKE ◽  
F. R. CLARKE ◽  
G. M. SIMPSON

Broadcast and drill seeding of Brassica napus L. were compared at four seeding rates. Drill-seeded material yielded more than broadcast-seeded material, particularly at the low seeding rates. Broadcast-seeded plants had more branches and pods than drill-seeded plants. Seeding method did not affect number of seeds per pod or 1,000-seed weight.


2013 ◽  
Vol 807-809 ◽  
pp. 591-595
Author(s):  
Hong Liang Chen ◽  
Ji Song Yang ◽  
Yan Wang ◽  
Hui Ying Li ◽  
Xin Xin Li ◽  
...  

High performance silicalite-1 membranes were successfully synthesized on silica tubes by seeding method after filling the tubes with water and glycerol mixtures. After seeding the silica tubes with 200 nm seeds, all the silicalite-1 membranes show acceptable separation performance towards ethanol/water mixture after 4-12 h hydrothermal synthesis, and the highest flux of membrane with 8 h hydrothermal synthesis reaches about 0.98 kg/m2.h and the separation factor reaches about 60 towards 3 wt.% ethanol/water mixture. This result shows that the as-synthesized silicalite-1 membrane can concentrate the ethanol from 3% to about 65%, and the ethanol can be obtained over 600 g/m2.h by using the silicalite-1 membrane, which shows that seeding method and suitable control of synthesis conditions is possible for preparing high-performance silicalite-1 membranes.


2000 ◽  
Vol 107 (2) ◽  
pp. 140 ◽  
Author(s):  
Allen J. Schwenk
Keyword(s):  

1999 ◽  
Vol 2 (1) ◽  
pp. 53-57 ◽  
Author(s):  
Hideto Ueno ◽  
Motoko Shimura ◽  
Minoru Yamauchi

2007 ◽  
Vol 124-126 ◽  
pp. 587-590
Author(s):  
Sung Hak Yi ◽  
Jae Min Jang ◽  
Seung Kyu Choi ◽  
Woo Gwang Jung

The ZnO seed precursor was prepared by sol-gel reaction. ZnO nanorod arrays were fabricated by solution chemical deposition on ZnO coated seed substrates. The substrates used are Si wafer, glass and PET. The fabricated ZnO nanorod had hexagonal morphology, length of 400~500 nm and diameter of 25~50 nm. The ZnO seeds were indispensable for the aligned growth of ZnO nanorod. The ZnO nanorod growth was dependent on the seeding method used but independent of the substrates. The structure of ZnO nanorod was characterized by FE-SEM, XRD and FE-TEM. This method enables large scale growth of ZnO arrays on all kinds of substrates including polymers.


2018 ◽  
Vol 6 (18) ◽  
pp. 8757-8762 ◽  
Author(s):  
Risheng Bai ◽  
Qiming Sun ◽  
Yue Song ◽  
Ning Wang ◽  
Tianjun Zhang ◽  
...  

Crystallization time-modulated catalytic activity for oxidative desulfurization has been demonstrated over titanosilicate zeolite catalysts prepared by a seeding method.


Sign in / Sign up

Export Citation Format

Share Document