Investigation on the growth of snowflake-shaped Poly(l-Lactic acid) crystal by in-situ high-pressure microscope

Polymer ◽  
2019 ◽  
Vol 177 ◽  
pp. 25-34 ◽  
Author(s):  
Lei Zhang ◽  
Guoqun Zhao ◽  
Guilong Wang
Soft Matter ◽  
2019 ◽  
Vol 15 (28) ◽  
pp. 5714-5727 ◽  
Author(s):  
Lei Zhang ◽  
Guoqun Zhao ◽  
Guilong Wang

The rhythmic growth of the bamboo-like branch of PLLA crystals under pressurized CO2.


2020 ◽  
Author(s):  
Keishiro Yamashita ◽  
Kazuki Komatsu ◽  
Hiroyuki Kagi

An crystal-growth technique for single crystal x-ray structure analysis of high-pressure forms of hydrogen-bonded crystals is proposed. We used alcohol mixture (methanol: ethanol = 4:1 in volumetric ratio), which is a widely used pressure transmitting medium, inhibiting the nucleation and growth of unwanted crystals. In this paper, two kinds of single crystals which have not been obtained using a conventional experimental technique were obtained using this technique: ice VI at 1.99 GPa and MgCl<sub>2</sub>·7H<sub>2</sub>O at 2.50 GPa at room temperature. Here we first report the crystal structure of MgCl2·7H2O. This technique simultaneously meets the requirement of hydrostaticity for high-pressure experiments and has feasibility for further in-situ measurements.


2021 ◽  
Vol 1 (7) ◽  
pp. 305-305
Author(s):  
Jana Weiß ◽  
Christine Rautenberg ◽  
Thomas Rall ◽  
Christoph Kubis ◽  
Evgenii Kondratenko ◽  
...  

2021 ◽  
Vol 1 (7) ◽  
pp. 308-314
Author(s):  
Jana Weiß ◽  
Christine Rautenberg ◽  
Thomas Rall ◽  
Christoph Kubis ◽  
Evgenii Kondratenko ◽  
...  

2021 ◽  
pp. 51413
Author(s):  
Rong Yang ◽  
Hongwei Cao ◽  
Chong Li ◽  
Guoxiang Zou ◽  
Xin Zhang ◽  
...  

Author(s):  
Rebecca Scatena ◽  
Michał Andrzejewski ◽  
Roger D Johnson ◽  
Piero Macchi

Through in-situ, high-pressure x-ray diffraction experiments we have shown that the homoleptic perovskite-like coordination polymer [(CH3)2NH2]Cu(HCOO)3 undergoes a pressure-induced orbital reordering phase transition above 5.20 GPa. This transition is distinct...


2020 ◽  
Vol 98 (11) ◽  
Author(s):  
Ana L M Gomes ◽  
Antonio V I Bueno ◽  
Fernando A Jacovaci ◽  
Guilherme Donadel ◽  
Luiz F Ferraretto ◽  
...  

Abstract Our objective was to examine the effects of processing, moisture, and anaerobic storage length of reconstituted corn grain (RCG) on the fermentation profile, geometric mean particle size (GMPS), and ruminal dry matter disappearance (DMD). Dry corn kernels were ground (hammer mill, 5-mm screen) or rolled, then rehydrated to 30%, 35%, or 40% moisture, and stored for 0, 14, 30, 60, 90, 120, or 180 d in laboratory silos. Rolled corn had an increased GMPS compared with ground corn (2.24 and 1.13 mm, respectively, at ensiling). However, there was a trend for an interaction between processing and moisture concentration to affect particle size, with GMPS increasing with increased moisture concentration, especially in ground corn. Longer storage periods also slightly increased GMPS. Processing, moisture, and storage length interacted to affect the fermentation pattern (two- or three-way interactions). Overall, pH decreased, whereas lactic acid, acetic acid, ethanol, and NH3-N increased with storage length. RCG with 30% moisture had less lactic acid than corn with 35% and 40% moisture, indicating that fermentation might have been curtailed and also due to the clostridial fermentation that converts lactic acid to butyric acid. Ensiling reconstituted ground corn with 30% of moisture led to greater concentrations of ethanol and butyric acid, resulting in greater DM loss than grain rehydrated to 35% or 40% of moisture. Ammonia-N and in situ ruminal DMD were highest for reconstituted ground corn with 35% or 40% of moisture, mainly after 60 d of storage. Therefore, longer storage periods and greater moisture contents did not offset the negative effect of greater particle size on the in situ ruminal DMD of rolled RCG. Nonetheless, RCG should be ensiled with more than 30% moisture and stored for at least 2 mo to improve the ruminal DMD and reduce the formation of ethanol and butyric acid.


Sign in / Sign up

Export Citation Format

Share Document