Model-based strategy for nitrogen removal enhancement in full-scale wastewater treatment plants by GPS-X integrated with response surface methodology

2021 ◽  
Vol 769 ◽  
pp. 144851
Author(s):  
Jiashun Cao ◽  
E. Yang ◽  
Chengzhi Xu ◽  
Teng Zhang ◽  
Runze Xu ◽  
...  
Keyword(s):  
Response Surface Methodology ◽  
Wastewater Treatment ◽  
Response Surface ◽  
Nitrogen Removal ◽  
Wastewater Treatment Plants ◽  
Full Scale ◽  
Model Based

scholarly journals Effect of COD:N ratio on biological nitrogen removal using full-scale step-feed in municipal wastewater treatment plants

2020 ◽  
Vol 30 (1) ◽  
Author(s):  
Supaporn Phanwilai ◽  
Pongsak Noophan ◽  
Chi-Wang Li ◽  
Kwang-Ho Choo
Keyword(s):  
Wastewater Treatment ◽  
Nitrogen Removal ◽  
Municipal Wastewater ◽  
Wastewater Treatment Plants ◽  
Full Scale ◽  
Biological Nitrogen Removal ◽  
Municipal Wastewater Treatment ◽  
Municipal Wastewater Treatment Plants ◽  
Scale Step ◽  
Biological Nitrogen

Abstract This study investigated the effect of low and high chemical oxygen demand (COD):N ratios on biological nitrogen removal and microbial distributions in full-scale step-feed (SF) municipal wastewater treatment plants (WWTPs) in Thailand (SF1) and Taiwan (SF2). The SF1 WWTP had a low COD:N (4:1) ratio, a long solids retention time (SRT) (> 60 d), and low dissolved oxygen (DO) conditions (0.2 mg L− 1 in anoxic tank and 0.9 mg L− 1 in aerobic tank). The total nitrogen (TN) removal efficiency was 48%. The SF2 WWTP had a high COD:N (10:1) ratio, a short SRT (7 d), and high DO (0.6 mg L− 1 in anoxic tank and 1.8 mg L− 1 in aerobic tank). The TN removal efficiency was 61%. The nitrification and denitrification rates from these two plants were inadequate. Using a quantitative polymerase chain reaction (qPCR) technique, the populations of ammonium oxidizing bacteria (AOB) and ammonium oxidizing archaea were quantified. Measurement of ammonia monooxygenase (amoA) gene abundances identified these AOB: Nitrosomonas sp., Nitrosospira sp., Nitrosoccus sp. and Zoogloea sp. Higher amounts of the archaeal-amoA gene were found with long SRT, lower DO and COD:N ratios. Abundance of Nitrobacter sp. was slightly higher than Nitrospira sp. at the SF1, while abundance of Nitrobacter sp. was two orders of magnitude greater than Nitrospira sp. at the SF2. More denitrifying bacteria were of the nirS-type than the nirK-type, especially at higher COD:N ratio. Most bacteria belong to the phyla Acidobacteria, Actinobacteria Bacteroidetes, Chloroflexi, Proteobacteria. The results from this work showed that insufficient carbon sources at the SF1 and high DO concentration in anoxic tank of SF2 adversely affected nitrogen removal efficiencies. In further research work, advanced techniques on the next generation sequencing with different variable regions should be recommended in full-scale WWTPs.

scholarly journals Comparison of Nitrogen Removal Efficiencies and Microbial Communities of Full-Scale Anaerobic, Anoxic and Aerobic Processes in Municipal Wastewater Treatment Plants having Low and High COD/TN Ratios

2021 ◽  
Author(s):  
Supaporn Phanwilai ◽  
Pongsak Noophan ◽  
Chi-Wang Li ◽  
Kwang-Ho Choo
Keyword(s):  
Wastewater Treatment ◽  
Microbial Communities ◽  
Removal Efficiency ◽  
Nitrogen Removal ◽  
Municipal Wastewater ◽  
Wastewater Treatment Plants ◽  
Full Scale ◽  
Biological Nutrient Removal ◽  
Distribution Analysis ◽  
Microbial Distribution

Abstract Full-scale anaerobic, anoxic and aerobic (A2O) process is used worldwide for biological nutrient removal (BNR). However, operation parameters for nitrogen removals and information of microbial communities related to nitrogen removal in full-scale A2O wastewater treatment plants (WWTPs) having low and high COD/TN ratios are not available. Based on the analysis of four full-scale A2O WWTPs, it is suggested that maintaining longer SRT of ≥ 30 day and DO of ≥ 0.9±0.2 mg-O2 L-1 is needed to improve nitrogen removal efficiency under low COD/TN ratio (≤ 3.7). On other hand, at high COD/TN ratio (≥ 4.2), DO level of ≥ 2.6 mg-O2 /L and typical SRT of 19‒ 25 days would be suggested. It was confirmed that phosphorus removal efficiency significantly improved under BOD/TP ratio of > 20 for A2O process in these full-scale WWTP. Microbial distribution analysis showed that ammonia-oxidizing archaea (AOA) was abundant under conditions of low DO level, longer SRT, high temperature and low COD/TN ratio (≤ 3.7). Nitrosomonas sp. are mostly found in aerobic tank of full-scale A2O WWTPs. However, abundances of Nitrosomonas sp. are proportional to DO and NH4+ concentrations for WWTPs with high COD/TN ratio. Nitrosospira sp. are only found under operating condition of longer SRT for WWTPs with low COD/TN ratio. Abundances of Nitrobacter sp. are proportional to DO concentration and temperature rather than abundance of Nitrospira sp. Predominance of nosZ-type denitrifiers were found at low COD/TN ratio. Abundance of denitrifiers by using nirS genes was over abundance of denitrifiers by using nirK genes at high COD/TN ratios WWTPs.

Combined quantity management and biological treatment of sludge liquor at Hamburg's wastewater treatment plants - first experience in operation with the Store and Treat process

2004 ◽  
Vol 50 (7) ◽  
pp. 49-52
Author(s):  
F. Laurich
Keyword(s):  
Wastewater Treatment ◽  
Energy Consumption ◽  
Nitrogen Removal ◽  
Biological Treatment ◽  
Wastewater Treatment Plants ◽  
Full Scale ◽  
Process Waste ◽  
Reduce Energy Consumption

Store and Treat (SAT) is a new concept for the management of ammonium-rich process waste aters at wastewater treatment plants. It combines the advantages of quantity management and separate biological treatment, whereby both operations are carried out in the same tank. Now the first full-scale application of that method was realized in Hamburg. As first experience shows the process can help to increase nitrogen removal and to reduce energy consumption.

Nutrient Removal in Small Wastewater Treatment Plants

1990 ◽  
Vol 22 (3-4) ◽  
pp. 211-216
Author(s):  
Niels Skov Olesen
Keyword(s):  
Wastewater Treatment ◽  
Nitrogen Removal ◽  
Nutrient Removal ◽  
Phosphorus Removal ◽  
Wastewater Treatment Plants ◽  
Ferrous Sulphate ◽  
Practical Solution ◽  
Sensitive Technique ◽  
Pumping Station ◽  
Denitrification Reactor

In some areas of Denmark nutrient removal is required even for very small wastewater plants, that is down to 500 pe (pe = person equivalents). The goal for the removal is 80% removal of nitrogen and 90% removal of phosphorus, or in terms of concentrations: 8 mg nitrogen/l and 1.2 mg phosphorus/l. The inlet concentrations are typically 40 mg N/l and 10 mg P/l. The paper presents the results from two such plants with a capacity of 800 pe. Phosphorus removal is made by simultaneous precipitation with ferrous sulphate. Nitrogen removal is carried out using the recirculation method. Both plants were originally rotor aerated oxidation ditches. They have been extended with a denitrification reactor and a recirculation pumping station. At present both plants have been in activity for about 3 years and with satisfactory results. Average concentrations of nitrogen (summer) and phosphorus is 7 mg/l and 0.9 mg/l respectively. Nitrogen removal seems to be a practical solution on these small plants. It is,though, sensitive to temperature and highly oxidized rain water. Phosphorus removal seems to be an easily run and relatively non-sensitive technique at least when using simultaneous precipitation.

Automatic buffer capacity based sensor for effluent quality monitoring

1996 ◽  
Vol 33 (1) ◽  
pp. 81-87
Author(s):  
L. Van Vooren ◽  
P. Willems ◽  
J. P. Ottoy ◽  
G. C. Vansteenkiste ◽  
W. Verstraete
Keyword(s):  
Wastewater Treatment ◽  
Buffer Capacity ◽  
Wastewater Treatment Plants ◽  
Data Interpretation ◽  
Full Scale ◽  
Quality Monitoring ◽  
Effluent Quality ◽  
Capacity Curves ◽  
On Line

The use of an automatic on-line titration unit for monitoring the effluent quality of wastewater plants is presented. Buffer capacity curves of different effluent types were studied and validation results are presented for both domestic and industrial full-scale wastewater treatment plants. Ammonium and ortho-phosphate monitoring of the effluent were established by using a simple titration device, connected to a data-interpretation unit. The use of this sensor as the activator of an effluent quality proportional sampler is discussed.

Sign in / Sign up

Export Citation Format

Share Document