Robust and High Selective Chitosan Asymmetric Membranes: Relation Between Microporous Structure and Pervaporative Efficiency in Ethanol Dehydration

2021 ◽  
pp. 119897
Author(s):  
Paweł Grzybek ◽  
Łukasz Jakubski ◽  
Przemysław Borys ◽  
Sławomir Kołodziej ◽  
Czesław Ślusarczyk ◽  
...  
Keyword(s):  
Microporous Structure ◽  
Ethanol Dehydration ◽  
Asymmetric Membranes

Ultrastructure of Some Planktonic Formainifera

1974 ◽  
Vol 32 ◽  
pp. 190-191
Author(s):  
William H. Zucker
Keyword(s):  
Cell Biology ◽  
Water Mass ◽  
Planktonic Foraminifera ◽  
Uranyl Acetate ◽  
Ethanol Dehydration ◽  
Globigerinoides Ruber ◽  
Light Microscope Level ◽  
Globigerina Bulloides ◽  
Glutaraldehyde Solution ◽  
Diamond Knife

Planktonic foraminifera are widely-distributed and abundant zooplankters. They are significant as water mass indicators and provide evidence of paleotemperatures and events which occurred during Pleistocene glaciation. In spite of their ecological and paleological significance, little is known of their cell biology. There are few cytological studies of these organisms at the light microscope level and some recent reports of their ultrastructure.Specimens of Globigerinoides ruber, Globigerina bulloides, Globigerinoides conglobatus and Globigerinita glutinata were collected in Bermuda waters and fixed in a cold cacodylate-buffered 6% glutaraldehyde solution for two hours. They were then rinsed, post-fixed in Palade's fluid, rinsed again and stained with uranyl acetate. This was followed by graded ethanol dehydration, during which they were identified and picked clean of debris. The specimens were finally embedded in Epon 812 by placing each organism in a separate BEEM capsule. After sectioning with a diamond knife, stained sections were viewed in a Philips 200 electron microscope.

The significance of SEM in the diagnosis of haematopoietic malignancies

1978 ◽  
Vol 36 (2) ◽  
pp. 314-315
Author(s):  
Etienne de Harven ◽  
Nina Lampen
Keyword(s):  
Room Temperature ◽  
Culture Medium ◽  
Cell Attachment ◽  
Ethanol Dehydration ◽  
Moist Chamber ◽  
Efficient Alternative ◽  
Mononuclear Leucocytes ◽  
Fast Quenching ◽  
Freeze Dryer ◽  
Scanning Electron

Samples of heparinized blood, or bone marrow aspirates, or cell suspensions prepared from biopsied tissues (nodes, spleen, etc. ) are routinely prepared, after Ficoll-Hypaque concentration of the mononuclear leucocytes, for scanning electron microscopy. One drop of the cell suspension is placed in a moist chamber on a poly-l-lysine pretreated plastic coverslip (Mazia et al., J. Cell Biol. 66:198-199, 1975) and fifteen minutes allowed for cell attachment. Fixation, started in 2. 5% glutaraldehyde in culture medium at room temperature for 30 minutes, is continued in the same fixative at 4°C overnight or longer. Ethanol dehydration is immediately followed by drying at the critical point of CO2 or of Freon 13. An efficient alternative method for ethanol dehydrated cells is to dry the cells at low temperature (-75°C) under vacuum (10-2 Torr) for 30 minutes in an Edwards-Pearse freeze-dryer (de Harven et al., SEM/IITRI/1977, 519-524). This is preceded by fast quenching in supercooled ethanol (between -90 and -100°C).

Surface roughness measurements of vanadium-contaminated fluidized cracking catalysts by atomic force microscopy

1996 ◽  
Vol 54 ◽  
pp. 866-867
Author(s):  
H. Kinney ◽  
M.L. Occelli ◽  
S.A.C. Gould
Keyword(s):  
Surface Roughness ◽  
Zeolite Y ◽  
Atomic Level ◽  
Microporous Structure ◽  
Contact Mode ◽  
Force Microscopy ◽  
Atomic Force ◽  
Before And After ◽  
Roughness Measurements ◽  
Cracking Catalysts

For this study we have used a contact mode atomic force microscope (AFM) to study to topography of fluidized cracking catalysts (FCC), before and after contamination with 5% vanadium. We selected the AFM because of its ability to well characterize the surface roughness of materials down to the atomic level. It is believed that the cracking in the FCCs occurs mainly on the catalysts top 10-15 μm suggesting that the surface corrugation could play a key role in the FCCs microactivity properties. To test this hypothesis, we chose vanadium as a contaminate because this metal is capable of irreversibly destroying the FCC crystallinity as well as it microporous structure. In addition, we wanted to examine the extent to which steaming affects the vanadium contaminated FCC. Using the AFM, we measured the surface roughness of FCCs, before and after contamination and after steaming.We obtained our FCC (GRZ-1) from Davison. The FCC is generated so that it contains and estimated 35% rare earth exchaged zeolite Y, 50% kaolin and 15% binder.

Elemental analysis of human erythrocytes

1989 ◽  
Vol 47 ◽  
pp. 242-243
Author(s):  
S. A. Livesey ◽  
A. A. del Campo ◽  
E. S. Griffey ◽  
D. Ohlmer ◽  
T. Schifani ◽  
...  
Keyword(s):  
Sample Preparation ◽  
Elemental Analysis ◽  
Human Erythrocyte ◽  
Spectroscopic Analysis ◽  
Model System ◽  
Human Erythrocytes ◽  
List Type ◽  
Chemical Fixation ◽  
Ethanol Dehydration ◽  
Lowicryl K4m

The aim of this study is to compare methods of sample preparation for elemental analysis. The model system which is used is the human erythrocyte. Energy dispersive spectroscopic analysis has been previously reported for cryofixed and cryosectioned erythrocytes. Such work represents the reference point for this study. The use of plastic embedded samples for elemental analysis has also been documented. The work which is presented here is based on human erythrocytes which have been either chemically fixed and embedded or cryofixed and subsequently processed by a variety of techniques which culminated in plastic embedded samples.Heparinized and washed erythrocytes were prepared by the following methods for this study :(1). Chemical fixation in 4% paraformaldehyde/0.25% glutaraldehyde/0.2 M sucrose in 0.1 M Na cacodylate, pH 7.3 for 30 min, followed by ethanol dehydration, infiltration and embedding in Lowicryl K4M at -20° C.

Porous Structure and Transport Properties of a Carbonized Phenolic Resin

1995 ◽  
Vol 60 (2) ◽  
pp. 172-187 ◽  
Author(s):  
Pavel Fott ◽  
František Kolář ◽  
Zuzana Weishauptová
Keyword(s):  
Porous Structure ◽  
Transport Properties ◽  
Phenolic Resin ◽  
Arrhenius Equation ◽  
Mercury Porosimetry ◽  
Micropore Volume ◽  
Microporous Structure ◽  
Wetting And Drying ◽  
Phenolic Resins ◽  
Kinetics Of

On carbonizing phenolic resins, the development of porous structure takes place which influences the transport properties of carbonized materials. To give a true picture of this effect, specimens in the shape of plates were prepared and carbonized at various temperatures. The carbonizates obtained were studied by adsorption methods, electron microscopy, and mercury porosimetry. Diffusivities were evaluated in terms of measuring the kinetics of wetting and drying. It was found out that the porous structure of specimens in different stages of carbonization is formed mostly by micropores whose volumes were within 0.06 to 0.22 cm3/g. The maximum micropore volume is reached at the temperature of 750 °C. The dependence of diffusivity on the carbonization temperature is nearly constant at first, begins to increase in the vicinity of 400 °C, and at 600 °C attains its maximum. The experimental results reached are in agreement with the conception of the development and gradual closing of the microporous structure in the course of carbonization. The dependence of diffusivity on temperature can be expressed by the Arrhenius equation. In this connection, two possible models of mass transport were discussed.

Microporous structure and mechanical behavior of separators used for lithium-ion battery

2021 ◽  
Vol 28 (3) ◽  
Author(s):  
Lei Ding ◽  
Daoxin Zhang ◽  
Sihang Zhang ◽  
Tong Wu ◽  
Feng Yang ◽  
...  
Keyword(s):  
Mechanical Behavior ◽  
Lithium Ion Battery ◽  
Lithium Ion ◽  
Microporous Structure

scholarly journals Computer Analysis of the Effect of Activation Temperature on the Microporous Structure Development of Activated Carbon Derived from Common Polypody

Materials ◽  
2021 ◽  
Vol 14 (11) ◽  
pp. 2951
Author(s):  
Mirosław Kwiatkowski ◽  
Jarosław Serafin ◽  
Andy M. Booth ◽  
Beata Michalkiewicz
Keyword(s):  
Activated Carbon ◽  
Porous Structure ◽  
Computer Analysis ◽  
Density Functional ◽  
Activated Carbons ◽  
Chemical Activation ◽  
Geometrical Parameters ◽  
Activation Process ◽  
Microporous Structure ◽  
Activation Temperature

This paper presents the results of a computer analysis of the effect of activation process temperature on the development of the microporous structure of activated carbon derived from the leaves of common polypody (Polypodium vulgare) via chemical activation with phosphoric acid (H3PO4) at activation temperatures of 700, 800, and 900 °C. An unconventional approach to porous structure analysis, using the new numerical clustering-based adsorption analysis (LBET) method together with the implemented unique gas state equation, was used in this study. The LBET method is based on unique mathematical models that take into account, in addition to surface heterogeneity, the possibility of molecule clusters branching and the geometric and energy limitations of adsorbate cluster formation. It enabled us to determine a set of parameters comprehensively and reliably describing the porous structure of carbon material on the basis of the determined adsorption isotherm. Porous structure analyses using the LBET method were based on nitrogen (N2), carbon dioxide (CO2), and methane (CH4) adsorption isotherms determined for individual activated carbon. The analyses carried out showed the highest CO2 adsorption capacity for activated carbon obtained was at an activation temperature of 900 °C, a value only slightly higher than that obtained for activated carbon prepared at 700 °C, but the values of geometrical parameters determined for these activated carbons showed significant differences. The results of the analyses obtained with the LBET method were also compared with the results of iodine number analysis and the results obtained with the Brunauer–Emmett–Teller (BET), Dubinin–Radushkevich (DR), and quenched solid density functional theory (QSDFT) methods, demonstrating their complementarity.

Sign in / Sign up

Export Citation Format

Share Document