Combining magnetic filtered cathodic arc deposition with ion beam sputtering to afford superhard TiSiN multilayer composite films with tunable microstructure and mechanical properties

Vacuum ◽  
2016 ◽  
Vol 125 ◽  
pp. 6-12 ◽  
Author(s):  
Yujuan Zhang ◽  
Yingze Yang ◽  
Hongwei Ding ◽  
Yi Peng ◽  
Shengmao Zhang ◽  
...  
2017 ◽  
Vol 743 ◽  
pp. 112-117
Author(s):  
Alexander Zolkin ◽  
Anna Semerikova ◽  
Sergey Chepkasov ◽  
Maksim Khomyakov

In the present study, the Raman spectra of diamond-like amorphous (a-C) and hydrogenated amorphous (a-C:H) carbon films on silicon obtained using the ion-beam methods and the pulse cathodic arc deposition technique were investigated with the aim of elucidating the relation between the hardness and structure of the films. The hardness of the samples used in the present study was 19 – 45 GPa. Hydrogenated carbon films were synthesized using END–Hall ion sources and a linear anode layer ion source (LIS) on single-crystal silicon substrates. The gas precursors were CH4 and C3H8, and the rate of the gas flow fed into the ion source was 4.4 to 10 sccm. The ion energies ranged from 150 to 600 eV. a-C films were deposited onto Si substrates using the pulse cathodic arc deposition technique. The films obtained by the pulse arc technique contained elements with an ordered structure. In the films synthesized using low- (150 eV) and high-energy (600 eV) ions beams, an amorphous phase was the major phase. The significant blurriness of the diffraction rings in the electron diffraction patterns due to a large film thickness (180 – 250 nm) did not allow distinctly observing the signals from the elements with an ordered structure against the background of an amorphous phase.


2018 ◽  
Vol 60 (5) ◽  
pp. 1005
Author(s):  
В.А. Терехов ◽  
Д.С. Усольцева ◽  
О.В. Сербин ◽  
И.Е. Занин ◽  
Т.В. Куликова ◽  
...  

AbstractThe peculiarities of the phase composition and electronic structure of aluminum–silicon composite films near the Al_0.75Si_0.25 composition obtained by the magnetron and ion-beam sputtering methods on a Si(100) silicon substrate are studied using the X-ray diffraction techniques and ultrasoft X-ray emission spectroscopy. In addition to silicon nanocrystals of about 25 nm in size, an ordered solid solution corresponding to the previously unknown Al_3Si phase is formed in magnetron sputtering on a polycrystalline Al matrix. Films obtained by ion-beam sputtering of the composite target are found to be monophasic and contained only one phase of an ordered solid solution of aluminum silicide Al_3Si of the Pm3m cubic system with the primitive cell parameter a = 4.085 Å. However, subsequent pulsed photon annealing of the composite with different radiation doses from 145 to 216 J/cm^2 gives rise to the partial decomposition of the Al_3Si phase with the formation of free metallic aluminum and silicon nanocrystals with sizes in the range from 50 to 100 nm, depending on the pulsed photon radiation dose.


1988 ◽  
Vol 129 ◽  
Author(s):  
F. L. Williams ◽  
L. L. Boyer ◽  
W. Reicher ◽  
J. J. McNally ◽  
G. A. Al-Jumaily ◽  
...  

ABSTRACTWe have deposited thin films of optical materials using ion beam sputtering and ion assisted deposition techniques. It is possible to obtain good quality film material deposited on substrates at temperatures lower than normally required. Ion assisted deposition influences film stoichiometry and packing density, which in turn determine optical and mechanical properties of the film material. We discuss two general indicators which appear helpful in predicting the degree to which these occur.


2003 ◽  
Vol 426-432 ◽  
pp. 3451-3456 ◽  
Author(s):  
Philippe Goudeau ◽  
N. Merakeb ◽  
J.P. Eymery ◽  
D. Faurie ◽  
B. Boubeker ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document