A study on stability limits of spiral grooved journal bearing with considering the effect of cavitation

Author(s):  
T. Hirayama ◽  
T. Sakurai ◽  
H. Yabe
2012 ◽  
Vol 135 (1) ◽  
Author(s):  
Rodrigo Nicoletti

This work presents an optimization procedure to find bearing profiles that improve stability margins of rotor-bearing systems. The profile is defined by control points and cubic splines. Stability margins are estimated using bearing dynamic coefficients, and obtained solutions are analyzed as a function of the number of control points and of the Sommerfeld number at optimization. Results show the feasibility of finding shapes for the bearing that significantly improve the stability margins. Some of the obtained solutions overcome the stability margins of conventional bearings, such as the journal bearing and preloaded bearings with 0.5 and 0.67 preload. A time domain simulation of a flexible shaft rotating system supported by such bearings corroborates the results.


1967 ◽  
Vol 89 (3) ◽  
pp. 369-373 ◽  
Author(s):  
J. V. Beck ◽  
C. L. Strodtman

An investigation is made of the regions of stability for a compressible fluid, squeeze-film journal bearing of infinite length. Motion along one axis considered and the resulting dynamic equation is solved two ways: by variational techniques and by numerical techniques. The solution from the variational analysis can be approximated by a Mathieu equation thus showing that instability can occur at one-half the driving frequency. The numerical analysis shows the stability limits in terms of the load, drive amplitude, and dimensionless “mass.” The stability analysis is significant as there appears to be a rather large number of combinations of the parameters for which the squeeze-film journal is not stable. The stability characteristics of a squeeze-film bearing should, therefore, be examined carefully before application.


2019 ◽  
Vol 13 (3) ◽  
pp. 5278-5293
Author(s):  
Vipul Patel ◽  
Rupesh Shah

The present research aims to analyse diffusion flame in a tube type burner with Liquefied petroleum gas (LPG) as a fuel. An experimental investigation is performed to study flame appearance, flame stability, Soot free length fraction (SFLF) and CO emission of LPG diffusion flame. Effects of varying air and fuel velocities are analysed to understand the physical process involved in combustion. SFLF is measured to estimate the reduction of soot. Stability limits of the diffusion flame are characterized by the blowoff velocity. Emission characteristic in terms of CO level is measured at different equivalence ratios. Experimental results show that the air and fuel velocity strongly influences the appearance of LPG diffusion flame. At a constant fuel velocity, blue zone increases and the luminous zone decreases with the increase in air velocity. It is observed that the SFLF increases with increasing air velocity at a constant fuel velocity. It is observed that the blowoff velocity of the diffusion flame increases as fuel velocity increases. Comparison of emission for flame with and without swirl indicates that swirl results in low emission of CO and higher flame stability. Swirler with 45° vanes achieved the lowest CO emission of 30 ppm at Φ = 1.3.


Pharmaceutics ◽  
2021 ◽  
Vol 13 (2) ◽  
pp. 261
Author(s):  
Orlando Donoso-González ◽  
Lucas Lodeiro ◽  
Álvaro E. Aliaga ◽  
Miguel A. Laguna-Bercero ◽  
Soledad Bollo ◽  
...  

Gold nanostars (AuNSs) exhibit modulated plasmon resonance and have a high SERS enhancement factor. However, their low colloidal stability limits their biomedical application as a nanomaterial. Cationic β-cyclodextrin-based polymer (CCD/P) has low cytotoxicity, can load and transport drugs more efficiently than the corresponding monomeric form, and has an appropriate cationic group to stabilize gold nanoparticles. In this work, we functionalized AuNSs with CCD/P to load phenylethylamine (PhEA) and piperine (PIP) and evaluated SERS-based applications of the products. PhEA and PIP were included in the polymer and used to functionalize AuNSs, forming a new AuNS-CCD/P-PhEA-PIP nanosystem. The system was characterized by UV–VIS, IR, and NMR spectroscopy, TGA, SPR, DLS, zeta potential analysis, FE-SEM, and TEM. Additionally, Raman optical activity, SERS analysis and complementary theoretical studies were used for characterization. Minor adjustments increased the colloidal stability of AuNSs. The loading capacity of the CCD/P with PhEA-PIP was 95 ± 7%. The physicochemical parameters of the AuNS-CCD/P-PhEA-PIP system, such as size and Z potential, are suitable for potential biomedical applications Raman and SERS studies were used to monitor PhEA and PIP loading and their preferential orientation upon interaction with the surface of AuNSs. This unique nanomaterial could be used for simultaneous drug loading and SERS-based detection.


Sign in / Sign up

Export Citation Format

Share Document