Flow field in a low-speed axial fan: a DPIV investigation

2000 ◽  
Vol 23 (1-2) ◽  
pp. 11-21 ◽  
Author(s):  
J. Estevadeordal ◽  
S. Gogineni ◽  
W. Copenhaver ◽  
G. Bloch ◽  
M. Brendel
Keyword(s):  
Flow Field ◽  
Axial Fan ◽  
Low Speed

Performance of a Low Speed Axial Fan Under Distortion: An Experimental Investigation

2020 ◽  
Author(s):  
Sumit Tambe ◽  
Ugaitz Bartolomé Oseguera ◽  
Arvind Gangoli Rao
Keyword(s):  
Flow Field ◽  
Symmetry Plane ◽  
Vortex Pair ◽  
Axial Fan ◽  
Low Speed ◽  
Fan Performance ◽  
Fuel Burn ◽  
Flow Phenomena ◽  
Order Of Magnitude ◽  
Distortion Index

Abstract In the pursuit of reducing the fuel burn, future aircraft configurations will feature several types of improved propulsion systems, e.g. embedded engines with boundary layer ingestion, high-bypass ratio engines with short intakes, etc. Depending on the design and phase of flight, the engine fan will encounter inflow distortion of varying strength, and fan performance will be adversely affected. Therefore, investigation of the flow phenomena causing performance losses in fan and distortion interaction is important. This experimental study shows the effect of varying distortion index on four aspects of fan performance: distortion topology, upstream redistribution, performance curve, and flow unsteadiness. A low speed fan is tested under 60° circumferential distortion of varying strength, generated using distortion screens. The flow field in the upstream redistribution region is measured using PIV (planar and stereo). The fan performance is obtained using total pressure measurements. The noise spectra measured by a microphone are used to quantify the unsteadiness in the flow field. The distortion index (DC60) varies linearly with the grid porosity at constant wall thickness and aspect ratio of the grid cells. However, the distortion topology is significantly different as a stream-wise vortex pair appears in distorted flow at higher DC60. The vortices are stronger at higher DC60, but their order of magnitude is much lower than the circulation corresponding to fan itself. The spinner, distortion index and topology significantly affect the upstream redistribution mechanism. The vortex pair redistributes the flow which results in lower asymmetry in the symmetry plane. With increasing distortion, the performance is reduced and the unsteadiness is increased.

Near Field Aeroacoustic Experimental Investigation in Low Speed Axial Fans

2008 ◽  
Author(s):  
Stefano Bianchi ◽  
Alessandro Corsini ◽  
Franco Rispoli ◽  
Anthony G. Sheard
Keyword(s):  
Flow Field ◽  
Incidence Angle ◽  
Near Field ◽  
Anechoic Chamber ◽  
Tip Clearance ◽  
Axial Fan ◽  
Present Program ◽  
Turbulent Structures ◽  
Experimental Database ◽  
Low Speed

This paper describes a technique for the investigation of noise sources correlated to tip clearance flows in a low-speed axial fan. A detailed experimental acoustic study is carried out examining the chord-wise evolution of a rotor flow field in the proximity of the blade tip in a low-solidity impeller. The experiment is performed by keeping the rotor “frozen” inside an anechoic chamber. The Mach number, Reynolds number, and blade incidence angle are set in the static frame of reference, reproducing the flow field in the rotating frame. The ‘frozen’ fan rotor is mounted in an anechoic chamber. The near-field pressure perturbations are measured using a chord-traversed microphone. Near-field pressure data is then compared with theoretical predictions, experimental data, and numerical simulations. In this way the validity of the developed experimental scheme is assessed. The purpose of the present program of work is to identify the change in near-field noise as a result of the chord-wise turbulent structures that are located close to the blade surface at the tip. The objective is to study the evolution of turbulent flow structure paths along the chord, and thus to provide insights into their acoustic significance. The present program of work is facilitated by the existence of a detailed pre-existing experimental database on the fan studied.

scholarly journals Assessment of Steady and Unsteady Full Annulus Simulations Predictivity for a Low-Speed Axial Fan at Load-Controlled Windmill

2018 ◽  
Vol 2018 ◽  
pp. 1-12
Author(s):  
Aurélie Ortolan ◽  
Suk-Kee Courty-Audren ◽  
Nicolas Binder ◽  
Xavier Carbonneau ◽  
Yannick Bousquet ◽  
...  
Keyword(s):  
Numerical Analysis ◽  
Velocity Field ◽  
Detailed Analysis ◽  
Added Value ◽  
Classical Approach ◽  
Axial Fan ◽  
Low Speed ◽  
Unsteady Simulation ◽  
Temporal Periodicity

A steady mixing plane approach is compared with the time-averaged solution of an unsteady full annulus calculation for a conventional fan operating at load-controlled windmill. The objective is to assess the added value of a complete unsteady calculation compared with a more classical approach, especially concerning the effect of the spatial and temporal periodicity release in such an unusual operation as windmill. Experiment with global steady measurements and rotor radial characterizations was conducted. Numerical analysis demonstrates that windmilling global performances obtained with the time-averaged solution of the unsteady simulation are not far different from the steady case, especially in the rotor. Some differences arise in the stator, particularly regarding the velocity field. Temporal periodicity release in this row has clearly a significant effect on the flow unsteady response. A detailed analysis highlights that generic patterns of windmilling flows recorded on a steady approach are also reported on the unsteady case.

Influence of Circumferential Inflow Distortion on the Performance of a Low Speed, High Aspect Ratio Contra Rotating Axial Fan

2014 ◽  
Vol 136 (7) ◽  
Author(s):  
Chetan Mistry ◽  
A. M. Pradeep
Keyword(s):  
Aspect Ratio ◽  
High Aspect Ratio ◽  
Rotational Speed ◽  
Total Pressure ◽  
Flow Behavior ◽  
Axial Fan ◽  
Low Speed ◽  
Overall Performance ◽  
Design Speed ◽  
Inflow Conditions

The influence of circumferential inflow distorted on the performance and flow behavior of a high aspect ratio, low speed contra rotating fan is reported in this paper. The total pressure at the inlet is artificially distorted by means of 90 deg mesh sector with a porosity of 0.70. The performance of the contra rotating fan was studied under different speed combinations of the two rotors under clean and distorted inflow conditions. Detailed flow analyses were conducted under design and off-design conditions. In order to understand the effect of distortion and its extent, the distortion sector was rotated circumferentially at intervals of 15 deg to cover the entire annulus. Detailed measurements of the total pressure, velocity components, and flow angles were carried out at the inlet of the first rotor, between the two rotors, and at the exit of the second rotor. The study reveals a few interesting aspects on the effect of inflow distortion on the performance of a contra-rotating stage. For the design speed combination and lower rotational speed of rotor-2, a reduction in the overall operating range with a shift of the peak pressure point towards higher mass flow rate, was observed. It is observed that the effect of inflow distortion at the inlet of rotor-1 gets transferred in the direction of rotor-1 rotation and spreads across the entire annulus. The opposite sense of rotation of rotor-2 causes the distortion effect to get transferred in the direction of rotation of rotor-2 with an associated reduction in the total pressure near the hub. It is observed that a higher rotational speed of the second rotor has a beneficial effect on the overall performance due to the strong suction by generated higher rotational speed of rotor-2.

Performance of a Low Speed Axial Fan Under Distortion: An Experimental Investigation

2021 ◽  
Author(s):  
Sumit Tambe ◽  
Ugaitz Bartolom\xe9 Oseguera ◽  
Arvind Gangoli Rao
Keyword(s):  
Experimental Investigation ◽  
Axial Fan ◽  
Low Speed

Direct aeroacoustics predictions of a low speed axial fan

2010 ◽  
Author(s):  
Franck Perot ◽  
Stephane Moreau ◽  
Min-Suk Kim ◽  
Manuel Henner ◽  
Douglas Neal
Keyword(s):  
Axial Fan ◽  
Low Speed

PIV Maps of Tip Leakage and Secondary Flow Fields on a Low-Speed Turbine Blade Cascade With Moving End Wall

2007 ◽  
Vol 130 (1) ◽  
Author(s):  
P. Palafox ◽  
M. L. G. Oldfield ◽  
J. E. LaGraff ◽  
T. V. Jones
Keyword(s):  
Flow Field ◽  
Secondary Flow ◽  
Field Measurements ◽  
Tip Clearance ◽  
Leakage Flow ◽  
Tip Leakage Flow ◽  
Tip Leakage Vortex ◽  
Low Speed ◽  
Tip Leakage ◽  
End Wall

New, detailed flow field measurements are presented for a very large low-speed cascade representative of a high-pressure turbine rotor blade with turning of 110deg and blade chord of 1.0m. Data were obtained for tip leakage and passage secondary flow at a Reynolds number of 4.0×105, based on exit velocity and blade axial chord. Tip clearance levels ranged from 0% to 1.68% of blade span (0% to 3% of blade chord). Particle image velocimetry was used to obtain flow field maps of several planes parallel to the tip surface within the tip gap, and adjacent passage flow. Vector maps were also obtained for planes normal to the tip surface in the direction of the tip leakage flow. Secondary flow was measured at planes normal to the blade exit angle at locations upstream and downstream of the trailing edge. The interaction between the tip leakage vortex and passage vortex is clearly defined, revealing the dominant effect of the tip leakage flow on the tip end-wall secondary flow. The relative motion between the casing and the blade tip was simulated using a motor-driven moving belt system. A reduction in the magnitude of the undertip flow near the end wall due to the moving wall is observed and the effect on the tip leakage vortex examined.

Sign in / Sign up

Export Citation Format

Share Document