Mercury and photochemistry in the marine boundary layer-modelling studies suggest the in situ production of reactive gas phase mercury

2001 ◽  
Vol 35 (17) ◽  
pp. 3055-3062 ◽  
Author(s):  
Ian M. Hedgecock ◽  
Nicola Pirrone
2009 ◽  
Vol 9 (6) ◽  
pp. 24815-24846 ◽  
Author(s):  
F. Sprovieri ◽  
I. M. Hedgecock ◽  
N. Pirrone

Abstract. Atmospheric mercury concentrations were measured during two oceanographic cruise campaigns covering the Adriatic Sea, the first during the autumn in 2004 and the second in the summer of 2005. The inclement weather during the autumn campaign meant that no clear in-situ production of oxidised gas phase mercury was seen, and that events where high values of HgII(g) and/or Hg associated with particulates (HgP) were observed, were the result of plumes from anthropogenic emission sources. During the summer campaign however, the by now rather familiar diurnal variation of HgII(g) concentration, with maxima around midday, was observed. Again there were events when high HgII(g) and particulates (HgP) concentrations were seen which did not fit with the pattern of daily in-situ HgII(g) production, which were traceable, with the help of back trajectory calculations, to anthropogenic emission sources. All the emission plumes encountered could be traced back to ports, not all of which are associated with major industrial installations. It therefore seems likely in theses cases that the emissions are either due to shipping or to port activities. Box modelling studies of the summer 2005 campaign show that although the in-situ production of HgII(g) occurs in the MBL, the exact chemical mechanism responsible is difficult to determine. However given the high O3 concentrations encountered during this campaign it seems clear that if Hg0 does react with O3, it does not produce gas phase HgII, and the reaction between Hg0 and OH if it occurs, does not contribute appreciably to HgII(g) production.


2001 ◽  
Vol 1 (2) ◽  
pp. 277-335
Author(s):  
J. E. Williams ◽  
F. J. Dentener ◽  
A. R. van den Berg

Abstract. A 1-D marine stratocumulus cloud model has been supplemented with a comprehensive and up-to-date aqueous phase chemical mechanism for the purpose of assessing the impact that the presence of clouds and aerosols has on gas phase HOx, NOx and O3 budgets in the marine boundary layer. The simulations presented here indicate that cloud may act as a heterogeneous source of HONOg via the conversion of HNO4(g) at moderate pH (~4.5). The photolysis of nitrate (NO3-) has also been found to contribute to this simulated increase in HONOg by ~5% and also acts as a minor source of NO2(g). The effect of introducing deliquescent aerosol on the simulated increase of HONOg is negligible. The most important consequences of this elevation in HONOg are that, in the presence of cloud, gas phase concentrations of NOx species increase by a factor of 2, which minimises the simulated decrease in O3(g), and results in a regeneration of OHg. This partly compensates for the removal of OHg by direct phase transfer into the cloud and has important implications regarding the oxidising capacity of the marine boundary layer. The findings presented here also suggest that previous modelling studies, which neglect the heterogeneous HNO4(g) reaction cycle, may have over-estimated the role of clouds as a sink for OHg and O3(g)in unpolluted oceanic regions, by ~10% and ~2%, respectively.


2010 ◽  
Vol 10 (8) ◽  
pp. 3985-3997 ◽  
Author(s):  
F. Sprovieri ◽  
I. M. Hedgecock ◽  
N. Pirrone

Abstract. Atmospheric mercury species concentrations were measured during two oceanographic cruise campaigns covering the Adriatic Sea, the first during the autumn in 2004 and the second in the summer of 2005. The inclement weather during the autumn campaign meant that no clear in-situ production of oxidised gas phase mercury was seen. Events where high values of HgII(g) and/or Hg associated with particulates (HgP) were observed, could be linked to probable anthropogenic emission source areas. During the summer campaign however, the by now rather familiar diurnal variation of HgII(g) concentration, with maxima around midday, was observed. Again there were events when high HgII(g) and particulates (HgP) concentrations were seen which did not fit with the pattern of daily in-situ HgII(g) production. These events were traceable, with the help of back trajectory calculations, to areas of anthropogenic emissions. The back trajectories for all the events during which high Hg species concentrations were encountered showed that the airmass being sampled had passed near port areas in the previous 24 h. Not all these ports are associated with major industrial installations, it is possible therefore (bearing in mind the uncertainty associated with the back trajectory calculations) that either shipping or port activities are a Hg source. Box modelling studies of the summer 2005 campaign show that although the in-situ production of HgII(g) occurs in the MBL, the exact chemical mechanism responsible is difficult to determine. However given the high O3 concentrations encountered during this campaign it seems clear that if Hg0 does react with O3, it does not produce gas phase HgII. Equally, the reaction between Hg0 and OH if it occurs, does not contribute appreciably to HgII(g) production.


ACS Omega ◽  
2021 ◽  
Vol 6 (3) ◽  
pp. 2410-2419
Author(s):  
Junyao Li ◽  
Narcisse T. Tsona ◽  
Shanshan Tang ◽  
Xiuhui Zhang ◽  
Lin Du

2003 ◽  
Vol 3 (3) ◽  
pp. 2963-3050 ◽  
Author(s):  
R. Sander ◽  
W. C. Keene ◽  
A. A. P. Pszenny ◽  
R. Arimoto ◽  
G. P. Ayers ◽  
...  

Abstract. The cycling of inorganic bromine in the marine boundary layer (mbl) has received increased attention in recent years. Bromide, a constituent of sea water, is injected into the atmosphere in association with sea-salt aerosol by breaking waves on the ocean surface. Measurements reveal that supermicrometer sea-salt aerosol is depleted in bromine by about 50% relative to conservative tracers, whereas marine submicrometer aerosol is often enriched in bromine. Model calculations, laboratory studies, and field observations strongly suggest that these depletions reflect the chemical transformation of particulate bromide to reactive inorganic gases that influence the processing of ozone and other important constituents of marine air. However, currently available techniques cannot reliably quantify many \\chem{Br}-containing compounds at ambient concentrations and, consequently, our understanding of inorganic Br cycling over the oceans and its global significance are uncertain. To provide a more coherent framework for future research, we have reviewed measurements in marine aerosol, the gas phase, and in rain. We also summarize sources and sinks, as well as model and laboratory studies of chemical transformations. The focus is on inorganic bromine over the open oceans, excluding the polar regions. The generation of sea-salt aerosol at the ocean surface is the major tropospheric source producing about 6.2 Tg/a of bromide. The transport of  Br from continents (as mineral aerosol, and as products from biomass-burning and fossil-fuel combustion) can be of local importance. Transport of degradation products of long-lived Br-containing compounds from the stratosphere and other sources contribute lesser amounts. Available evidence suggests that, following aerosol acidification, sea-salt bromide reacts to form Br2 and BrCl that volatilize to the gas phase and photolyze in daylight to produce atomic Br and Cl. Subsequent transformations can destroy tropospheric ozone, oxidize dimethylsulfide (DMS) and hydrocarbons in the gas phase and S(IV) in aerosol solutions, and thereby potentially influence climate. The diurnal cycle of gas-phase \\Br and the corresponding particulate Br deficits are correlated. Higher values of Br in the gas phase during daytime are consistent with expectations based on photochemistry. Mechanisms that explain the widely reported accumulation of particulate Br in submicrometer aerosols are not yet understood. We expect that the importance of inorganic Br cycling will vary in the future as a function of both increasing acidification of the atmosphere (through anthropogenic emissions) and climate changes. The latter affects bromine cycling via meteorological factors including global wind fields (and the associated production of sea-salt aerosol), temperature, and relative humidity.


2009 ◽  
Vol 9 (2) ◽  
pp. 5289-5320 ◽  
Author(s):  
D. Lowe ◽  
D. Topping ◽  
G. McFiggans

Abstract. A coupled box model of photochemistry and aerosol microphysics which explicitly accounts for size-dependent chemical properties of the condensed-phase has been developed to simulate the multi-phase chemistry of chlorine, bromine and iodine in the marine boundary layer (MBL). The model contains separate seasalt and non-seasalt modes, each of which may be composed of 1–16 size-sections. By comparison of gaseous and aerosol compositions predicted using different size-resolutions with both fixed and size-dependent aerosol turnover rates, it was found that, for halogen-activation processes, the physical property initialisation of the aerosol-mode has a significant influence on gas-phase chemistry. Failure to adequately represent the appropriate physical properties can lead to substantial errors in gas-phase chemistry. The size-resolution of condensed-phase composition has a less significant influence on gas-phase chemistry.


2019 ◽  
Author(s):  
Huisheng Bian ◽  
Karl Froyd ◽  
Daniel M. Murphy ◽  
Jack Dibb ◽  
Mian Chin ◽  
...  

Abstract. Atmospheric sea salt plays important roles in marine cloud formation and atmospheric chemistry. We performed an integrated analysis of NASA GEOS model simulations run with the GOCART aerosol module, in situ measurements from the PALMS and SAGA instruments obtained during the NASA ATom campaign, and aerosol optical depth (AOD) measurements from AERONET Marine Aerosol Network (MAN) sun photometers and from MODIS satellite observations to better constrain sea salt in the marine atmosphere. ATom measurements and GEOS model simulation both show that sea salt concentrations over the Pacific and Atlantic oceans have a strong vertical gradient, varying up to four orders of magnitude from the marine boundary layer to free troposphere. The modeled residence times suggest that the lifetime of sea salt particles with dry diameter less than 3 μm is largely controlled by wet removal, followed next by turbulent process. During both boreal summer and winter, the GEOS simulated sea salt mass mixing ratios agree with SAGA measurements in the marine boundary layer (MBL) and with PALMS measurements above the MBL. However, comparison of AOD from GEOS with AERONET/MAN and MODIS aerosol retrievals indicated that the model underestimated AOD over the oceans where sea salt dominates. The apparent discrepancy of slightly overpredicted concentration and large underpredicted AOD could not be explained by biases in the model RH, which was found to be comparable to or larger than the in-situ measurements. This conundrum is at least partially explained by the sea salt size distribution; where the GEOS simulation has much less sea salt percentage-wise in the smaller particles than was observed by PALMS. Model sensitivity experiments indicated that the simulated sea salt is better correlated with measurements when the sea salt emission is calculated based on the friction velocity and with consideration of sea surface temperature dependence than that parameterized with the 10-m winds.


2009 ◽  
Vol 9 (9) ◽  
pp. 3075-3093 ◽  
Author(s):  
R. Sommariva ◽  
H. D. Osthoff ◽  
S. S. Brown ◽  
T. S. Bates ◽  
T. Baynard ◽  
...  

Abstract. This paper describes a modelling study of several HOx and NOx species (OH, HO2, organic peroxy radicals, NO3 and N2O5) in the marine boundary layer. A model based upon the Master Chemical Mechanism (MCM) was constrained to observations of chemical and physical parameters made onboard the NOAA ship R/V Brown as part of the New England Air Quality Study (NEAQS) in the summer of 2004. The model was used to calculate [OH] and to determine the composition of the peroxy radical pool. Modelled [NO3] and [N2O5] were compared to in-situ measurements by Cavity Ring-Down Spectroscopy. The comparison showed that the model generally overestimated the measurements by 30–50%, on average. The model results were analyzed with respect to several chemical and physical parameters, including uptake of NO3 and N2O5 on fog droplets and on aerosol, dry deposition of NO3 and N2O5, gas-phase hydrolysis of N2O5 and reactions of NO3 with NMHCs and peroxy radicals. The results suggest that fog, when present, is an important sink for N2O5 via rapid heterogeneous uptake. The comparison between the model and the measurements were consistent with values of the heterogeneous uptake coefficient of N2O5 (γN2O5)>1×10−2, independent of aerosol composition in this marine environment. The analysis of the different loss processes of the nitrate radical showed the important role of the organic peroxy radicals, which accounted for a significant fraction (median: 15%) of NO3 gas-phase removal, particularly in the presence of high concentrations of dimethyl sulphide (DMS).


Sign in / Sign up

Export Citation Format

Share Document