A scaling analysis of transient natural convection in a reservoir model induced by iso-flux heating

2014 ◽  
Vol 764 ◽  
pp. 219-249 ◽  
Author(s):  
Peng Yu ◽  
John C. Patterson ◽  
Chengwang Lei

AbstractThis study presents a detailed scaling analysis quantifying the transient behaviour of natural convection in a reservoir model induced by iso-flux surface heating. It is found that horizontal conduction, which has often been neglected in previous analyses, plays an important role in the development of the flow. Depending on the Rayleigh number, three possible pathways through which the flow develops towards the final steady state are identified. A thermal boundary layer initially grows downwards from the surface. When the thermal boundary layer reaches the sloping bottom and becomes indistinct, a horizontal temperature gradient establishes due to the increasing water depth in the offshore direction. A flow is then driven towards the offshore direction by a buoyancy-induced horizontal pressure gradient, which convects away the heat input from the water surface. On the other hand, the horizontal temperature gradient also conducts heat away. The flow behaviour is determined by the interaction between the horizontal conduction and convection. An interesting flow feature revealed by the present scaling analysis is that the region across which the thermal boundary layer encompasses the full water depth shrinks over time at a certain stage of the flow development. The shrinking process eventually stops when this region coincides with a conduction-dominated subregion. The present scaling results are verified by corresponding numerical simulations.

2012 ◽  
Vol 707 ◽  
pp. 342-368 ◽  
Author(s):  
Yadan Mao ◽  
Chengwang Lei ◽  
John C. Patterson

AbstractThe present investigation is concerned with natural convection in a wedge-shaped domain induced by constant isothermal heating at the water surface. Complementary to the study of daytime heating by solar radiation relevant to nearshore regions of lakes and reservoirs previously reported by the same authors, this study focuses on sensible heating imposed by the atmosphere when it is warmer than the water body. A semi-analytical approach coupled with scaling analysis and numerical simulation is adopted to resolve the problem. Two flow regimes are identified depending on the comparison between the Rayleigh number and the inverse of the square of the bottom slope. For the lower Rayleigh number regime, the entire flow domain eventually becomes isothermal and stationary. For the higher Rayleigh number regime, the flow domain is composed of two distinct subregions, a conductive subregion near the shore and a convective subregion offshore. Within the conductive subregion, the maximum local flow velocity occurs when the thermal boundary layer reaches the local bottom, and the subregion eventually becomes isothermal and stationary. In the offshore convective subregion, a steady state is reached with a distinct thermal boundary layer below the surface and a steady flow velocity. The dividing position between the two subregions and the major time and velocity scales governing the flow development in both subregions are proposed by the scaling analysis and validated by corresponding numerical simulation.


2006 ◽  
Vol 9 (05) ◽  
pp. 530-542 ◽  
Author(s):  
Hadi Nasrabadi ◽  
Kassem Ghorayeb ◽  
Abbas Firoozabadi

Summary We present formulation and numerical solution of two-phase multicomponent diffusion and natural convection in porous media. Thermal diffusion, pressure diffusion, and molecular diffusion are included in the diffusion expression from thermodynamics of irreversible processes. The formulation and the numerical solution are used to perform initialization in a 2D cross section. We use both homogeneous and layered media without and with anisotropy in our calculations. Numerical examples for a binary mixture of C1/C3 and a multicomponent reservoir fluid are presented. Results show a strong effect of natural convection in species distribution. Results also show that there are at least two main rotating cells at steady state: one in the gas cap, and one in the oil column. Introduction Proper initialization is an important aspect of reliable reservoir simulations. The use of the Gibbs segregation condition generally cannot provide reliable initialization in hydrocarbon reservoirs. This is caused, in part, by the effect of thermal diffusion (caused by the geothermal temperature gradient), which cannot be neglected in some cases; thermal diffusion might be the main phenomenon affecting compositional variation in hydrocarbon reservoirs, especially for near-critical gas/condensate reservoirs (Ghorayeb et al. 2003). Generally, temperature increases with increasing burial depth because heat flows from the Earth's interior toward the surface. The temperature profile, or geothermal gradient, is related to the thermal conductivity of a body of rock and the heat flux. Thermal conductivity is not necessarily uniform because it depends on the mineralogical composition of the rock, the porosity, and the presence of water or gas. Therefore, differences in thermal conductivity between adjacent lithologies can result in a horizontal temperature gradient. Horizontal temperature gradients in some offshore fields can be observed because of a constant water temperature (approximately 4°C) in different depths in the seabed floor. The horizontal temperature gradient causes natural convection that might have a significant effect on species distribution (Firoozabadi 1999). The combined effects of diffusion (pressure, thermal, and molecular) and natural convection on compositional variation in multicomponent mixtures in porous media have been investigated for single-phase systems (Riley and Firoozabadi 1998; Ghorayeb and Firoozabadi 2000a).The results from these references show the importance of natural convection, which, in some cases, overrides diffusion and results in a uniform composition. Natural convection also can result in increased horizontal compositional variation, an effect similar to that in a thermogravitational column (Ghorayeb and Firoozabadi 2001; Nasrabadi et al. 2006). The combined effect of convection and diffusion on species separation has been the subject of many experimental studies. Separation in a thermogravitational column with both effects has been measured widely (Schott 1973; Costeseque 1982; El Mataaoui 1986). The thermogravitational column consists of two isothermal vertical plates with different temperatures separated by a narrow space. The space can be either without a porous medium or filled with a porous medium. The thermal diffusion, in a binary mixture, causes one component to segregate to the hot plate and the other to the cold plate. Because of the density gradient caused by temperature and concentration gradients, convection flow occurs and creates a concentration difference between the top and bottom of the column. Analytical and numerical models have been presented to analyze the experimental results (Lorenz and Emery 1959; Jamet et al. 1992; Nasrabadi et al. 2006). The experimental and theoretical studies show that the composition difference between the top and bottom of the column increases with permeability until an optimum permeability is reached. Then, the composition difference declines as permeability increases. The process in a thermogravitational column shows the significance of the convection from a horizontal temperature gradient.


1988 ◽  
Vol 110 (4b) ◽  
pp. 1175-1190 ◽  
Author(s):  
S. Ostrach

There exists a great diversity of buoyancy flows in enclosures that are of interest in science and technology. These buoyancy flows pose new and challenging physical and mathematical problems. Emphasis is given to the complexities of the phenomena, viz., the coupling of the flow and transport and of the boundary-layer and core flows, the interaction between the flow and the driving force, which alters the regions in which the buoyancy acts, and the occurrence of flow sub-regions (cells and layers). The importance of scaling analysis and experiments to determine flow details are discussed and the essentials of scaling techniques are outlined. The implications of these for numerical methods are presented, and the inadequacies of purely numerical solutions are pointed out. Representative works covering a broad range of problems are discussed.


Sign in / Sign up

Export Citation Format

Share Document