Multiple scattering of plane harmonic elastic waves in an infinite solid by an arbitrary configuration of obstacles

1969 ◽  
Vol 66 (2) ◽  
pp. 469-480 ◽  
Author(s):  
P. J. Barratt

AbstractThe multiple scattering of plane harmonic P and S waves in an infinite elastic solid by arbitrary configurations of obstacles is considered. Integral equations relating the far-field multiple scattering amplitudes to the corresponding single scattering functions are obtained and asymptotic solutions are found by an iterative procedure. The scattering of a plane harmonic P wave by two identical rigid spheres is investigated.

Author(s):  
C P Scott ◽  
A J Craven ◽  
C J Gilmore ◽  
A W Bowen

The normal method of background subtraction in quantitative EELS analysis involves fitting an expression of the form I=AE-r to an energy window preceding the edge of interest; E is energy loss, A and r are fitting parameters. The calculated fit is then extrapolated under the edge, allowing the required signal to be extracted. In the case where the characteristic energy loss is small (E < 100eV), the background does not approximate to this simple form. One cause of this is multiple scattering. Even if the effects of multiple scattering are removed by deconvolution, it is not clear that the background from the recovered single scattering distribution follows this simple form, and, in any case, deconvolution can introduce artefacts.The above difficulties are particularly severe in the case of Al-Li alloys, where the Li K edge at ~52eV overlaps the Al L2,3 edge at ~72eV, and sharp plasmon peaks occur at intervals of ~15eV in the low loss region. An alternative background fitting technique, based on the work of Zanchi et al, has been tested on spectra taken from pure Al films, with a view to extending the analysis to Al-Li alloys.


1963 ◽  
Vol 3 (3) ◽  
pp. 325-339 ◽  
Author(s):  
M. Papadopoulos

AbstractA crack is assumed to be the union of two smooth plane surfaces of which various parts may be in contact, while the remainder will not. Such a crack in an isotropic elastic solid is an obstacle to the propagation of plane pulses of the scalar and vector velocity potential so that both reflected and diffracted fields will be set up. In spite of the non-linearity which is present because the state of the crack, and hence the conditions to be applied at the surfaces, is a function of the dependent variables, it is possible to separate incident step-function pulses into either those of a tensile or a compressive nature and the associated scattered field may then be calculated. One new feature which arises is that following the arrival of a tensile field which tends to open up the crack there is necessarily a scattered field which causes the crack to close itself with the velocity of free surface waves.


2013 ◽  
Vol 2013 ◽  
pp. 1-10 ◽  
Author(s):  
Edwin A. Marengo ◽  
Paul Berestesky

The information about the distance of separation between two-point targets that is contained in scattering data is explored in the context of the scalar Helmholtz operator via the Fisher information and associated Cramér-Rao bound (CRB) relevant to unbiased target separation estimation. The CRB results are obtained for the exact multiple scattering model and, for reference, also for the single scattering or Born approximation model applicable to weak scatterers. The effects of the sensing configuration and the scattering parameters in target separation estimation are analyzed. Conditions under which the targets' separation cannot be estimated are discussed for both models. Conditions for multiple scattering to be useful or detrimental to target separation estimation are discussed and illustrated.


2019 ◽  
Vol 68 (10) ◽  
pp. 3733-3739 ◽  
Author(s):  
Chufeng Hu ◽  
Nanjing Li ◽  
Weijun Chen ◽  
Shuxia Guo

2011 ◽  
Vol 31 (3) ◽  
pp. 535-545 ◽  
Author(s):  
Tang-dai Xia ◽  
Miao-miao Sun ◽  
Chen Chen ◽  
Wei-yun Chen ◽  
Xu Ping

Sign in / Sign up

Export Citation Format

Share Document