Single-Layer MoS2 Mechanical Resonant Piezo-Sensors with High Mass Sensitivity

2020 ◽  
Vol 12 (37) ◽  
pp. 41991-41998
Author(s):  
Chengming Jiang ◽  
Qikun Li ◽  
Jijie Huang ◽  
Sheng Bi ◽  
Ruonan Ji ◽  
...  
Author(s):  
Eyal Buks

Nanomechanical resonators having small mass, high resonance frequency and low damping rate are widely employed as mass detectors. We study the performance of such a detector when the resonator is driven into a region of nonlinear oscillations [1]. We predict theoretically that the mass sensitivity of the device in this region may exceed the upper bound imposed by thermo-mechanical noise upon the sensitivity when operating in the linear region. On the other hand, we find that the high mass sensitivity is accompanied by a slow response of the system to a change in the mass. For experimental demonstration we employ homodyne detection (see Fig. 1) for readout of the output signal of an optical displacement detector, which monitors the motion of a doubly clamped nanomechanical resonator made of Pd-Au [2, 3]. The nanomechanical resonator is driven into the region of nonlinear oscillations (see Fig. 2) and the region of bistability is identified (see Fig. 3). As expected theoretically [1] we find that when operating close to the edge of the bistability region the device exhibits strong intermodulation amplification [2] (see Fig. 3). Moreover, strong noise squeezing in the output signal of the homodyne detector is observed in this region [3] (see Fig. 4). An alternative mass detection scheme, in which the resonator is driven into a stochastic resonance, will also be discussed [4].


1988 ◽  
Vol 2 (2) ◽  
pp. 30-34 ◽  
Author(s):  
Russell H. Robins ◽  
Frank W. Crow ◽  
Marvin L. Vestal

2020 ◽  
Vol 116 (12) ◽  
pp. 123502 ◽  
Author(s):  
Jiangpo Zheng ◽  
Jian Zhou ◽  
Pei Zeng ◽  
Yi Liu ◽  
Yiping Shen ◽  
...  

Author(s):  
Sung K. Koh ◽  
Yong Chul Kim

Novel nanomechanical resonators with high mass sensitivities are designed in an optimal manner. We are concerned with a nanomechanical resonator with step changes in cross section and determine its geometry so as to maximize its mass sensitivity. Since the mass sensitivity is proportional to the fundamental frequency, we decide the geometric shape so as to maximize the fundamental frequency. In particular, we design a cantilever resonator with a single discontinuity in its cross sectional area. As the design space of this design problem is decided by the volume of the resonator, we synthesize it for various prescribed volume constraints. The fundamental frequency is estimated based on the Euler-Bernoulli beam theory. We discovered that there is a unique global optimal solution of this design problem that does not depend on the given volume constraints. The mass sensitivity of optimally designed cantilever resonators is 1.9193 times greater than that of conventional uniform beam type resonators that are designed for the same volume. Consequently, the mass sensitivity of a nanomechanical uniform resonator of constant volume can always be enhanced without regard to its global size by modifying its geometry following the optimal design proposed in this paper.


Sensors ◽  
2019 ◽  
Vol 19 (23) ◽  
pp. 5069 ◽  
Author(s):  
Martín-Pérez ◽  
Ramos ◽  
Tamayo ◽  
Calleja

Characterization of micro and nanoparticle mass has become increasingly relevant in a wide range of fields, from materials science to drug development. The real-time analysis of complex mixtures in liquids demands very high mass sensitivity and high throughput. One of the most promising approaches for real-time measurements in liquid, with an excellent mass sensitivity, is the use of suspended microchannel resonators, where a carrier liquid containing the analytes flows through a nanomechanical resonator while tracking its resonance frequency shift. To this end, an extremely sensitive mechanical displacement technique is necessary. Here, we have developed an optomechanical transduction technique to enhance the mechanical displacement sensitivity of optically transparent hollow nanomechanical resonators. The capillaries have been fabricated by using a thermal stretching technique, which allows to accurately control the final dimensions of the device. We have experimentally demonstrated the light coupling into the fused silica capillary walls and how the evanescent light coming out from the silica interferes with the surrounding electromagnetic field distribution, a standing wave sustained by the incident laser and the reflected power from the substrate, modulating the reflectivity. The enhancement of the displacement sensitivity due to this interferometric modulation (two orders of magnitude better than compared with previous accomplishments) has been theoretically predicted and experimentally demonstrated.


Ultrasonics ◽  
2018 ◽  
Vol 84 ◽  
pp. 150-161 ◽  
Author(s):  
Shyam Trivedi ◽  
Harshal B. Nemade

Author(s):  
Xiufeng Yang ◽  
Lidong He ◽  
Bingkang Zhang

This paper investigated the vibration control mechanism of dynamic vibration absorber (DVA) used in pipelines and other chemical equipment. For investigating the broadband characteristics, a pipe-vibration absorber test bench was built and different tests were carried out. The results showed that high mass ratio could widen the frequency bandwidth of effective vibration suppression. A new type of passive ring-shaped DVA with particle damping, employing moving steel particles in single-layer or more-layers boxes was designed, and its vibration suppression capability tested and compared with traditional DVA. The proposed damped DVA could reduce the pipeline double vibration peaks typical of the traditional DVAs. Moreover, results showed that stratifying the box was a useful method to improve the vibration suppression efficiency that increased from 59.5% (single-layer-box case) to 72.5% when two-layers-box were used and to 78.5% with three-layers-box.


Sign in / Sign up

Export Citation Format

Share Document