Dual Fuel Diesel Engine Operation Using H2. Effect on Particulate Emissions

2005 ◽  
Vol 19 (2) ◽  
pp. 418-425 ◽  
Author(s):  
A. Tsolakis ◽  
J. J. Hernandez ◽  
A. Megaritis ◽  
M. Crampton
Keyword(s):  
Diesel Engine ◽  
Dual Fuel ◽  
Particulate Emissions ◽  
Engine Operation ◽  
H2 Effect

Coal–Water Slurry Operation in an EMD Diesel Engine

1988 ◽  
Vol 110 (3) ◽  
pp. 437-443 ◽  
Author(s):  
C. M. Urban ◽  
H. E. Mecredy ◽  
T. W. Ryan ◽  
M. N. Ingalls ◽  
B. T. Jett
Keyword(s):  
Diesel Engine ◽  
Diesel Fuel ◽  
Diesel Engines ◽  
Operating Conditions ◽  
Department Of Energy ◽  
Coal Slurry ◽  
Particulate Emissions ◽  
Development Effort ◽  
Engine Operation ◽  
Coal Burning

The U.S. Department of Energy, Morgantown Energy Technology Center has assumed a leadership role in the development of coal-burning diesel engines. The motivation for this work is obvious when one considers the magnitude of the domestic reserves of coal and the widespread use of diesel engines. The work reported in this paper represents the preliminary engine experiments leading to the development of a coal-burning, medium-speed diesel engine. The basis of this development effort is a two-stroke, 900 rpm, 216-mm (8.5-in.) bore engine manufactured by Electro-Motive Division of General Motors Corporation. The engine, in a minimally modified form, has been operated for several hours on a slurry of 50 percent (by mass) coal in water. Engine operation was achieved in this configuration using a pilot injection of diesel fuel to ignite the main charge of slurry. A standard unit injector, slightly modified by increasing diametric clearances in the injector pump and nozzle tip, was used to inject the slurry. Under the engine operating conditions evaluated, the combustion efficiency of the coal and the NOx emissions were lower than, and the particulate emissions were higher than, corresponding diesel fuel results. These initial results, achieved without optimizing the system on the coal slurry, demonstrate the potential for utilizing coal slurry fuels.

scholarly journals Effect of LPG Content on the Performance and Emissions of A Diesel-LPG Dual-Fuel Engine

1970 ◽  
Vol 46 (2) ◽  
pp. 195-200 ◽  
Author(s):  
GA Rao ◽  
AVS Raju ◽  
CVM Rao ◽  
KG Rajulu
Keyword(s):  
Diesel Engine ◽  
Diesel Fuel ◽  
Agricultural Sector ◽  
Mechanical Efficiency ◽  
Operating Conditions ◽  
Dual Fuel ◽  
Engine Operation ◽  
Engine Load ◽  
Performance And Emission ◽  
Combustion Performance

In the present work, LPG, a by-product of petroleum refining process is used to replace conventional diesel fuel, partially, for improved combustion efficiency and clean burning. A conventional diesel engine was operated on the dual-fuel mode, using LPG as the primary fuel and diesel as the pilot fuel. A four-stroke, single-cylinder diesel engine, most widely used in agricultural sector, has been considered for the purpose of experimentation. The engine was operated at a constant speed of 1500 rpm at a low engine load of 20% and a high engine load of 80%. Under both these operating conditions, combustion, performance and emission characteristics of the engine have been evaluated and compared with that of baseline diesel fuel operation. At 20 % engine load the brake thermal efficiency of the engine has found to decrease with an increase in the LPG content. On the other hand at 80% engine load, it has increased with an increase in the LPG content. Same trend has been observed with regard to the mechanical efficiency. The volumetric efficiency has decreased with an increase in the LPG content at both the loads. The engine operation is more economical on dual-fuel operation at 80% engine load, whereas at 20% engine load, diesel fuel operation is found to be better. With regard to emissions, smoke density and emissions of NOx were found to reduce with an increase in LPG content at both the loads; however, emissions of HC and CO have shown the reverse trend. Key words: Dual-Fuel; LPG; Diesel; Combustion; Performance; Emissions Load. DOI: http://dx.doi.org/10.3329/bjsir.v46i2.8186 Bangladesh J. Sci. Ind. Res. 46(2), 195-200, 2011

Effect of Load Level on the Performance of a Dual Fuel Compression Ignition Engine Operating on Syngas Fuels With Varying H2/CO Content

2011 ◽  
Vol 133 (12) ◽  
Author(s):  
B. B. Sahoo ◽  
U. K. Saha ◽  
N. Sahoo
Keyword(s):  
Diesel Engine ◽  
Thermal Efficiency ◽  
Peak Pressure ◽  
Gaseous Fuel ◽  
Dual Fuel ◽  
Engine Fuel ◽  
Compression Ignition ◽  
Compression Ignition Engine ◽  
Engine Operation ◽  
Brake Thermal Efficiency

Syngas, an environmentally friendly alternative gaseous fuel for internal combustion engine operation, mainly consists of carbon monoxide (CO) and hydrogen (H2). It can substitute fossil diesel oil in a compression ignition diesel engine through dual fuel operation route. In the present investigation, experiments were conducted in a constant speed single cylinder direct injection diesel engine fuelled with syngas-diesel in a dual fuel operation mode. The main contribution of this study is to introduce the new synthetic gaseous fuel (syngas) including the possible use of CO gas, an alternative diesel engine fuel. In this work, four different H2 and CO compositions of syngas were chosen for dual fuel study under different engine loading levels. Keeping the same power output at the corresponding tested loads, the engine performance of dual fuel operations were compared to that of diesel mode for the entire load range. The maximum diesel replacement in the engine was found to be 72.3% for 100% H2 fuel. This amount replacement rate was reduced for the low energetic lower H2 content fuels. The brake thermal efficiency was always found highest (about 21%) in the case of diesel mode operation. However, the 100% H2 syngas showed a comparative performance level with diesel mode at the expense of higher NOx emissions. At 80% engine load, the brake thermal efficiency was found to be 15.7% for 100% CO syngas. This value increased to 16.1%, 18.3% and 19.8% when the 100% CO syngas composition was replaced by H2 contents of 50%, 75% and 100%, respectively. At part loads (i.e., at 20% and 40%), dual fuel mode resulted a poor performance including higher emission levels. In contrast, at higher loads, syngas fuels showed a good competitive performance to diesel mode. At all the tested loads, the NOx emission was observed highest for 100% H2 syngas as compared to other fuel conditions, and a maximum of 240 ppm was found at 100% load. However, when the CO fractions of 25%, 50% and 100%, were substituted to hydrogen fuel, the emission levels got reduced to 175 ppm, 127 ppm, and 114 ppm, respectively. Further, higher CO and HC emission levels were recorded for 25%, 50%, and 100% CO fraction syngas fuels due to their CO content. Ignition delay was found to increase for the dual fuel operation as compared to diesel mode, and also it seemed to be still longer for higher H2 content syngas fuels. The peak pressure and maximum rate of pressure rise were found to decrease for all the cases of dual fuel operation, except for 100% H2 syngas (beyond 60% load). The reduction in peak pressure resulted a rise in the exhaust gas temperature at all loads under dual fuel operation. The present investigation provides some useful experimental data which can be applied to the possible existing engine parameters modifications to produce a competitive syngas dual fuel performance at all the loading operations.

scholarly journals Dual fuel diesel engine operation using LPG

2016 ◽  
Vol 147 ◽  
pp. 012122 ◽  
Author(s):  
I Mirica ◽  
C Pana ◽  
N Negurescu ◽  
Al Cernat ◽  
N C Nutu
Keyword(s):  
Diesel Engine ◽  
Dual Fuel ◽  
Engine Operation

Performance of Partial Flow Sampling Systems Relative to Full Flow CVS for Determination of Particulate Emissions under Steady-State and Transient Diesel Engine Operation

2002 ◽  
Author(s):  
Imad A. Khalek ◽  
Terry L. Ullman ◽  
Shirish A. Shimpi ◽  
Cleophas C. Jackson ◽  
Bennett Dharmawardhana ◽  
...  
Keyword(s):  
Steady State ◽  
Diesel Engine ◽  
Particulate Emissions ◽  
Engine Operation ◽  
Sampling Systems

Effect of H2:CO ratio in syngas on the performance of a dual fuel diesel engine operation

2012 ◽  
Vol 49 ◽  
pp. 139-146 ◽  
Author(s):  
Bibhuti B. Sahoo ◽  
Niranjan Sahoo ◽  
Ujjwal K. Saha
Keyword(s):  
Diesel Engine ◽  
Dual Fuel ◽  
Engine Operation

scholarly journals INVESTIGATION ON THE AIR-GAS CHARACTERISTICS OF AIR-HYDROGEN MIXER DESIGNED FOR DUAL FUEL – ENGINES

2021 ◽  
pp. 66-77
Author(s):  
Alaulddin A. Kazum ◽  
Osam H. Attia ◽  
Ali I. Mosa ◽  
Nor Mariah. Adam
Keyword(s):  
Diesel Engine ◽  
Diesel Engines ◽  
Alternative Fuels ◽  
Dual Fuel ◽  
Engine Operation ◽  
Friction Forces ◽  
Fuel Ratio ◽  
Head Surface ◽  
Wide Range ◽  
Reduce Emissions

High smoke emissions, nitrogen oxide and particulate matter typically produced by diesel engines. Diminishing the exhausted emissions without doing any significant changes in their mechanical configuration is a challenging subject. Thus, adding hydrogen to the traditional fuel would be the best practical choice to ameliorate diesel engines performance and reduce emissions. The air hydrogen mixer is an essential part of converting the diesel engine to work under dual fuel mode (hydrogen-diesel) without any engine modification. In this study, the Air-hydrogen mixer is developed to get a homogenous mixture for hydrogen with air and a stoichiometric air-fuel ratio according to the speed of the engine. The mixer depends on the balance between the force exerted on the head surface of the valve and the opposite forces (the spring and friction forces) and its relation to decrease and increase the fuel inlet. Computational fluid dynamics (CFD) analysis software was utilised to study the hydrogen and airflow behaviour inside the mixer, established by 3.2 L engine. The Air-hydrogen mixer is examined with different speeds of engine1000, 2000, 3000 and 4000 RPM. Results showed air-hydrogen mixture was homogenous in the mixer. Furthermore, the stoichiometric air-fuel ratio was achieved according to the speed of the engine, the developed mixer of the AIR-Hydrogen mixing process provides high mixing homogeneity and engines with stoichiometric air-fuel ratios, which subsequently contributes to the high levels of efficiency in engine operation. In summary, the current study intends to reduce the emissions of gases and offer a wide range of new alternative fuels usage. While the performance of the diesel engine with the new air-hydrogen mixer needs to be tested practically.

An overview on comparative engine performance and emission characteristics of different techniques involved in diesel engine as dual-fuel engine operation

2016 ◽  
Vol 60 ◽  
pp. 306-316 ◽  
Author(s):  
M.J. Abedin ◽  
A. Imran ◽  
H.H. Masjuki ◽  
M.A. Kalam ◽  
S.A. Shahir ◽  
...  
Keyword(s):  
Diesel Engine ◽  
Engine Performance ◽  
Dual Fuel ◽  
Emission Characteristics ◽  
Engine Operation ◽  
Performance And Emission

Exploration of Dual Fuel Diesel Engine Operation with On-Board Fuel Reforming

2017 ◽  
Author(s):  
Jeffrey Hwang ◽  
Xuesong Li ◽  
William Northrop
Keyword(s):  
Diesel Engine ◽  
Dual Fuel ◽  
Fuel Reforming ◽  
Engine Operation
Sign in / Sign up

Export Citation Format

Share Document