Surface Motions and Continental Deformation in the Indian Plate and the India‐Eurasia Collision Zone

2019 ◽  
Vol 124 (11) ◽  
pp. 12141-12170
Author(s):  
Srishti Singh ◽  
Attreyee Ghosh
2021 ◽  
Author(s):  
Abdul Qayyum ◽  
Nalan Lom ◽  
Eldert L Advokaat ◽  
Wim Spakman ◽  
Douwe J.J van Hinsbergen

<p>Much of our understanding of the dynamics of slab break-off and its geological signatures rely on numerical models with a simplified set-up, in which slab break-off follows arrival of a continent in a mantle-stationary trench, the subsequent arrest of plate convergence, and after a delay time of 10 Ma or more, slab break off under the influence of slab pull. However, geological reconstructions show that plate tectonic reality deviates from this setup: post-collisional convergence is common, trenches are generally not stationary relative to mantle, neither before nor after collision, and there are many examples in which the mantle structure below collision zones is characterized by more, or fewer slabs than collisions.</p><p>A key example of the former is the India-Asia collision zone, where the mantle below India hosts two major, despite the common view of a single collision. Kinematic reconstructions reveal that post-collisional convergence amounted 1000s of kms, and was associated with ~1000 km of trench/collision zone advance. Collision between India-Asia collision zone may provide a good case study to determine the result of post-collisional convergence and absolute lower and upper plate motion on mantle structure, and to evaluate to what extent commonly assumed diagnostic geological phenomena of slab break-off apply.</p><p>In addition to the previously identified major India, Himalaya, and Burma slabs, we here map smaller slabs below Afghanistan and the Himalaya that reveal the latest phases of break-off. We show that west-dipping and east-dipping slabs west and east of India, respectively, are dragged northward parallel to the slab, slabs subducting north of India are overturned, and that the shallowest slab fragments are found in the location where the horizontally underthrust Indian lithosphere below Tibet is narrowest. Our results confirm that northward Indian absolute plate motion continued during two episodes of break-off of large (>1000 km wide) slabs, and decoupling of several smaller fragments. These slabs are currently found south of the present day trench locations. The slabs are located even farther south (>1000 km) of the leading edge of the Indian continental lithosphere, currently underthrust below Tibet, from which the slabs detached, signalling ongoing absolute Indian plate motion. We conclude that the multiple slab break-off events in this setting of ongoing plate convergence and trench advance is better explained by shearing off of slabs from the downgoing plate, possibly at a depth corresponding to the base of the Indian continental lithosphere, are not (necessarily) related to the timing of collision. A recently proposed, detailed diachronous record of deformation, uplift, and oroclinal bending in the Himalaya that was liked to slab break-off fits well with our kinematically reconstructed timing of the last slab shear-off, and may provide an important reference geological record for this process. We find that the commonly applied conceptual geological signatures of slab break-off do not apply to the India-Asia collision zone, or to similar settings and histories such as the Arabia-Eurasia collision zone. Our study provides more realistic boundary conditions for future numerical models that aim to assess the dynamics of subduction termination and its geological signatures.</p>


Author(s):  
S. Krishna ◽  
J. Mathew ◽  
R. Majumdar ◽  
P. Roy ◽  
K. Vinod Kumar

The Indian Plate is highly dynamic in nature which in turn makes the Indo-Eurassian collision zone the foci of most of the historic large magnitude earthquakes. Processing of positional information from continuously observing reference stations is one of the space based geodetic techniques used globally and nationally to understand the crustal dynamics. The present study evaluates the dynamic nature of the Indian plate relative to its adjoining plates using the permanent GPS data (2011 to 2013) of 12 International GNSS Service (IGS), which are spread across the Indian, Eurassian, Australian, Somaliyan and African plates. The data processing was carried out using GAMIT/GLOBK software. The results indicate that the average velocity for the two IGS stations on the Indian Plate (Hyderabad and Bangalore) is 54.25 mm/year towards NE in the ITRF-2008 reference frame. The relative velocity of various stations with respect to the Indian plate has been estimated using the Bangalore station and has been found that the stations in the Eurasian plate (Lhasa, Urumqi, Bishkek and Kitab) are moving with velocity ranging from 25 to 33 mm/year in the SE direction resulting in compressional interaction with the Indian plate. This study reveals and confirms to the previous studies that the Indian- Eurassian-Australian Plates are moving at different relative velocities leading to compressional regimes at their margins leading to seismicity in these zones.


Lithosphere ◽  
2021 ◽  
Vol 2021 (1) ◽  
Author(s):  
G. Bhattacharya ◽  
D. M. Robinson ◽  
D. A. Orme

Abstract The India-Asia continental collision zone archives a sedimentary record of the tectonic, geodynamic, and erosional processes that control the thermal history of the Himalayan orogenic interior since the onset of collision in early Paleogene time. In this paper, we present new (U-Th)/He thermochronometric cooling age data from 18 detrital zircons (ZHe) and 19 detrital apatites (AHe) of the early Eocene–early Miocene (ca. 50–23 Ma) continental facies of the Indus Group along the India-Asia collision zone in Ladakh, northwest (NW) India. This along-strike regional-scale low-temperature thermochronometric data set from the Indus basin is the first report of ZHe and AHe cooling ages from western and eastern Ladakh. Thermal modeling of our ZHe and AHe cooling ages indicates a postdepositional Neogene cooling signal in the Indus Group. Cooling initiated at ca. 21–19 Ma, was operational along the ~300 km strike of the collision zone in NW India by ca. 11 Ma, and continued until ca. 3 Ma. The Miocene cooling signal, also present along the India-Asia collision zone in south Tibet, is a continental-scale cooling event likely linked to increased erosional efficiency by the Indus and Yarlung Rivers across an elevated region resulting from the subduction dynamics of the underthrusting Indian plate.


2006 ◽  
Vol 111 (B5) ◽  
pp. n/a-n/a ◽  
Author(s):  
Robert Reilinger ◽  
Simon McClusky ◽  
Philippe Vernant ◽  
Shawn Lawrence ◽  
Semih Ergintav ◽  
...  

2015 ◽  
Vol 5 (1) ◽  
Author(s):  
Di-Cheng Zhu ◽  
Qing Wang ◽  
Zhi-Dan Zhao ◽  
Sun-Lin Chung ◽  
Peter A. Cawood ◽  
...  

Abstract New geochronological and geochemical data on magmatic activity from the India-Asia collision zone enables recognition of a distinct magmatic flare-up event that we ascribe to slab breakoff. This tie-point in the collisional record can be used to back-date to the time of initial impingement of the Indian continent with the Asian margin. Continental arc magmatism in southern Tibet during 80–40 Ma migrated from south to north and then back to south with significant mantle input at 70–43 Ma. A pronounced flare up in magmatic intensity (including ignimbrite and mafic rock) at ca. 52–51 Ma corresponds to a sudden decrease in the India-Asia convergence rate. Geological and geochemical data are consistent with mantle input controlled by slab rollback from ca. 70 Ma and slab breakoff at ca. 53 Ma. We propose that the slowdown of the Indian plate at ca. 51 Ma is largely the consequence of slab breakoff of the subducting Neo-Tethyan oceanic lithosphere, rather than the onset of the India-Asia collision as traditionally interpreted, implying that the initial India-Asia collision commenced earlier, likely at ca. 55 Ma.


2019 ◽  
Vol 481 (1) ◽  
pp. 19-40 ◽  
Author(s):  
Naresh Kumar ◽  
A. Aoudia ◽  
M. Guidarelli ◽  
Vivek G. Babu ◽  
Devajit Hazarika ◽  
...  

AbstractGroup velocities for a period range of 6–60 s for the fundamental mode of the Rayleigh wave passing across the Himalaya–Karakoram–Tibet orogen are used to delineate the structure of the upper lithosphere using the data from 35 broadband seismic stations. 2D tomography velocity maps of group velocities were obtained at grids of 1° separation. Redefined local dispersion curves are inverted non-linearly to obtain 1D velocity models and to construct a 3D image of the S-wave structure down to a depth of 90 km.The Moho discontinuity is correlated with c. 4.0 km s−1 S-wave velocity. The results depict a NE-dipping trend of the Moho depth from c. 40 km beneath the frontal part of the Himalaya to up to c. 70–80 km beneath the collision zone before shallowing substantially to c. 40 km beneath the Tarim Basin. The study also reveals thick deposits of sediments in the Indo-Gangetic plains and the Tarim Basin. A broad low-velocity zone at mid-crustal depth in the western Tibetan Plateau, the Karakoram region and the surface-collision part of the India–Eurasia tectonic plates is interpreted as the effect of partial melting and/or the presence of aqueous fluid. The high velocities in the southern deeper part indicate that the lower crust and uppermost mantle of the Indian Plate are dense and cold.


2021 ◽  
Vol 43 (4) ◽  
pp. 486-498
Author(s):  
Zhao Junmeng

In the previous article**, data were given on the clockwise rotation of the Tarim Basin at a speed of 0.461° per million years around a virtual axis within the structure. Additional fieldwork and new evidence confirm earlier findings about the asymmetry of the Indo-Asian collision zone. These data are additional arguments in favor of the rotation of the Tarim Basin and lithospheric interactions along the Tarim boundaries. Conclusions are based on detailed geological and geophysical data.


Sign in / Sign up

Export Citation Format

Share Document