On how episodic sediment supply influences the evolution of channel morphology, bedload transport and channel stability in an experimental step‐pool channel

Author(s):  
Jiamei Wang ◽  
Marwan A. Hassan ◽  
Matteo Saletti ◽  
Xingyu Chen ◽  
Xudong Fu ◽  
...  
2021 ◽  
Author(s):  
Jiamei Wang ◽  
Marwan A. Hassan ◽  
Matteo Saletti ◽  
Xingyu Chen ◽  
Xudong Fu ◽  
...  

<p>Steep step-pool streams are often coupled to adjacent hillslope, directly receiving episodic sediment supply from mass movement processes such as landslides and debris flows. The response of step-pool channels to the variations in sediment supply remains largely unexplored. We conducted flume experiments with a poorly sorted grain-size distribution in an 8%-steep, 5-m long flume with variable width at the University of British Columbia, to study the effects of episodic sediment supply on channel evolution. After a conditioning phase with no feed, the channel was subjected to sediment pulses of different magnitude and frequency under constant flow discharge. High-resolution data of hydraulics, bedload transport, bed surface grain size, and channel morphology were collected every 10-20 minutes and an additional time at the end of each pulse.</p><p>In response to sediment pulses, we recorded an increase in bedload transport rates, channel aggradation, bed surface fining, and continuous step formation and collapse. In between pulses, bedload rates dropped by several orders of magnitude, net erosion occurred, the bed surface gradually coarsened, and steps became more stable. The small-magnitude high-frequency pulses caused smaller but more frequent spikes in bedload transport, bed surface evolution, and thus step stability. Instead, the large-magnitude low-frequency pulses cause larger changes but provided a longer time for the channel to recover. This suggests that in step-pool channels pulse magnitude is a key control on channel rearrangement, while pulse frequency controls how fast and strong the recovery is.</p><p>The frequency and stability of steps varied as a function of local channel width, showing that channel geometry is a primary control on step formation and stability even under episodic sediment supply conditions. Instead, the effect of sediment pulses is less important because the total number and average survival time of steps were similar among runs with different pulses. The critical Shields stress decreased following sediment pulses, then increased immediately after, and fluctuated until the next pulse. The variations in sediment supply caused cycles in bedload transport rate, surface and bedload texture, thus controlling the variability in the threshold for motion.</p><p>Our results indicate that episodic sediment supply is a primary control on the evolution of step-pool channels, with sediment feed magnitude affecting mostly morphological changes, and sediment feed frequency controlling channel stability.</p>


2016 ◽  
Author(s):  
Z. W. Li ◽  
G. A. Yu ◽  
G. Brierley ◽  
Z. W. Wang

Abstract. The influence of vegetation upon bedload transport and channel morphodynamics is examined along a channel stability gradient ranging from meandering through anabranching through anabranching-braided to fully braided planform conditions along trunk and tributary reaches of the Upper Yellow River in western China. Although the regional geology and climate are relatively consistent across the study area, there is a distinct gradient in the presence and abundance of riparian vegetation for these reaches atop the Qinghai-Tibet Plateau (elevations in the study area range from 2800–3400 m a.s.l.). The hydraulic and geomorphic role of riparian vegetation varies as follows: trees exert the strongest influence in the anabranching reach, the meandering reach flows through meadow vegetation, the anabranching-braided reach has a grass, herb, and sparse shrub cover, and the braided reach has no riparian vegetation. A non-linear relation between vegetative cover on the valley floor and bedload transport capacity is evident, wherein bedload transport capacity is highest for the anabranching reach, followed by the anabranching-braided, braided and meandering reaches respectively. The relationship between the bedload transport capacity of a reach and sediment supply from upstream exerts a significant influence upon channel stability. Bedload transport capacity during the flood season (June–September) in the braid ed reach is much less than the rate of sediment supply, inducing bed aggradation and dynamic channel adjustments. Rates of channel adjustment are less pronounced for the anabranching-braided and anabranching reaches, while the meandering reach is relatively stable (i.e. this is a passive meandering reach).


2016 ◽  
Vol 20 (7) ◽  
pp. 3013-3025 ◽  
Author(s):  
Zhi Wei Li ◽  
Guo An Yu ◽  
Gary Brierley ◽  
Zhao Yin Wang

Abstract. The influence of vegetation upon bedload transport and channel morphodynamics is examined along a channel stability gradient ranging from meandering to anabranching to anabranching–braided to fully braided planform conditions along trunk and tributary reaches of the Upper Yellow River in western China. Although the regional geology and climate are relatively consistent across the study area, there is a distinct gradient in the presence and abundance of riparian vegetation for these reaches atop the Qinghai–Tibet Plateau (elevations in the study area range from 2800 to 3400 m a.s.l.). To date, the influence of vegetative impacts upon channel planform and bedload transport capacity of alluvial reaches of the Upper Yellow River remains unclear because of a lack of hydrological and field data. In this region, the types and pattern of riparian vegetation vary with planform type as follows: trees exert the strongest influence in the anabranching reach, the meandering reach flows through meadow vegetation, the anabranching–braided reach has a grass, herb, and sparse shrub cover, and the braided reach has no riparian vegetation. A non-linear relation between vegetative cover on the valley floor and bedload transport capacity is evident, wherein bedload transport capacity is the highest for the anabranching reach, roughly followed by the anabranching–braided, braided, and meandering reaches. The relationship between the bedload transport capacity of a reach and sediment supply from upstream exerts a significant influence upon channel stability. Bedload transport capacity during the flood season (June–September) in the braided reach is much less than the rate of sediment supply, inducing bed aggradation and dynamic channel adjustments. Rates of channel adjustment are less pronounced for the anabranching–braided and anabranching reaches, while the meandering reach is relatively stable (i.e., this is a passive meandering reach).


2015 ◽  
Vol 3 (1) ◽  
pp. 113-138 ◽  
Author(s):  
L. Zhang ◽  
G. Parker ◽  
C. P. Stark ◽  
T. Inoue ◽  
E. Viparelli ◽  
...  

Abstract. The 1-D saltation–abrasion model of channel bedrock incision of Sklar and Dietrich (2004), in which the erosion rate is buffered by the surface area fraction of bedrock covered by alluvium, was a major advance over models that treat river erosion as a function of bed slope and drainage area. Their model is, however, limited because it calculates bed cover in terms of bedload sediment supply rather than local bedload transport. It implicitly assumes that as sediment supply from upstream changes, the transport rate adjusts instantaneously everywhere downstream to match. This assumption is not valid in general, and thus can give rise to unphysical consequences. Here we present a unified morphodynamic formulation of both channel incision and alluviation that specifically tracks the spatiotemporal variation in both bedload transport and alluvial thickness. It does so by relating the bedrock cover fraction to the ratio of alluvium thickness to bedrock macro-roughness, rather than to the ratio of bedload supply rate to capacity bedload transport. The new formulation (MRSAA) predicts waves of alluviation and rarification, in addition to bedrock erosion. Embedded in it are three physical processes: alluvial diffusion, fast downstream advection of alluvial disturbances, and slow upstream migration of incisional disturbances. Solutions of this formulation over a fixed bed are used to demonstrate the stripping of an initial alluvial cover, the emplacement of alluvial cover over an initially bare bed and the advection–diffusion of a sediment pulse over an alluvial bed. A solution for alluvial–incisional interaction in a channel with a basement undergoing net rock uplift shows how an impulsive increase in sediment supply can quickly and completely bury the bedrock under thick alluvium, thus blocking bedrock erosion. As the river responds to rock uplift or base level fall, the transition point separating an alluvial reach upstream from an alluvial–bedrock reach downstream migrates upstream in the form of a "hidden knickpoint". A tectonically more complex case of rock uplift subject to a localized zone of subsidence (graben) yields a steady-state solution that is not attainable with the original saltation–abrasion model. A solution for the case of bedrock–alluvial coevolution upstream of an alluviated river mouth illustrates how the bedrock surface can be progressively buried not far below the alluvium. Because the model tracks the spatiotemporal variation in both bedload transport and alluvial thickness, it is applicable to the study of the incisional response of a river subject to temporally varying sediment supply. It thus has the potential to capture the response of an alluvial–bedrock river to massive impulsive sediment inputs associated with landslides or debris flows.


2016 ◽  
Author(s):  
Matteo Saletti ◽  
Peter Molnar ◽  
Marwan A. Hassan ◽  
Paolo Burlando

Abstract. A new particle-based reduced-complexity model, CAST, to simulate sediment transport and channel morphology in steep streams is presented. CAST contains phenomenological parameterizations, deterministic or stochastic, of sediment supply, bed load transport, particle entrainment and deposition in a cellular-automaton space with uniform grain size. The model can reproduce a realistic bed morphology and typical fluctuations in transport rates observed in steep channels. Particle hop distances, from entrainment to deposition, are well-fitted by exponential distributions, in agreement with field data. The effect of stochasticity both in the entrainment and in the input rate is shown. A stochastic parameterization of the entrainment is essential to create and maintain a realistic channel morphology, while sediment transport in CAST shreds the input signal and its stochastic variability. A jamming routine has been added to CAST to simulate the grain-grain and grain-bed interactions that lead to particle jamming and step formation in a step-pool stream. The results show that jamming is effective in generating steps in unsteady conditions. Steps are created during high- flow periods and they survive during low flows only in sediment- starved conditions, in agreement with the jammed-state hypothesis of Church and Zimmermann (2007). Reduced-complexity models such as CAST can give new insight into the dynamics of complex phenomena (such as sediment transport and bedform stability) and be useful to test research hypotheses, being an effective complement to fully physically-based models.


2012 ◽  
Vol 39 (10) ◽  
pp. n/a-n/a ◽  
Author(s):  
E. M. Yager ◽  
J. M. Turowski ◽  
D. Rickenmann ◽  
B. W. McArdell

Sign in / Sign up

Export Citation Format

Share Document