Enhanced thermoelectric properties of the n-type Magnéli phase WO2.90: reduced thermal conductivity through microstructure engineering

2014 ◽  
Vol 2 (33) ◽  
pp. 13492-13497 ◽  
Author(s):  
Gregor Kieslich ◽  
Ulrich Burkhardt ◽  
Christina S. Birkel ◽  
Igor Veremchuk ◽  
Jason E. Douglas ◽  
...  
Keyword(s):  
Thermal Conductivity ◽  
Thermoelectric Properties ◽  
Magnéli Phase ◽  
Magneli Phase

The thermoelectric properties of the Magnéli phase WO2.90 were investigated, with special attention to how the performance can be altered by changing its microstructure.

Reduction in the Thermal Conductivity of Thermoelectric Titanium Oxide by Introduction of Planar Defects

2009 ◽  
Vol 1218 ◽  
Author(s):  
Shunta Harada ◽  
Katsushi Tanaka ◽  
Haruyuki Inui
Keyword(s):  
Thermal Conductivity ◽  
Titanium Oxide ◽  
Hot Pressing ◽  
Oxygen Deficiency ◽  
Nominal Composition ◽  
Titanium Oxides ◽  
X Ray Diffraction ◽  
Planar Defects ◽  
Magnéli Phase ◽  
Magneli Phase

AbstractThermoelectric properties of a homologous series of Magnéli phase titanium oxides TinO2n-1 (n = 2, 3..) have been investigated. Dense polycrystalline specimens with nominal composition of TiO2-x (x = 0.10, 0.20) have been prepared by conventional hot-pressing. X-ray diffraction analysis has revealed that prepared specimens are slightly reduced during hot-pressing. Electrical conduction is of n-type for all prepared titanium oxides and electrical resistivity and absolute values of Seebeck coefficient decrease with increasing oxygen deficiency. The carrier concentration of Magnéli phase titanium oxide increases with increasing oxygen deficiency. Lattice thermal conductivity decreases with increasing oxygen deficiency by more than 60% at room temperature and 40% at 773K compared to TiO2, which can be due to the presence of dense planar defects. The largest thermoelectric figure of merit Z, 1.6×10-4 K-1 at 773K, was obtained in TiO1.90 hot pressed specimen.

Modeling the Thermoelectric Properties of Ti5O9 Magnéli Phase Ceramics

2016 ◽  
Vol 45 (11) ◽  
pp. 5526-5532 ◽  
Author(s):  
Sudeep J. Pandey ◽  
Giri Joshi ◽  
Shidong Wang ◽  
Stefano Curtarolo ◽  
Romain M. Gaume
Keyword(s):  
Thermoelectric Properties ◽  
Magnéli Phase ◽  
Magneli Phase

Thermoelectric Properties of PbSr(Se,Te)-Based Low Dimensional Structures

2000 ◽  
Vol 626 ◽  
Author(s):  
Harald Beyer ◽  
Joachim Nurnus ◽  
Harald Böttner ◽  
Armin Lambrecht ◽  
Lothar Schmitt ◽  
...  
Keyword(s):  
Thermal Conductivity ◽  
Thermoelectric Properties ◽  
Power Factor ◽  
Evaluation Method ◽  
Interband Transition ◽  
Multiple Quantum Well ◽  
Calculated Data ◽  
Multiple Quantum ◽  
Ir Transmission ◽  
Low Dimensional

ABSTRACTThermoelectric properties of low dimensional structures based on PbTe/PbSrTe-multiple quantum-well (MQW)-structures with regard to the structural dimensions, doping profiles and levels are presented. Interband transition energies and barrier band-gap are determined from IR-transmission spectra and compared with Kronig-Penney calculations. The influence of the data evaluation method to obtain the 2D power factor will be discussed. The thermoelectrical data of our layers show a more modest enhancement in the power factor σS2 compared with former publications and are in good agreement with calculated data from Broido et al. [5]. The maximum allowed doping level for modulation doped MQW structures is determined. Thermal conductivity measurements show that a ZT enhancement can be achieved by reducing the thermal conductivity due to interface scattering. Additionally promising lead chalcogenide based superlattices for an increased 3D figure of merit are presented.

Structure and Thermoelectric Properties of New Quaternary Tin and Lead Bismuth Selenides, K1+xM4-2xBi7+xSe15 (M = Sn, Pb) and K1+xSn5-xBi11+xSe22

2000 ◽  
Vol 626 ◽  
Author(s):  
Antje Mrotzek ◽  
Kyoung-Shin Choi ◽  
Duck-Young Chung ◽  
Melissa A. Lane ◽  
John R. Ireland ◽  
...  
Keyword(s):  
Thermal Conductivity ◽  
Single Crystal ◽  
Thermoelectric Properties ◽  
Three Dimensional ◽  
Structure Type ◽  
Narrow Gap ◽  
Low Thermal Conductivity ◽  
Seebeck Coefficients ◽  
Metal Atoms ◽  
Anionic Framework

ABSTRACTWe present the structure and thermoelectric properties of the new quaternary selenides K1+xM4–2xBi7+xSe15 (M = Sn, Pb) and K1-xSn5-xBi11+xSe22. The compounds K1+xM4-2xBi7+xSe15 (M= Sn, Pb) crystallize isostructural to A1+xPb4-2xSb7+xSe15 with A = K, Rb, while K1-xSn5-xBi11+xSe22 reveals a new structure type. In both structure types fragments of the Bi2Te3-type and the NaCl-type are connected to a three-dimensional anionic framework with K+ ions filled tunnels. The two structures vary by the size of the NaCl-type rods and are closely related to β-K2Bi8Se13 and K2.5Bi8.5Se14. The thermoelectric properties of K1+xM4-2xBi7+xSe15 (M = Sn, Pb) and K1-xSn5-xBi11+xSe22 were explored on single crystal and ingot samples. These compounds are narrow gap semiconductors and show n-type behavior with moderate Seebeck coefficients. They have very low thermal conductivity due to an extensive disorder of the metal atoms and possible “rattling” K+ ions.

Electrochemical Oxidation of Perfluorooctanesulfonate by Magnéli Phase Ti4O7 Electrode in the Presence of Trichloroethylene

2020 ◽  
Vol 1 (4) ◽  
Author(s):  
Peizeng Yang ◽  
Yaye Wang ◽  
Junhe Lu ◽  
Viktor Tishchenko ◽  
Qingguo Huang ◽  
...  
Keyword(s):  
Electrochemical Oxidation ◽  
Current Density ◽  
First Order ◽  
Degradation Rates ◽  
Oxidation Technology ◽  
Magnéli Phase ◽  
Polyfluoroalkyl Substances ◽  
Titanium Suboxide ◽  
Gas Tight ◽  
Magneli Phase

This study examined the degradation of perfluorooctanesulfonate (PFOS) in electrochemical oxidation (EO) processes in the presence of trichloroethylene (TCE). The EO experiment was performed in a gas-tight reactor using Magnéli phase titanium suboxide (Ti4O7) as the anode. The experimental data demonstrated that 75% of PFOS (2 μM) was degraded at 10 mA/cm2 current density in 30 min without TCE present in the solution, while the presence of 76 μM TCE apparently inhibited the degradation of PFOS, reducing its removal down to 53%. Defluorination ratio suggested that PFOS was significantly mineralized upon EO treatment, and it appeared to be not influenced by the presence of TCE. The respective pseudo-first order rate constants (kobs) of PFOS removal were 0.0471 and 0.0254 min-1 in the absence and presence of TCE. The degradation rates of both PFOS and TCE increased with current density rising from 2.5 to 20 mA/cm2. In the presence of TCE, chloride, chlorate, and perchlorate were formed that accounted for 79.7 %, 5.53%, and 1.51% of the total chlorine at 60 min. This work illustrates the promise of the Magnéli phase Ti4O7 electrode based electrochemical oxidation technology for degrading per- and polyfluoroalkyl substances (PFASs) and co-contaminants in groundwaters.

Influence of multi-sintering on the thermoelectric properties of Bi2Sr2Co2Oy ceramics

2019 ◽  
Vol 34 (02) ◽  
pp. 2050019 ◽  
Author(s):  
Y. Zhang ◽  
M. M. Fan ◽  
C. C. Ruan ◽  
Y. W. Zhang ◽  
X.-J. Li ◽  
...  
Keyword(s):  
Thermal Conductivity ◽  
Thermoelectric Properties ◽  
Figure Of Merit ◽  
Phonon Scattering ◽  
Sintered Sample ◽  
Thermoelectric Figure Of Merit ◽  
Thermoelectric Figure ◽  
The Third ◽  
Ceramic Samples ◽  
Optimum Formula

[Formula: see text] ceramic samples have a structure similar to phonon glass electronic crystals, and their thermoelectric properties can be effectively adjusted through repeated grinding and sintering. The results show that multi-sintering can make their grain refined and increase their grain boundary, which will effectively increase density and phonon scattering. Finally, multi-sintering can reduce the resistivity and thermal conductivity, thus obviously improve thermoelectric figure of merit [Formula: see text] of [Formula: see text]. The optimum [Formula: see text] value of 0.26 is achieved at 923 K by the third sintered sample.

Thermoelectric properties of PEDOT:PSS aerogel secondary-doped in supercritical CO2 atmosphere with low thermal conductivity

Polymer ◽  
2020 ◽  
Vol 206 ◽  
pp. 122912
Author(s):  
Naoya Yanagishima ◽  
Shinji Kanehashi ◽  
Hiromu Saito ◽  
Kenji Ogino ◽  
Takeshi Shimomura
Keyword(s):  
Thermal Conductivity ◽  
Thermoelectric Properties ◽  
Supercritical Co2 ◽  
Low Thermal Conductivity ◽  
Co2 Atmosphere

Effects of Ce filling fraction and Fe content on the thermoelectric properties of Co-rich CeyFexCo4−xSb12

2001 ◽  
Vol 16 (3) ◽  
pp. 837-843 ◽  
Author(s):  
Xinfeng Tang ◽  
Lidong Chen ◽  
Takashi Goto ◽  
Toshio Hirai
Keyword(s):  
Thermal Conductivity ◽  
Thermoelectric Properties ◽  
Figure Of Merit ◽  
Single Phase ◽  
Lattice Thermal Conductivity ◽  
Hole Concentration ◽  
Thermoelectric Figure Of Merit ◽  
Thermoelectric Figure ◽  
Filling Fraction ◽  
Fe Content

Single-phase filled skutterudite compounds, CeyFexCo4−xSb12 (x = 0 to 3.0, y = 0 to 0.74), were synthesized by a melting method. The effects of Fe content and Ce filling fraction on the thermoelectric properties of CeyFexCo4−xSb12 were investigated. The lattice thermal conductivity of Ce-saturated CeyFexCo4−xSb12, y being at the maximum corresponding to x, decreased with increasing Fe content (x) and reached its minimum at about x = 1.5. When x was 1.5, lattice thermal conductivity decreased with increasing Ce filling fraction till y = 0.3 and then began to increase after reaching the minimum at y = 0.3. Hole concentration and electrical conductivity of Cey Fe1.5Co2.5Sb12 decreased with increasing Ce filling fraction. The Seebeck coefficient increased with increasing Ce filling fraction. The greatest dimensionless thermoelectric figure of merit T value of 1.1 was obtained at 750 K for the composition of Ce0.28Fe1.52Co2.48Sb12.

Sign in / Sign up

Export Citation Format

Share Document