Development of an AES based analytical method for the determination of trace metallic impurities in uranium silicide dispersion fuel: from precursors to end products

2020 ◽  
Vol 35 (1) ◽  
pp. 169-177 ◽  
Author(s):  
Arijit Sengupta ◽  
Rajeswari B. ◽  
R. M. Kadam
Keyword(s):  
Analytical Method ◽  
Atomic Emission ◽  
Dispersion Fuel ◽  
End Products ◽  
Metallic Impurities ◽  
Uranium Silicide

An analytical method was developed based on the D.C. arc carrier distillation atomic emission spectrometric (D.C. Arc AES) technique for determination of trace metallic impurities (Al, Ca, Co, Cr, Cu, Fe, Mg, Mn, Mo, Na, Ni, Si, Sn, Ti, V and Zn) in uranium silicide samples.

Colorimetric Determination of Amoxicillin in Pure and some Pharmaceutical Formulations Via Reaction with Potassium Permanganate as Oxidant Reagent

2019 ◽  
Vol 10 (02) ◽  
Author(s):  
Abbas Shebeeb Al-kadumi ◽  
Sahar Rihan Fadhel ◽  
Mohammed Abdullah Ahmed ◽  
Luma Amer Musa
Keyword(s):  
Potassium Permanganate ◽  
Pharmaceutical Preparations ◽  
Pharmaceutical Formulations ◽  
Atomic Emission ◽  
Basic Medium ◽  
Photometric Method ◽  
Colorimetric Determination ◽  
Spectrophotometric Methods ◽  
Label Claim

We proposed two simple, rapid, and convenient spectrophotometric methods are described for the determination of Amoxicillin in bulk and its pharmaceutical preparations. They are based on the measurement of the flame atomic emission of potassium ion (in first method) and colorimetric determination of the green colored solution for manganite ion at 610 nm formed after reaction of Amoxicillin with potassium permanganate as oxidant agent (in the second method) in basic medium. The working conditions of the methods were investigated and optimized. Beer's law plot showed a good correlation in the concentration range of 5-45 μg/ml. The detection limits and relative standared deviations were (2.573, 2.814 μg/ml) (2.137, 2.498) for the flame emission photometric method and (1.844, 2.016 μg/ml) (1.645,1.932) for colorimetric methods for capsules and suspensions respectively. The methods were successfully applied to the determination of Amoxicillin in capsules and suspensions, and the obtained results were in good agreement with the label claim. No interference was observed from the commonly encountered additives and expectancies.

Dc arc emission analysis of rare earth metals and their oxides with sorption preconcentration of impurities

2018 ◽  
Vol 84 (11) ◽  
pp. 9-14
Author(s):  
E. S. Koshel ◽  
V. B. Baranovskaya ◽  
M. S. Doronina
Keyword(s):  
Rare Earth ◽  
Rare Earth Metals ◽  
Analytical Signal ◽  
Graphite Powder ◽  
Atomic Emission ◽  
Standard Samples ◽  
Emission Analysis ◽  
Sorption Preconcentration ◽  
Sample Shape

The analytical capabilities of arc atomic emission determination of As, Bi, Sb, Cu, Te in rare earth metals (REM) and their oxides after preparatory group concentration using S,N-containing heterochain polymer sorbent are studied on a high-resolution spectrometer “Grand- Extra” (“WMC-Optoelectron-ics” company, Russia). Sorption kinetics and dependence of the degree of the impurity extraction on the solution acidity are analyzed to specify conditions of sorption concentration. To optimize the procedure of arc atomic emission determination of As, Bi, Sb, Cu, and Te various schemes of their sorption preconcentration and subsequent processing of the resulted concentrate with the addition of a collector at different stages of the sorption process have been considered. Graphite powder is used as a collector in analysis of rare earth oxides due to universality and relative simplicity of the emission spectrum. Conditions of analysis and parameters of the spectrometer that affect the analytical signal (mass and composition of the sample, shape and size of the electrodes, current intensity and generator operation mode, interelectrode spacing, wavelengths of the analytical lines) are chosen. The evaporation curves of the determinable impurities were studied and the exposure time of As, Bi, Sb, Cu, and Te in the resulted sorption concentrate was determined. Correctness of the obtained results was evaluated using standard samples of the composition and in comparisons between methods. The results of the study are used to develop a method of arc chemical-atomic emission analysis of yttrium, gadolinium, neodymium, europium, scandium and their oxides in a concentration range of n x (10-2 - 10-5) wt.%.

LUMINESCENT DETERMINATION OF SUGAR IN NATURAL HONEY

2020 ◽  
Vol 0 (4) ◽  
pp. 29-32
Author(s):  
B.M. GAREEV ◽  
◽  
A.M. ABDRAKHMANOV ◽  
G.L. SHARIPOV ◽  
◽  
...  
Keyword(s):  
Quantum Dots ◽  
Laboratory Test ◽  
Aqueous Solutions ◽  
Analytical Method ◽  
Sugar Content ◽  
Carbon Quantum Dots ◽  
Photoluminescence Intensity ◽  
Sucrose Content ◽  
Natural Honey

The photoluminescence of carbon quantum dots synthesized from natural honey and mixtures of honey and sugar has been studied. An increase in the sugar content leads to a decrease in the photoluminescence intensity without changing the shape of the luminescence spectrum of these quantum dots aqueous solutions, which is associated with a decrease in the yield of their synthesis in the sugar presence. The discovered effect can be used to detect sugar in honey. When examining five different market samples of flower honey using this method, two of them showed a significant decrease in the photoluminescence intensity. A laboratory test for compliance with GOST 19792-2017 Standard requirements established an excess of the sucrose content in these samples. Luminescent determination of sugar in honey does not require complicated equipment and can be used to develop a new analytical method for determining the sugar content in counterfeit natural honey.

Sign in / Sign up

Export Citation Format

Share Document