Fabrication and characterization of a high-surface area MoS2@WS2 heterojunction for the ultra-sensitive NO2 detection at room temperature

2019 ◽  
Vol 7 (24) ◽  
pp. 14602-14612 ◽  
Author(s):  
Muhammad Ikram ◽  
Lujia Liu ◽  
Yang Liu ◽  
Laifeng Ma ◽  
He Lv ◽  
...  
Keyword(s):  
Surface Area ◽  
Room Temperature ◽  
High Surface ◽  
High Surface Area ◽  
Fabrication And Characterization ◽  
No2 Detection

Hydrothermally prepared vertical multilayer WS2 nanosheets on the surface of few-layer MoS2 for the ultra-sensitive NO2 detection at room temperature.

scholarly journals Preparation and characterization of activated carbons from albizia saman pod

2017 ◽  
Vol 36 (3) ◽  
pp. 44-53
Author(s):  
G. D. Akpen ◽  
M. I. Aho ◽  
N. Baba
Keyword(s):  
Activated Carbon ◽  
Surface Area ◽  
Activated Carbons ◽  
High Surface ◽  
High Surface Area ◽  
Volatile Matter ◽  
Sieve Analysis ◽  
Albizia Saman ◽  
Temperature Surface

Activated carbon was prepared from the pods of Albizia saman for the purpose of converting the waste to wealth. The pods were thoroughly washed with water to remove any dirt, air- dried and cut into sizes of 2-4 cm. The prepared pods were then carbonised in a muffle furnace at temperatures of 4000C, 5000C, 6000C ,7000C and 8000C for 30 minutes. The same procedure was repeated for 60, 90, 120 and 150 minutes respectively. Activation was done using impregnationratios of 1:12, 1:6, 1:4, 1:3, and 1:2 respectively of ZnCl2 to carbonised Albizia saman pods by weight. The activated carbon was then dried in an oven at 1050C before crushing for sieve analysis. The following properties of the produced Albizia saman pod activated carbon (ASPAC) were determined: bulk density, carbon yield, surface area and ash, volatile matter and moisture contents. The highest surface area of 1479.29 m2/g was obtained at the optimum impregnation ratio, carbonization time and temperature of 1:6, 60 minutes and 5000C respectively. It was recommended that activated carbon should be prepared from Albizia saman pod with high potential for adsorption of pollutants given the high surface area obtained.Keywords: Albizia saman pod, activated carbon, carbonization, temperature, surface area

Characterization of high surface area smectite supported cobalt oxides catalysts for hydrodesulfurization by means of TPR, TPS and ESR

1999 ◽  
Vol 179 (1-2) ◽  
pp. 203-216 ◽  
Author(s):  
Eiji Hayashi ◽  
Eiji Iwamatsu ◽  
Mohammad Elias Biswas ◽  
Yuzo Sanada ◽  
Shakeel Ahmed ◽  
...  
Keyword(s):  
Surface Area ◽  
High Surface ◽  
High Surface Area ◽  
Cobalt Oxides

scholarly journals The synthesis of a BiOClxBr1−x nanostructure photocatalyst with high surface area for the enhanced visible-light photocatalytic reduction of Cr(vi)

RSC Advances ◽  
2020 ◽  
Vol 10 (8) ◽  
pp. 4763-4771 ◽  
Author(s):  
Muhammad Bilal Hussain ◽  
Malik Saddam Khan ◽  
Herman Maloko Loussala ◽  
Muhammad Sohail Bashir
Keyword(s):  
Visible Light ◽  
Surface Area ◽  
Room Temperature ◽  
High Surface ◽  
High Surface Area ◽  
Photocatalytic Reduction ◽  
Synthetic Process ◽  
Visible Light Photocatalytic

Cr(vi) reduction is performed by BiOCl0.8Br0.2 composite produced via a facile in situ synthetic process at room temperature while making use of PVP (Mw = 10 000).

Sign in / Sign up

Export Citation Format

Share Document