Boundary probe for measurement of current density and electric-field strength—with special reference to ionised gases

1974 ◽  
Vol 121 (3) ◽  
pp. 213 ◽  
Author(s):  
O.J. Tassicker
1971 ◽  
Vol 43 ◽  
pp. 417-421
Author(s):  
A. B. Severny

It is observed that the change of the net magnetic flux associated with flares can exceed 1017 Mx/s, which corresponds according to Maxwell's equation to the e.m.f. ∼ 109 V which is specific for the high energy protons generated in flares. It is shown that this value of e.m.f. can hardly be compensated by e.m.f. of inductance which should appear due to the actually measured motions in a flare generating active region. The values of electric field strength thus found, together with measured values of electric current density (from rotH), leads to an electric conductivity which is 103 times smaller than usually adopted.


2001 ◽  
Vol 15 (06n07) ◽  
pp. 1050-1056 ◽  
Author(s):  
K. SHIMADA ◽  
H. NISHIDA ◽  
T. FUJITA

We made an experimental investigation of the steady characteristics of torque, current density, and response time of ERF on rotational flow of the disk and the concentric cylinder. We used smectite particles suspension ERF and D.C. electric field. We compared the steady shearstress, current density, and the rise and settling time of the concentric cylinder and with those of the rotating disk. Then we clarified the differences. At a larger electric field strength, the shear stress, yield stress, and apparent viscosity to a constant shear rate in the case of the rotating disk are larger than they are in the case of the rotating concentric cylinder. However, at a larger electric field strength, the current density to a constant shear rate in the case of the rotating disk is smaller than it is in the case of the rotating concentric cylinder. Rise time of torque in the case of the rotating disk is faster than it is in the case of the rotating concentric cylinder. However, rise time of current density in the case of the rotating disk is slower than it is in the case of the rotating concentric cylinder at a small electric field strength. On the other hand, the difference of settling time of torque and current density between the rotating disk and the rotating concentric cylinder is changed by the electric field strength and shear rate. The settling time of torque in the case of the rotating disk is faster than it is in the case of the rotating concentric cylinder at a large electric field strength and large shear rate. The settling time of current density in the case of the rotating disk is slower than it is in the case of rotating concentric cylinder at a small electric field strength. Based on these results, the rotating disk has an efficiency of obtained torque to given electric power greater than that of the rotating concentric cylinder.


2016 ◽  
Vol 136 (10) ◽  
pp. 1420-1421
Author(s):  
Yusuke Tanaka ◽  
Yuji Nagaoka ◽  
Hyeon-Gu Jeon ◽  
Masaharu Fujii ◽  
Haruo Ihori

2021 ◽  
Vol 87 (2) ◽  
Author(s):  
Swati Baruah ◽  
U. Sarma ◽  
R. Ganesh

Lane formation dynamics in externally driven pair-ion plasma (PIP) particles is studied in the presence of external magnetic field using Langevin dynamics (LD) simulation. The phase diagram obtained distinguishing the no-lane and lane states is systematically determined from a study of various Coulomb coupling parameter values. A peculiar lane formation-disintegration parameter space is identified; lane formation area extended to a wide range of Coulomb coupling parameter values is observed before disappearing to a mixed phase. The different phases are identified by calculating the order parameter. This and the critical parameters are calculated directly from LD simulation. The critical electric field strength value above which the lanes are formed distinctly is obtained, and it is observed that in the presence of the external magnetic field, the PIP system requires a higher value of the electric field strength to enter into the lane formation state than that in the absence of the magnetic field. We further find out the critical value of electric field frequency beyond which the system exhibits a transition back to the disordered state and this critical frequency is found as an increasing function of the electric field strength in the presence of an external magnetic field. The movement of the lanes is also observed in a direction perpendicular to that of the applied electric and magnetic field directions, which reveals the existence of the electric field drift in the system under study. We also use an oblique force field as the external driving force, both in the presence and absence of the external magnetic field. The application of this oblique force changes the orientation of the lane structures for different applied oblique angle values.


Author(s):  
Dhaval Solanki ◽  
Zeynab Rezaee ◽  
Anirban Dutta ◽  
Uttama Lahiri

Abstract Background Investigation of lobule-specific electric field effects of cerebellar transcranial direct current stimulation (ctDCS) on overground gait performance has not been performed, so this study aimed to investigate the feasibility of two lobule-specific bilateral ctDCS montages to facilitate overground walking in chronic stroke. Methods Ten chronic post-stroke male subjects participated in this repeated-measure single-blind crossover study, where we evaluated the single-session effects of two bilateral ctDCS montages that applied 2 mA via 3.14 cm2 disc electrodes for 15 min targeting (a) dentate nuclei (also, anterior and posterior lobes), and (b) lower-limb representations (lobules VIIb-IX). A two-sided Wilcoxon rank-sum test was performed at a 5% significance level on the percent normalized change measures in the overground gait performance. Partial least squares regression (PLSR) analysis was performed on the quantitative gait parameters as response variables to the mean lobular electric field strength as the predictors. Clinical assessments were performed with the Ten-Meter walk test (TMWT), Timed Up & Go (TUG), and the Berg Balance Scale based on minimal clinically important differences (MCID). Results The ctDCS montage specific effect was found significant using a two-sided Wilcoxon rank-sum test at a 5% significance level for 'Step Time Affected Leg' (p = 0.0257) and '%Stance Time Unaffected Leg' (p = 0.0376). The changes in the quantitative gait parameters were found to be correlated to the mean electric field strength in the lobules based on PLSR analysis (R2 statistic = 0.6574). Here, the mean electric field strength at the cerebellar lobules, Vermis VIIIb, Ipsi-lesional IX, Vermis IX, Ipsi-lesional X, had the most loading and were positively related to the 'Step Time Affected Leg' and '%Stance Time Unaffected Leg,' and negatively related to the '%Swing Time Unaffected Leg,' '%Single Support Time Affected Leg.' Clinical assessments found similar improvement in the TMWT (MCID: 0.10 m/s), TUG (MCID: 8 s), and BBS score (MCID: 12.5 points) for both the ctDCS montages. Conclusion Our feasibility study found an association between the lobular mean electric field strength and the changes in the quantitative gait parameters following a single ctDCS session in chronic stroke. Both the ctDCS montages improved the clinical outcome measures that should be investigated with a larger sample size for clinical validation. Trial registration: Being retrospectively registered.


2019 ◽  
Vol 58 (SC) ◽  
pp. SCCB09 ◽  
Author(s):  
George M. Christian ◽  
Stefan Schulz ◽  
Simon Hammersley ◽  
Menno J. Kappers ◽  
Martin Frentrup ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document