Advanced Topic: Rain-Gauge Rainfall Data Augmentation and Radar Rainfall Data Analysis

2020 ◽  
Vol 30 (63) ◽  
pp. 923
Author(s):  
Paulo Henrique Souza ◽  
Bruno César dos Santos ◽  
Maurício Sanches Duarte Silva ◽  
Diego Narciso Buarque Pereira ◽  
Adriano Rogério Bruno Tech

The acquisition of climate data is essential for understanding the environment and is fundamental in many human activities. One of the problems is the high cost of this equipment. This paper describes the development of a low-cost rain gauge prototype using the Arduino platform and presents the validation of the records against reference data. Therefore, a period of 5 days of observation was selected. Statistical methods of PEARSON and ANOVA were applied in order to verify the consistency of the prototype rainfall data with those of the USP reference station in Itirapina, SP. The results were satisfactory, and the prototype can be considered reliable since the data analysis showed equivalence with the rain gauge and the reference rain gauge.


2019 ◽  
Vol 14 (1) ◽  
pp. 69-79 ◽  
Author(s):  
Roby Hambali ◽  
Djoko Legono ◽  
Rachmad Jayadi ◽  
Satoru Oishi ◽  
◽  
...  

Rainfall monitoring is important for providing early warning of lahar flow around Mt. Merapi. The X-band multi-parameter radar developed to support these warning systems provides rainfall information with high spatial and temporal resolution. However, this method underestimates the rainfall compared with rain gauge measurements. Herein, we performed conditional radar-rain gauge merging to obtain the optimal rainfall value distribution. By using the cokriging interpolation method, kriged gauge rainfall, and kriged radar rainfall data were obtained, which were then combined with radar rainfall data to yield the adjusted spatial rainfall. Radar-rain gauge conditional merging with cokriging interpolation provided reasonably well-adjusted spatial rainfall pattern.


Author(s):  
David C. Curtis

Successful hydrologic modeling depends heavily on high-quality rainfall data sets. If hydrologists cannot determine what is coming into a watershed, there is little chance that any hydrologic model will accurately estimate what is coming out on a consistent basis. Hydrologists are frequently forced to use rainfall data sets derived from sparse rain gauge networks that poorly resolve critical rainfall features, leading to inadequate model results. Over the past several years, the modernizing National Weather Service, the Federal Aviation Administration, and the Department of Defense have installed a new nationwide network of weather radars, providing a rich suite of real-time meteorological observations. Radar rainfall estimates from the new radars cover vast areas at a spatial and temporal resolution that would be impossibly expensive to match with a conventional rain gauge network. Hydrologists can now literally see between the gauges and view truer representations of the spatial distribution of rainfall than ever before. Results from the analysis of the January 9-10, 1995, storms in Sacramento, California, show that gauge-adjusted radar rainfall estimates help resolve rainfall features that could not have been inferred from rain gauge analysis alone. Accurate estimates of the volume, timing, and distribution of rainfall helped create excellent modeling results. In Waco, Texas, radar rainfall estimates were used to improve the analysis of excess inflow and infiltration into city storm sewers. The radar rainfall analyses enabled modelers to account for inflow/infiltration variations down to the neighborhood level.


2021 ◽  
Author(s):  
Punpim Puttaraksa Mapiam ◽  
Monton Methaprayun ◽  
Thom Bogaard ◽  
Gerrit Schoups ◽  
Marie-Claire Ten Veldhuis

Abstract. Low density of conventional rain gauge networks is often a limiting factor for radar rainfall bias correction. Citizen rain gauges offer a promising opportunity to collect rainfall data at higher spatial density. In this paper hourly radar rainfall bias adjustment was applied using two different rain gauge networks consisting of tipping buckets (measured by Thailand Meteorological Department, TMD) and daily citizen rain gauges in a two-step Kalman Filter approach. Radar reflectivity data of Sattahip radar station and gauge rainfall data from the TMD and citizen rain gauges located in Tubma basin, Thailand were used in the analysis. Daily data from the citizen rain gauge network were downscaled to hourly resolution based on temporal distribution patterns obtained from radar rainfall time series and the TMD gauge network. The radar rainfall bias correction factor was sequentially updated based on TMD and citizen rain gauge data using a Kalman Filter. Results show that an improvement of radar rainfall estimates was achieved by including the downscaled citizen observations compared to bias correction based on the conventional rain gauge network only. These outcomes emphasize the value of citizen rainfall observations for radar bias correction, in particular in regions where conventional rain gauge networks are sparse.


2012 ◽  
Vol 16 (11) ◽  
pp. 4247-4264 ◽  
Author(s):  
E. Harader ◽  
V. Borrell-Estupina ◽  
S. Ricci ◽  
M. Coustau ◽  
O. Thual ◽  
...  

Abstract. The present study explores the application of a data assimilation (DA) procedure to correct the radar rainfall inputs of an event-based, distributed, parsimonious hydrological model. An extended Kalman filter algorithm was built on top of a rainfall-runoff model in order to assimilate discharge observations at the catchment outlet. This work focuses primarily on the uncertainty in the rainfall data and considers this as the principal source of error in the simulated discharges, neglecting simplifications in the hydrological model structure and poor knowledge of catchment physics. The study site is the 114 km2 Lez catchment near Montpellier, France. This catchment is subject to heavy orographic rainfall and characterised by a karstic geology, leading to flash flooding events. The hydrological model uses a derived version of the SCS method, combined with a Lag and Route transfer function. Because the radar rainfall input to the model depends on geographical features and cloud structures, it is particularly uncertain and results in significant errors in the simulated discharges. This study seeks to demonstrate that a simple DA algorithm is capable of rendering radar rainfall suitable for hydrological forecasting. To test this hypothesis, the DA analysis was applied to estimate a constant hyetograph correction to each of 19 flood events. The analysis was carried in two different modes: by assimilating observations at all available time steps, referred to here as reanalysis mode, and by using only observations up to 3 h before the flood peak to mimic an operational environment, referred to as pseudo-forecast mode. In reanalysis mode, the resulting correction of the radar rainfall data was then compared to the mean field bias (MFB), a corrective coefficient determined using rain gauge measurements. It was shown that the radar rainfall corrected using DA leads to improved discharge simulations and Nash-Sutcliffe efficiency criteria compared to the MFB correction. In pseudo-forecast mode, the reduction of the uncertainty in the rainfall data leads to a reduction of the error in the simulated discharge, but uncertainty from the model parameterisation diminishes data assimilation efficiency. While the DA algorithm used is this study is effective in correcting uncertain radar rainfall, model uncertainty remains an important challenge for flood forecasting within the Lez catchment.


Atmosphere ◽  
2018 ◽  
Vol 9 (11) ◽  
pp. 446 ◽  
Author(s):  
Francesca Cecinati ◽  
Antonio Moreno-Ródenas ◽  
Miguel Rico-Ramirez ◽  
Marie-claire ten Veldhuis ◽  
Jeroen Langeveld

In urban hydrological models, rainfall is the main input and one of the main sources of uncertainty. To reach sufficient spatial coverage and resolution, the integration of several rainfall data sources, including rain gauges and weather radars, is often necessary. The uncertainty associated with rain gauge measurements is dependent on rainfall intensity and on the characteristics of the devices. Common spatial interpolation methods do not account for rain gauge uncertainty variability. Kriging for Uncertain Data (KUD) allows the handling of the uncertainty of each rain gauge independently, modelling space- and time-variant errors. The applications of KUD to rain gauge interpolation and radar-gauge rainfall merging are studied and compared. First, the methodology is studied with synthetic experiments, to evaluate its performance varying rain gauge density, accuracy and rainfall field characteristics. Subsequently, the method is applied to a case study in the Dommel catchment, the Netherlands, where high-quality automatic gauges are complemented by lower-quality tipping-bucket gauges and radar composites. The case study and the synthetic experiments show that considering measurement uncertainty in rain gauge interpolation usually improves rainfall estimations, given a sufficient rain gauge density. Considering measurement uncertainty in radar-gauge merging consistently improved the estimates in the tested cases, thanks to the additional spatial information of radar rainfall data but should still be used cautiously for convective events and low-density rain gauge networks.


2006 ◽  
Vol 1 (1) ◽  
Author(s):  
K. Katayama ◽  
K. Kimijima ◽  
O. Yamanaka ◽  
A. Nagaiwa ◽  
Y. Ono

This paper proposes a method of stormwater inflow prediction using radar rainfall data as the input of the prediction model constructed by system identification. The aim of the proposal is to construct a compact system by reducing the dimension of the input data. In this paper, Principal Component Analysis (PCA), which is widely used as a statistical method for data analysis and compression, is applied to pre-processing radar rainfall data. Then we evaluate the proposed method using the radar rainfall data and the inflow data acquired in a certain combined sewer system. This study reveals that a few principal components of radar rainfall data can be appropriate as the input variables to storm water inflow prediction model. Consequently, we have established a procedure for the stormwater prediction method using a few principal components of radar rainfall data.


2021 ◽  
Author(s):  
Graziano Patti ◽  
Sabrina Grassi ◽  
Gabriele Morreale ◽  
Mauro Corrao ◽  
Sebastiano Imposa

AbstractThe occurrence of strong and abrupt rainfall, together with a wrong land use planning and an uncontrolled urban development, can constitute a risk for infrastructure and population. The water flow in the subsoil, under certain conditions, may cause underground cavities formation. This phenomena known as soil piping can evolve and generate the surface collapse. It is clear that such phenomena in densely urbanized areas represent an unpredictable and consistent risk factor, which can interfere with social activities. In this study a multidisciplinary approach aimed to obtain useful information for the mitigation of the risks associated with the occurrence of soil piping phenomena in urban areas has been developed. This approach is aimed at defining the causes of sudden soil subsidence events, as well as the definition of the extension and possible evolution of these instability areas. The information obtained from rainfall data analysis, together with a study of the morphological, geological and hydrogeological characteristics, have allowed us to evaluate the causes that have led to the formation of soil pipes. Furthermore, performance of 3D electrical resistivity surveys in the area affected by the instability have allowed us to estimate their extension in the subsoil and identifying the presence of further areas susceptible to instability.


Sign in / Sign up

Export Citation Format

Share Document