Shrinkage and Creep Caused by Dissolution

Author(s):  
X. Li ◽  
Z. C. Grasley
Keyword(s):  
10.1617/13927 ◽  
2004 ◽  
Vol 37 (267) ◽  
pp. 177-183 ◽  
Author(s):  
J. J. Brooks

2019 ◽  
Vol 9 (20) ◽  
pp. 4322 ◽  
Author(s):  
Lv ◽  
Liu ◽  
Zhu ◽  
Bai ◽  
Qi

The significant difference between recycled aggregate and natural aggregate is the content of the attached mortar layer. With the increase of the replacement rate of recycled aggregate, the shrinkage and creep of recycled aggregate concrete is significantly increased. In this paper, 180-day shrinkage and creep tests of recycled aggregate concrete with different water–cement ratios were designed in order to analyze the effect of the substitution rate and water–cement ratio on shrinkage and creep properties. The results show that the shrinkage strain of recycled aggregate concrete with a substitution rate of 50% and 100% at 180 days is 26% and 48% higher than that of ordinary concrete, respectively, and the growth of group II is 22% and 47%, respectively. When the load was 180 days old, the creep coefficient of recycled aggregate concrete with a substitution rate of 50% and 100% in group I increased by 19.6% and 39.6%, respectively compared with ordinary concrete, and group II increased by 23.6% and 44.3%, respectively. Based on the difference of adhering mortar content, the creeping increase coefficient and shrinkage increase coefficient of the attached mortar were proposed, and a shrinkage and creep model of recycled aggregate concrete was established. When compared with the experimental results, the model calculation results met the accuracy requirements.


Materials ◽  
2020 ◽  
Vol 13 (16) ◽  
pp. 3583 ◽  
Author(s):  
Keila Robalo ◽  
Eliana Soldado ◽  
Hugo Costa ◽  
Luís Carvalho ◽  
Ricardo do Carmo ◽  
...  

The sustainability concerns of concrete construction are focused both on the materials’ eco-efficiency and on the structures’ durability. The present work focuses on the characterization of low cement concrete (LCC), regarding time-dependent and durability properties. LCC studies which explore the influence of the formulation parameters, such as the W/C (water/cement ratio), W/Ceq, (which represents the mass ratio between water and equivalent cement), W/B (water/binder) ratio, and the reference curves, on the aforementioned properties are limited. Thus, several LCC mixtures were formulated considering two dosages of binder powder, 350 and 250 kg/m3, the former with very plastic consistency and the latter with dry consistency, which were combined with a large spectrum of cement replacement rates (up to 70%), through adding fly ash and limestone filler, and with different compactness levels. The main objectives were to study the influence of the formulation parameters on the properties: shrinkage and creep, accelerated carbonation and water absorption, by capillarity, and by immersion. The lifetime of structures produced with the studied LCC was estimated, considering the durability performance, regarding the carbonation effect on the possible corrosion of the steel reinforcement. LCC mixtures with reduced cement dosage and high compactness, despite the high W/C ratios, have low shrinkage and those with higher strength have reduced creep, however depending on W/Ceq ratio. Those mixtures can be formulated and produced presenting good performance regarding carbonation resistance and, consequently, a long lifetime, which is mandatory for a sustainable construction. LCC with 175 kg/m3 of cement dosage is an example with higher lifetime than current concrete with 250 kg/m3 of cement; depending on the XC exposure classes (corrosion induced by carbonation), the amount of cement can be reduced between 37.5% and 42%, since the LCC with 175 kg/m3 of cement allows reducing the concrete cover below the minimum recommended, ensuring simultaneously the required lifetime for current and special structures.


Bauingenieur ◽  
2018 ◽  
Vol 93 (03) ◽  
pp. 95-102 ◽  
Author(s):  
M. Drexel ◽  
Y. Theiner ◽  
G. Hofstetter

Im vorliegenden Beitrag wird ein umfangreiches Versuchsprogramm zum Schwinden und Kriechen unter Druckbeanspruchung eines Betons der Festigkeitsklasse C 30/37 vorgestellt. An versiegelten und unversiegelten zylindrischen Probekörpern wurde die zeitliche Entwicklung (i) der autogenen Schwinddehnungen, (ii) der kombinierten autogenen Schwind- und Trocknungsschwinddehnungen, (iii) der totalen Dehnungen von im Alter von zwei, sieben und 28 Tagen mit 30 % der jeweiligen Druckfestigkeit belasteten Probekörpern und (iv) des Feuchtegehalts der Schwind- und Kriechprobekörper ermittelt. Dadurch konnte der Einfluss der Druckbelastung auf den Feuchtegehalt in Abhängigkeit des Betonalters bei Belastungsbeginn sowie der Einfluss des Feuchteaustausches zwischen Probekörper und trockenerer Umgebungsluft auf das Kriechen (Pickett-Effekt) und Schwinden von Beton untersucht werden. Zusätzlich wurde die Desorptionsisotherme für fünf verschiedene Werte der relativen Luftfeuchtigkeit ermittelt sowie die zeitliche Entwicklung der Druckfestigkeit und des Elastizitätsmoduls jeweils an bis zur Prüfung versiegelten Probekörpern bestimmt.


2012 ◽  
Vol 204-208 ◽  
pp. 2167-2171
Author(s):  
Yu Lan Wang ◽  
Guo Dong Zheng

Finite element analysis and calculation are held on the superstructure of the auxiliary channel bridge at the right branching of Beijiang Bridge for a short condition and the service phase. The theoretical launching force is calculated and amended in construction. The results show that when considering load effects such as the dead loads of box girders, the live loads of decks and the pre-stressed secondary forces, the eccentric stress state will appear on the webs, and the steel stress produced by shrinkage and creep of concrete can not be ignored. So the launching force must be amended during the construction process. These conclusions have a certain reference value on the bridge design and construction.


2007 ◽  
Vol 10 (3) ◽  
pp. 219-228 ◽  
Author(s):  
Allan C. L. Wong ◽  
Paul A. Childs ◽  
William Terry ◽  
Nadarajah Gowripalan ◽  
Gang-Ding Peng

Sign in / Sign up

Export Citation Format

Share Document