Ion induced stress relaxation in dense sputter-deposited DLC thin films

2017 ◽  
Vol 111 (5) ◽  
pp. 051902 ◽  
Author(s):  
Asim Aijaz ◽  
Tomas Kubart
Polymer ◽  
2001 ◽  
Vol 42 (1) ◽  
pp. 319-328 ◽  
Author(s):  
H. Chung ◽  
C. Lee ◽  
H. Han

2009 ◽  
Vol 57 (4) ◽  
pp. 1209-1219 ◽  
Author(s):  
R. Gremaud ◽  
M. Gonzalez-Silveira ◽  
Y. Pivak ◽  
S. de Man ◽  
M. Slaman ◽  
...  

2007 ◽  
Vol 90 (18) ◽  
pp. 181910 ◽  
Author(s):  
B. Abendroth ◽  
H. U. Jäger ◽  
W. Möller ◽  
M. Bilek

2000 ◽  
Vol 76 (4) ◽  
pp. 430-432 ◽  
Author(s):  
C. K. Chiang ◽  
W. E. Wallace ◽  
G. W. Lynn ◽  
D. Feiler ◽  
W. Xia

1996 ◽  
Vol 436 ◽  
Author(s):  
Jonathan Gorrell ◽  
Paul Holloway ◽  
Hal Jerman

AbstractWith the development of microelectromechanical systems there is a need for stronger aluminum thin films that resist stress relaxation. A number of strengthening mechanisms are used extensively for bulk aluminum alloys, but very few have been used to improve the performance of thin films. Pure aluminum, standard microelectronicsmetallization (A1-.04Cu-.017Si), alloy T201 (Al-.046Cu-.006Ag-.004Mn-.003Mg-.003Ti), and alloy 2090 (Al-.026Cu-.021Li-.001Zr) were electron beam evaporated or sputter deposited onto (100) silicon substrates.. Stress versus temperature and stress relaxation were measured in the films. Pure aluminum and AlSiCu alloy films exhibited plastic deformation at low stresses and low temperatures. The T201 and 2090 films exhibited residual elastic stresses at room temperature of 350 MPa and 500 MPa, and did not plastically deform until 240°C at 100 MPa stress, or 270°C at 200 MPa stress, respectively. The T201 film also showed a low stress relaxation rate. We speculate that solid solution strengthening caused the increase in strength of the T201 film, and that age hardening caused the increase in strength of the 2090 film.


Author(s):  
N. Rozhanski ◽  
V. Lifshitz

Thin films of amorphous Ni-Nb alloys are of interest since they can be used as diffusion barriers for integrated circuits on Si. A native SiO2 layer is an effective barrier for Ni diffusion but it deformation during the crystallization of the alloy film lead to the appearence of diffusion fluxes through it and the following formation of silicides. This study concerns the direct evidence of the action of stresses in the process of the crystallization of Ni-Nb films on Si and the structure of forming NiSi2 islands.


Author(s):  
G. Lucadamo ◽  
K. Barmak ◽  
C. Michaelsen

The subject of reactive phase formation in multilayer thin films of varying periodicity has stimulated much research over the past few years. Recent studies have sought to understand the reactions that occur during the annealing of Ni/Al multilayers. Dark field imaging from transmission electron microscopy (TEM) studies in conjunction with in situ x-ray diffraction measurements, and calorimetry experiments (isothermal and constant heating rate), have yielded new insights into the sequence of phases that occur during annealing and the evolution of their microstructure.In this paper we report on reactive phase formation in sputter-deposited lNi:3Al multilayer thin films with a periodicity A (the combined thickness of an aluminum and nickel layer) from 2.5 to 320 nm. A cross-sectional TEM micrograph of an as-deposited film with a periodicity of 10 nm is shown in figure 1. This image shows diffraction contrast from the Ni grains and occasionally from the Al grains in their respective layers.


Sign in / Sign up

Export Citation Format

Share Document