scholarly journals Low-frequency excitation of singlet–triplet transitions. Application to nuclear hyperpolarization

2021 ◽  
Vol 155 (15) ◽  
pp. 154201
Author(s):  
Laurynas Dagys ◽  
Christian Bengs ◽  
Malcolm H. Levitt
2018 ◽  
Vol 28 (07) ◽  
pp. 1850082 ◽  
Author(s):  
Jianhua Yang ◽  
Dawen Huang ◽  
Miguel A. F. Sanjuán ◽  
Houguang Liu

We investigate the vibrational resonance by the numerical simulation and theoretical analysis in an overdamped system with fractional order potential nonlinearities. The nonlinearity is a fractional power function with deflection, in which the response amplitude presents vibrational resonance phenomenon for any value of the fractional exponent. The response amplitude of vibrational resonance at low-frequency is deduced by the method of direct separation of slow and fast motions. The results derived from the theoretical analysis are in good agreement with those of numerical simulation. The response amplitude decreases with the increase of the fractional exponent for weak excitations. The amplitude of the high-frequency excitation can induce the vibrational resonance to achieve the optimal response amplitude. For the overdamped systems, the nonlinearity is the crucial and necessary condition to induce vibrational resonance. The response amplitude in the nonlinear system is usually not larger than that in the corresponding linear system. Hence, the nonlinearity is not a sufficient factor to amplify the response to the low-frequency excitation. Furthermore, the resonance may be also induced by only a single excitation acting on the nonlinear system. The theoretical analysis further proves the correctness of the numerical simulation. The results might be valuable in weak signal processing.


Author(s):  
Amin Khajehdezfuly

In this paper, a two-dimensional numerical model is developed to investigate the effect of rail pad stiffness on the wheel/rail force in a slab track with harmonic irregularity. The model consists of a vehicle, nonlinear Hertz spring, rail, rail pad, concrete slab, resilient layer, concrete base, and subgrade. The rail is simulated using the Timoshenko beam element for considering the effects of high-frequency excitation produced by short-wave irregularity. The results obtained from the model are compared with those available in the literature and from the field to prove the validity of the model. Through a parametric study, the effect of variations in rail pad stiffness, vehicle speed, and harmonic irregularity on the wheel/rail force is investigated. For the slab track without any irregularity, the wheel/rail force is at maximum when the vehicle speed reaches the critical speed. As the rail pad stiffness increases, the critical speed increases. When the amplitude of irregularity is high, wheel jumping phenomenon may occur. In this situation, as the vehicle speed and rail pad stiffness are increased, the dynamic wheel/rail force is increased. In the low-frequency range, the wheel/rail force increases as the rail pad stiffness increases. In the high-frequency range, the wheel/rail force increases as the rail pad stiffness is decreased.


2016 ◽  
Vol 248 ◽  
pp. 204-210 ◽  
Author(s):  
Marian Sikora

The purpose of this study was to develop a model of the dynamic behavior of a hydraulic vehicle double-tube shock absorber. The model accounts for the effects of compressibility, valve stiction, inertia, etc. and can be suitable for use in the analyses on flow-induced pressure fluctuations in the device. The author highlights all major variables to influence the output of the shock absorber, and then proceeds by performing a series of simulations using the developed model. The model is demonstrated to operate well in the large amplitude and low frequency range as well as the small amplitude and high frequency excitation operation regimes. The results are presented in the form of time histories of pressures in each fluid volume of the damper, flow rates through the valves, piston rod acceleration and force. Fast Fourier Transform (FFT) graphs are presented, too, in order to identify major components of the pressure fluctuation phenomena in frequency domain.


Author(s):  
Aiqin Li ◽  
Earl H. Dowell

This paper reports a detailed study of modal reduction based on either linear normal mode(LNM) analysis or proper orthogonal decomposition(POD) for modeling a single α-D glucopyranose monomer as well as a chain of monomers. Also a modal reduction method combining POD and component modal synthesis(CMS) is developed. The accuracy and efficiency of these methods are reported. The focus of this study is to determine to what extent these methods can reduce the time and cost of molecular modeling and simultaneously provide the required accuracy. It has been demonstrated that a linear reduced order model(ROM) is valid for small amplitude excitation and low frequency excitation. It is found that a nonlinear ROM based on POD modes provides a good approximation even for large excitation while the nonlinear ROM using linear eigenmodes as the basis vectors is less effective for modeling molecules with a strong nonlinearity. The ROM based on CMS using POD modes for each component also gives a good approximation. With the reduction in the dimension of the system using these methods the computational time and cost can be reduced significantly.


Author(s):  
Limin Yang ◽  
Arne Nestegård ◽  
Erik Falkenberg

Viscous effects on the low-frequency excitation force on column based platforms are significant in extreme waves. The wave drift force as calculated by a zero-current potential flow radiation/diffraction code becomes negligible for such waves. In the present study, the effect of current and viscous contributions on the slowly varying wave forces are adjusted by a formula developed in the Exwave JIP, see e.g. [1], which is validated against model test results. This paper presents numerical predictions of low frequency horizontal motions of a semi-submersible in combined high waves and current condition. In the simulation model, frequency dependent wave drift forces from radiation/diffraction code are modified by the formula. Static current forces and viscous damping are modelled by the drag term in Morison load formula using relative velocity between current and floater and with force coefficients as recommended by DNVGL-RP-C205 [2]. Low frequency surge responses calculated by the simulation model are compared with model tests for waves only and for combined collinear and noncollinear wave and current conditions.


2005 ◽  
Vol 19 (28n29) ◽  
pp. 1615-1618 ◽  
Author(s):  
H. W. PENG ◽  
D. J. WANG ◽  
C. B. LEE

The experiment was carried out to study the low frequency surface waves due to the horizontal high frequency excitation. The feature of the phenomenon was that the big amplitude axisymmetric surface wave frequency was typically about 1/50 of the excitation frequency. The viscous effect of water was neglected as a first approximation in the earlier papers on this subject. In contrast, we found the viscosity was important to achieve the low frequency water wave with the cooperation of hundreds of "finger" waves. Photographs were taken with stroboscopic lighting and thereafter relevant quantitative results were obtained based on the measurements with Polytec Scanning Vibrometer PSV 400.


Sign in / Sign up

Export Citation Format

Share Document