scholarly journals p-GaN field plate for low leakage current in lateral GaN Schottky barrier diodes

2021 ◽  
Vol 119 (26) ◽  
pp. 263508
Author(s):  
Luca Nela ◽  
Catherine Erine ◽  
Elison Matioli
2021 ◽  
Vol 15 (1) ◽  
pp. 016501
Author(s):  
Fumio Otsuka ◽  
Hironobu Miyamoto ◽  
Akio Takatsuka ◽  
Shinji Kunori ◽  
Kohei Sasaki ◽  
...  

Abstract We fabricated high forward and low leakage current trench MOS-type Schottky barrier diodes (MOSSBDs) in combination with a field plate on a 12 μm thick epitaxial layer grown by halide vapor phase epitaxy on β-Ga2O3 (001) substrate. The MOSSBDs, measuring 1.7 × 1.7 mm2, exhibited a forward current of 2 A (70 A cm−2) at 2 V forward voltage and a leakage current of 5.7 × 10–10 A at −1.2 kV reverse voltage (on/off current ratio of > 109) with an ideality factor of 1.05 and wafer-level specific on-resistance of 17.1 mΩ · cm2.


2018 ◽  
Vol 113 (20) ◽  
pp. 202101 ◽  
Author(s):  
Wenshen Li ◽  
Zongyang Hu ◽  
Kazuki Nomoto ◽  
Zexuan Zhang ◽  
Jui-Yuan Hsu ◽  
...  

2012 ◽  
Vol 725 ◽  
pp. 53-56 ◽  
Author(s):  
Kenichi Ohtsuka ◽  
T. Nakatani ◽  
A. Nagae ◽  
H. Watanabe ◽  
Y. Nakaki ◽  
...  

SiC Schottky barrier diodes were fabricated and measured properties were characterized by device simulation. Most of devices show low leakage current, however, a few devices show leakage current larger than the values estimated from deviation of drift layer parameters. The leakage current component remarkable in lower voltage and saturating at higher voltage is related to Schottky barrier tunneling at macroscopic defects. The component remarkable in higher voltage is considered to be due to microscopic defect related generation current, concerning with non-stoichiometry.


Author(s):  
H. Kozaka ◽  
M. Takata ◽  
S. Murakami ◽  
T. Yatsuo

2006 ◽  
Vol 527-529 ◽  
pp. 927-930 ◽  
Author(s):  
Tomonori Nakamura ◽  
Toshiyuki Miyanagi ◽  
Isaho Kamata ◽  
Hidekazu Tsuchida

We compared the electrical characteristics of 4H-SiC(0001) and (000-1) Schottky barrier diodes (SBDs), and derived the Schottky barrier heights (Hbs) of Ta, W, Mo, and Pd on {0001}. We investigated the annealing temperature dependence of Hbs in Mo and the W Schottky contacts for (0001) and (000-1). The Hbs are increased by annealing, except for the W Schottky contact on (0001). The yields of 0.25 cm2 as-deposited Mo-SBDs were 93.3% for (0001) and 71.1% for (000-1), respectively. We also demonstrated over 1 cm2 (0001) as-deposited Mo-SBD with a low leakage current, an excellent ideality factor, and no excess current, encouraging the enlargement of the active area in the SBD.


Sign in / Sign up

Export Citation Format

Share Document