Synthesis and characterisation of PANI- coated Heliotrope Leaves (PANI@HL) with high clean-up capacity for Orange G dye from aqueous media

Author(s):  
Lahoucine Brini ◽  
Khalihana H’Maida ◽  
Abdelaziz Imgharn ◽  
Abdelghani Hsini ◽  
Yassine Naciri ◽  
...  
Keyword(s):  
2021 ◽  
Author(s):  
ABDELAZIZ IMGHARN ◽  
Nouh Aarab ◽  
Abdelghani Hsini ◽  
Yassine Naciri ◽  
Mohammed Elhoudi ◽  
...  

Abstract The aim of this work is to investigate the adsorption performance of orange G (OG) dye from aqueous solutions employing PANI@sawdust biocomposite enrobed by calcium-alginate biobeads (Alg-PANI@SD). The as-prepared adsorbent was characterized by scanning-electron-microscopy (SEM), X-ray energy dispersive spectroscopy (EDS) and Fourier transforms infrared (FT-IR) spectroscopy, and used to remove Orange G dye from water. batch tests were performed as a function of adsorbent dosage, pH, contact time, interfering ions and initial OG dye concentration. Experimental results show that the kinetic model of pseudo-first-order (PFO) and Freundlich isotherm provided a good fitting of the whole experimental data. The results revealed that the as-prepared tricomposite Alg-PANI@SD, has the potential to be applied as a low-cost adsorbent for the adsorption of OG dye from aqueous media.


2018 ◽  
Vol 104 ◽  
pp. 338-345 ◽  
Author(s):  
Bianca Cojocariu ◽  
Anca Mihaela Mocanu ◽  
Gabriela Nacu ◽  
Laura Bulgariu
Keyword(s):  

2019 ◽  
Vol 233 (3) ◽  
pp. 375-392 ◽  
Author(s):  
Abdul Malik ◽  
Abbas Khan ◽  
Muhammad Humayun

Abstract The rice husk char (RHC) was prepared by keeping a known amount of the rice husk in furnace at 400°C. The product was modified with KOH and labeled as KOH modified rice husk char (KMRHC) which was used as an adsorbent for the removal of toxic dye, Orange G (OG) from aqueous media. Variation in the experimental conditions (agitation time, dye concentration, adsorbent dose, pH and temperature) play significant role in the adsorption process. The maximum adsorption capacity of OG on KMRHC was investigated as 38.8 mg/g at pH=4 using initial dye concentrations of 80 mg/L containing 2 g/L of the adsorbent dose with agitation speed of 250 rpm at 303 K. The % adsorption of dye was inspected as 96%. Thermodynamics studies of the adsorption of OG on KMRHC indicated that the value of ΔG and ΔH were negative which revealed that the adsorption process is exothermic and spontaneous process. The negative value of ΔS suggested that randomness decreases at the interface of adsorbent–adsorbate during the adsorption process. The kinetics study indicated that the experimental data of the adsorption process best fits to pseudo-second order kinetic model. The equilibrium data was tested on Langmuir, Freundlich and Temkin adsorption isotherm models. It was inspected that data follows all the three isotherm models (R2>0.91). However, the values of correlation coefficients (R2) indicated that the data is best fit to the Langmuir isotherm model (R2>0.99) which suggest for chemi-sorption process. The effect of temperature (303–343 K) shows that by varying the temperature the adsorption process is significantly affected. The general trend indicates that adsorption efficiency is higher at lower temperature as compared to higher temperature. This trend also suggests that the adsorption coefficient (K), rate of adsorption, and hence the spontaneity of adsorption process also decreases with raising the temperature.


2017 ◽  
Vol 27 (5) ◽  
pp. 1526-1537 ◽  
Author(s):  
Mostafa Y. Nassar ◽  
Talaat Y. Mohamed ◽  
Ibrahim S. Ahmed ◽  
Naglaa M. Mohamed ◽  
Mai Khatab
Keyword(s):  

RSC Advances ◽  
2021 ◽  
Vol 11 (50) ◽  
pp. 31272-31283
Author(s):  
Abdelghani Hsini ◽  
Yassine Naciri ◽  
Asmae Bouziani ◽  
Nouh Aarab ◽  
Abdelilah Essekri ◽  
...  

In this work, the core–shell PANI@WO3 composite was obtained from the reaction of aniline monomer polymerization with WO3 particles; sodium persulfate was used as an oxidant.


2020 ◽  
Vol 56 (27) ◽  
pp. 3851-3854 ◽  
Author(s):  
Xiaomin Chai ◽  
Hai-Hua Huang ◽  
Huiping Liu ◽  
Zhuofeng Ke ◽  
Wen-Wen Yong ◽  
...  

A Co-based complex displayed the highest photocatalytic performance for CO2 to CO conversion in aqueous media.


2007 ◽  
Vol 20 (3) ◽  
pp. 227-230 ◽  
Author(s):  
Ana Reverdito ◽  
Mariano García ◽  
Alejandra Salerno ◽  
Oscar Locani ◽  
Isabel Perillo
Keyword(s):  

2003 ◽  
Vol 775 ◽  
Author(s):  
Sung-Hwa Oh ◽  
Ju-Myung Song ◽  
Joon-Seop Kim ◽  
Hyang-Rim Oh ◽  
Jeong-A Yu

AbstractSolution behaviors of poly(styrene-co-sodium methacrylate) were studied by fluorescence spectroscopic methods using pyrene as a probe. The mol% of methacrylate was in the range 3.6–9.4. Water and N,N-dimethylforamide(DMF) mixture was used as a solvent (DMF/water = 0.2 mol %). The critical micelle (or aggregation) concentrations of ionomers and the partition coefficients of pyrene were obtained the temperature range 10–80°C. At room temperature, the values of CMCs (or CACs) were in the range 4.7 ×10-6 5.3 ×10-6 g/mL and we could not find any notable effect of the content of ionic repeat units within the experimental errors. Unlike CMCs, as the ion content increased, partitioning of pyrene between the hydrophobic aggregates and an aqueous media decreased from 1.5 ×105 to 9.4 ×104. As the temperature increased from 10 to 80 °C, the values of CMCs increased less than one order of magnitude. While, the partition coefficients of pyrene decreased one order of magnitude and the effect of the ion content became negligible.


Sign in / Sign up

Export Citation Format

Share Document