Ten years outdoor exposure of steel in an urban and coastal tropical atmosphere

Author(s):  
Juan A. Jaén ◽  
Kevin Guzmán ◽  
Josefina Iglesias ◽  
Griselda Caballero Manrique
2018 ◽  
Vol 60 (3) ◽  
pp. 257-264
Author(s):  
Anja Geburtig ◽  
Volker Wachtendorf ◽  
Anita Schmidt ◽  
Thomas Goedecke

Author(s):  
Alessio Facciolà ◽  
Giuseppa Visalli ◽  
Marianna Pruiti Ciarello ◽  
Angela Di Pietro

Plastics are ubiquitous persistent pollutants, forming the most representative material of the Anthropocene. In the environment, they undergo wear and tear (i.e., mechanical fragmentation, and slow photo and thermo-oxidative degradation) forming secondary microplastics (MPs). Further fragmentation of primary and secondary MPs results in nanoplastics (NPs). To assess potential health damage due to human exposure to airborne MPs and NPs, we summarize the evidence collected to date that, however, has almost completely focused on monitoring and the effects of airborne MPs. Only in vivo and in vitro studies have assessed the toxicity of NPs, and a standardized method for their analysis in environmental matrices is still missing. The main sources of indoor and outdoor exposure to these pollutants include synthetic textile fibers, rubber tires, upholstery and household furniture, and landfills. Although both MPs and NPs can reach the alveolar surface, the latter can pass into the bloodstream, overcoming the pulmonary epithelial barrier. Despite the low reactivity, the number of surface area atoms per unit mass is high in MPs and NPs, greatly enhancing the surface area for chemical reactions with bodily fluids and tissue in direct contact. This is proven in polyvinyl chloride (PVC) and flock workers, who are prone to persistent inflammatory stimulation, leading to pulmonary fibrosis or even carcinogenesis.


Author(s):  
G. Caccia ◽  
A. Cappella ◽  
E. Castoldi ◽  
A. Marino ◽  
D. Colloca ◽  
...  
Keyword(s):  

2002 ◽  
Vol 74 (9) ◽  
pp. 65-80 ◽  
Author(s):  
Tinh Nguyen ◽  
Jonathan Martin ◽  
Eric Byrd ◽  
Ned Embree
Keyword(s):  

1999 ◽  
Vol 56 (6) ◽  
pp. 1058-1067 ◽  
Author(s):  
France Béland ◽  
Howard I Browman ◽  
Carolina Alonso Rodriguez ◽  
Jean-François St-Pierre

In the Gulf of St. Lawrence, Canada, solar ultraviolet B radiation (UV-B, 280-320 nm) penetrates a significant percentage of the summer mixed-layer water column: organisms residing in this layer, such as the eggs of Atlantic cod (Gadus morhua), are exposed to UV-B. In outdoor exposure experiments, Atlantic cod eggs were incubated in the presence versus the absence of UV-B and (or) UV-A (320-400 nm). We tested two hypotheses: H1, UV-B induces mortality in Atlantic cod eggs, and H2, UV-A either exacerbates or mitigates any such UV-B-induced mortality. Hypothesis H1 was supported: there was a significant mortality effect on Atlantic cod eggs exposed to UV-B at the surface and at a depth of 50 cm. Hypothesis H2 was not supported: there was no effect of UV-A. These experiments indicate that Atlantic cod eggs present in the first metre of the water column (likely only a small percentage of the total egg population) are susceptible to UV-B. However, UV-B must be viewed as only one among many environmental factors that produce the very high levels of mortality typically observed in the planktonic early life stages of marine fishes.


Author(s):  
Carl Bingham ◽  
Gary Jorgensen ◽  
Amy Wylie

NREL’s Ultra-Accelerated Weathering System (UAWS) selectively reflects and concentrates natural sunlight ultraviolet irradiance below 475 nm onto exposed samples to provide accelerated weathering of materials while keeping samples within realistic temperature limits. This paper will explain the design and implementation of the UAWS which allow it to simulate the effect of years of weathering in weeks of exposure. Exposure chamber design and instrumentation will be discussed for both a prototype UAWS used to test glazing samples as well as a commercial version of UAWS. Candidate polymeric glazing materials have been subjected to accelerated exposure testing at a light intensity level of up to 50 UV suns for an equivalent outdoor exposure in Miami, FL exceeding 15 years. Samples include an impact modified acrylic, fiberglass, and polycarbonate having several thin UV-screening coatings. Concurrent exposure is carried out for identical sample sets at two different temperatures to allow thermal effects to be quantified along with resistance to UV.


Sign in / Sign up

Export Citation Format

Share Document