scholarly journals X-ray photoelectron spectroscopy method for obtaining a CuIn0.95Ga0.05Se2 thin film: development of technology and a phase composition studying

2017 ◽  
Vol 872 ◽  
pp. 012041
Author(s):  
Kh Kh Kalazhokov ◽  
Z Kh Kalazhokov ◽  
T M Gadjiev ◽  
M A Aliev ◽  
A M Ismailov ◽  
...  
Keyword(s):  
Thin Film ◽  
Phase Composition ◽  
Photoelectron Spectroscopy ◽  
Spectroscopy Method ◽  
X Ray ◽  
Film Development

scholarly journals X-ray Photoelectron Spectroscopy Analysis of Chitosan–Graphene Oxide-Based Composite Thin Films for Potential Optical Sensing Applications

Polymers ◽  
2021 ◽  
Vol 13 (3) ◽  
pp. 478
Author(s):  
Wan Mohd Ebtisyam Mustaqim Mohd Daniyal ◽  
Yap Wing Fen ◽  
Silvan Saleviter ◽  
Narong Chanlek ◽  
Hideki Nakajima ◽  
...  
Keyword(s):  
Thin Film ◽  
Thin Films ◽  
Graphene Oxide ◽  
Photoelectron Spectroscopy ◽  
Functional Group ◽  
Optical Sensing ◽  
Composite Thin Films ◽  
Cobalt Ions ◽  
X Ray ◽  
Sensing Applications

In this study, X-ray photoelectron spectroscopy (XPS) was used to study chitosan–graphene oxide (chitosan–GO) incorporated with 4-(2-pyridylazo)resorcinol (PAR) and cadmium sulfide quantum dot (CdS QD) composite thin films for the potential optical sensing of cobalt ions (Co2+). From the XPS results, it was confirmed that carbon, oxygen, and nitrogen elements existed on the PAR–chitosan–GO thin film, while for CdS QD–chitosan–GO, the existence of carbon, oxygen, cadmium, nitrogen, and sulfur were confirmed. Further deconvolution of each element using the Gaussian–Lorentzian curve fitting program revealed the sub-peak component of each element and hence the corresponding functional group was identified. Next, investigation using surface plasmon resonance (SPR) optical sensor proved that both chitosan–GO-based thin films were able to detect Co2+ as low as 0.01 ppm for both composite thin films, while the PAR had the higher binding affinity. The interaction of the Co2+ with the thin films was characterized again using XPS to confirm the functional group involved during the reaction. The XPS results proved that primary amino in the PAR–chitosan–GO thin film contributed more important role for the reaction with Co2+, as in agreement with the SPR results.

Monitoring and characterization of creation of geopolymers prepared from fly ash and metakaolin by X-ray photoelectron spectroscopy method

2014 ◽  
Vol 34 (3) ◽  
pp. 841-849 ◽  
Author(s):  
M. Kanuchova ◽  
L. Kozakova ◽  
M. Drabova ◽  
M. Sisol ◽  
A. Estokova ◽  
...  
Keyword(s):  
Fly Ash ◽  
Photoelectron Spectroscopy ◽  
Spectroscopy Method ◽  
X Ray

Synthesis of CaWO4:(Eu3+,Tb3+) Thin Films by a Two-Step Method at Room Temperature

2013 ◽  
Vol 710 ◽  
pp. 170-173
Author(s):  
Lian Ping Chen ◽  
Yuan Hong Gao
Keyword(s):  
Thin Film ◽  
Thin Films ◽  
Phase Composition ◽  
Room Temperature ◽  
Electrochemical Techniques ◽  
Luminescent Properties ◽  
X Ray Diffraction ◽  
Step Method ◽  
X Ray ◽  
Rare Earth Doped

It is hardly possible to obtain rare earth doped CaWO4thin films directly through electrochemical techniques. A two-step method has been proposed to synthesize CaWO4:(Eu3+,Tb3+) thin films at room temperature. X-ray diffraction, energy dispersive X-ray analysis, spectrophotometer were used to characterize their phase, composition and luminescent properties. Results reveal that (Eu3+,Tb3+)-doped CaWO4films have a tetragonal phase. When the ratio of n (Eu)/n (Tb) in the solution is up to 3:1, CaWO4:(Eu3+,Tb3+) thin film will be enriched with Tb element; on the contrary, when the ratio in the solution is lower than 1:4, CaWO4:(Eu3+,Tb3+) thin film will be enriched with Eu element. Under the excitation of 242 nm, sharp emission peaks at 612, 543, 489 and 589 nm have been observed for CaWO4:(Eu3+,Tb3+) thin films.

scholarly journals Nanostructured, mesoporous Au/TiO2 model catalysts – structure, stability and catalytic properties

2011 ◽  
Vol 2 ◽  
pp. 593-606 ◽  
Author(s):  
Matthias Roos ◽  
Dominique Böcking ◽  
Kwabena Offeh Gyimah ◽  
Gabriela Kucerova ◽  
Joachim Bansmann ◽  
...  
Keyword(s):  
Thin Film ◽  
Photoelectron Spectroscopy ◽  
Catalytic Properties ◽  
Model Catalysts ◽  
Model Systems ◽  
Structure Stability ◽  
Titanium Tetraisopropoxide ◽  
X Ray ◽  
Film Model ◽  
Thin Film Model

Aiming at model systems with close-to-realistic transport properties, we have prepared and studied planar Au/TiO2 thin-film model catalysts consisting of a thin mesoporous TiO2 film of 200–400 nm thickness with Au nanoparticles, with a mean particle size of ~2 nm diameter, homogeneously distributed therein. The systems were prepared by spin-coating of a mesoporous TiO2 film from solutions of ethanolic titanium tetraisopropoxide and Pluronic P123 on planar Si(100) substrates, calcination at 350 °C and subsequent Au loading by a deposition–precipitation procedure, followed by a final calcination step for catalyst activation. The structural and chemical properties of these model systems were characterized by X-ray diffraction (XRD), transmission electron microscopy (TEM), N2 adsorption, inductively coupled plasma ionization spectroscopy (ICP–OES) and X-ray photoelectron spectroscopy (XPS). The catalytic properties were evaluated through the oxidation of CO as a test reaction, and reactivities were measured directly above the film with a scanning mass spectrometer. We can demonstrate that the thin-film model catalysts closely resemble dispersed Au/TiO2 supported catalysts in their characteristic structural and catalytic properties, and hence can be considered as suitable for catalytic model studies. The linear increase of the catalytic activity with film thickness indicates that transport limitations inside the Au/TiO2 film catalyst are negligible, i.e., below the detection limit.

Sign in / Sign up

Export Citation Format

Share Document