scholarly journals Simulated concentration profiling of liquid-phase products in the quaternary solvent system of (carbon dioxide + monoeth-anolamine / diethanolamine + triethanolamine + water)

Author(s):  
A N Soriano ◽  
M Novhanda ◽  
J E B D Cruz ◽  
A P Adornado
1991 ◽  
Vol 24 (7) ◽  
pp. 277-284 ◽  
Author(s):  
E. Gomólka ◽  
B. Gomólka

Whenever possible, neutralization of alkaline wastewater should involve low-cost acid. It is conventional to make use of carbonic acid produced via the reaction of carbon dioxide (contained in flue gases) with water according to the following equation: Carbon dioxide content in the flue gas stream varies from 10% to 15%. The flue gas stream may either be passed to the wastewater contained in the recarbonizers, or. enter the scrubbers (which are continually sprayed with wastewater) from the bottom in oountercurrent. The reactors, in which recarbonation occurs, have the ability to expand the contact surface between gaseous and liquid phase. This can be achieved by gas phase dispersion in the liquid phase (bubbling), by liquid phase dispersion in the gas phase (spraying), or by bubbling and spraying, and mixing. These concurrent operations are carried out during motion of the disk aerator (which is a patent claim). The authors describe the functioning of the disk aerator, the composition of the wastewater produced during wet gasification of carbide, the chemistry of recarbonation and decarbonation, and the concept of applying the disk aerator so as to make the wastewater fit for reuse (after suitable neutralization) as feeding water in acetylene generators.


Molecules ◽  
2021 ◽  
Vol 26 (2) ◽  
pp. 460
Author(s):  
Ratna Surya Alwi ◽  
Chandrasekhar Garlapati ◽  
Kazuhiro Tamura

Solubility of several anthraquinone derivatives in supercritical carbon dioxide was readily available in the literature, but correcting ability of the existing models was poor. Therefore, in this work, two new models have been developed for better correlation based on solid–liquid phase equilibria. The new model has five adjustable parameters correlating the solubility isotherms as a function of temperature. The accuracy of the proposed models was evaluated by correlating 25 binary systems. The proposed models observed provide the best overall correlations. The overall deviation between the experimental and the correlated results was less than 11.46% in averaged absolute relative deviation (AARD). Moreover, exiting solubility models were also evaluated for all the compounds for the comparison purpose.


1967 ◽  
Vol 20 (7) ◽  
pp. 1343
Author(s):  
EL Davids ◽  
TJV Findlay

The liquid-liquid phase diagram for ethylene glycol and triethylamine has been determined. This mixture has a lower consolute temperature of 57.7 � 0.1� at 0.45 � 0.1 mole fraction triethylamine. Both carbon dioxide and water lower the lower consolute temperature. The densities and viscosities of solutions just below the lower consolute temperature do not exhibit any abnormalities.


2016 ◽  
Vol 7 (3) ◽  
pp. 643-647 ◽  
Author(s):  
Qin-Qin Dang ◽  
Xiao-Min Wang ◽  
Yu-Fen Zhan ◽  
Xian-Ming Zhang

An azo-linked porous organic framework (Azo-Trip) in which triptycene is incorporated as linkage, has been constructed via a facile Zn-induced reductive homocoulping reaction. The Azo-Trip exhibits selective carbon dioxide uptake and excellent iodine uptake in vapour and liquid phase.


2014 ◽  
Vol 490-491 ◽  
pp. 311-314
Author(s):  
Zhen Zhong Fan ◽  
An Qi Tong ◽  
Yan Cui ◽  
Jun Feng Yang

The carbon dioxide corrosion on N80 steel was evaluated under the gas phase and the liquid phase. With the test temperature improved, the corrosion rate increases. Under the condition of gas phase, the corrosion peak is 0.2942mm/a when the temperature is 110°C and pressure is 24 MPa. Under the condition of liquid phase, the corrosion peak is 26.5325mm/a when the temperature is 50°C and pressure is 24 MPa. With the increase of CO2 partial pressure, the corrosion rate of N80 steel was falling. Microscopic analysis shows that the corrosion products of CO2 on N80 steel have a large white flocculent compounds and the corrosion surface have a lot of cracks and holes.


2003 ◽  
Vol 56 (5) ◽  
pp. 423 ◽  
Author(s):  
José A. C. Alves ◽  
Amadeu F. Brigas ◽  
Robert A. W. Johnstone

Adsorption isotherms in the liquid phase can be used to determine the relative strengths of adsorption of reactants and solvent at a catalyst surface. Such isotherms can then be used to indicate which type of solvent would be most suitable for a heterogeneously catalyzed reaction in the liquid-phase. Solubility in any chosen solvent is also important. As examples, rates of heterogeneously catalyzed liquid-phase transfer hydrogenolyzes of aryl tetrazolyl ethers (1) have been shown to be highly dependent on both the nature of the solvent and on the solution concentrations of the reactants. The rate of reaction can be varied from zero to a maximum and then back to zero simply by adjusting the solubility of the reductant through changes in the proportion of water in a mixed-solvent system.


Sign in / Sign up

Export Citation Format

Share Document