A Study on an Impact of Tower Surge Impedance Against Lightning Surge Phenomena

Abstract Inlet distortion has influence on the aerodynamic performance of turbomachinery such as compressors, turbines and fans. On turbochargers, bent pipes are installed around the compressor due to the spatial limitations in the engine room of the vehicle. As the result, the compressor is operated with the distorted inflow. In the low flow rate operation, the distorted inflow also affects the flow instability like stall and surge. Especially, the operation range on the low flow rate side is defined based on the flow rate where surge occurs, so it is important to investigate the effect of the distorted inflow on surge. In this study, the effect of the inlet distortion to surge phenomena has been investigated by the experiments with a transonic centrifugal compressor. A bent pipe has been installed at the upstream of the compressor to generate a distorted flow. Experiments have been also conducted under the condition that a straight pipe was installed upstream of the compressor, and unsteady measurements with high response pressure sensors and an I-type hot wire probe have been carried out to each experiments. In addition, Fast Fourier transform (FFT) and Wavelet transform have been applied to the unsteady measurement results obtained from each experiment.

Download Full-text

Granular effect on debris flow rheology

10.5194/egusphere-egu21-14116 ◽

2021 ◽

Author(s):

Taiqiang Yang

Keyword(s):

Shear Rate ◽

Debris Flow ◽

Debris Flows ◽

Shear Thinning ◽

Dynamical Equations ◽

Real Rate ◽

The Real ◽

Jiangjia Gully ◽

Material Sources ◽

Surge Phenomena

Debris flow is characterized by the multi-disperse grain composition and intergranular collision and friction, but the granular effects on rheology are often reduced to the volumetric concentration of solid (Cv), almost ignoring the specific grain size distribution (GSD). In this study, small debris flows occurring in a tributary of Jiangjia Gully were taken as the material sources for rheology experiments. From the real flows we selected slurries with different Cv and maximum grain sizes (Dm) for rheological tests under shearing rate up to 40 (s-1), which is usually the real rate for debris flows in natural conditions. The results indicate that the flows follow the Herschel-Bulkley (HB) rheology, with randomly changing consistency coefficient and relatively constant exponent of 0.45 on average. Only at high shear rate will the flow exhibit Bingham behavior. The HB rheology also reveals shear thinning behavior in surge phenomena observed in the field. Shear-thinning behavior is revealed by the viscosity-shear rate relationship: &#951;a=p&#947;q, with the exponent (thinning index) dependent on shear rate. This greatly concerns the surge phenomena observed in field. Moreover, both the yield stress and the effective viscosity are found to be perfectly related to the scaling GSD parameters in power-law and exponential form, with nearly constant exponents independent of the shear rate(Figure 1). The rheology properties can be calculated from their relationships to GSD parameters (&#956;, Dc), which in turn can be used to infer the HB rheology for the concerned flows and then build the dynamical equations(Figure 2). This implies the presence of some interlock between the fine and coarse grains. Finally the rheology model (general in HB form) can be completely determined by the GSD parameters. This study has for the first time proposed quantitative formulas for rheology incorporating GSD parameters, which is helpful for more accurate dynamic analysis of debris flow.

Download Full-text