Plasmonic excitations in two-dimensional materials: effects of structural symmetry and material anisotropy

2022 ◽  
Author(s):  
Linhui Ding ◽  
Ningning Wang ◽  
Leiming Chen ◽  
Kui Han ◽  
Xiaopeng Shen ◽  
...  

Abstract Plasmonics in two-dimensional materials, an emerging direction of nano-optics, has attracted great attention recently, which exhibits unique properties than that in noble metals. Extending its advanced features by different manipulations is very beneficial for its promotion. In this paper, we study plasmonic excitations in graphene and black phosphorus (BP) nanostructures, where the effects of structural symmetry and material anisotropy are discussed. We show that the two factors are crucial to mode excitations, e.g. the extinction can be dominated by higher order modes rather than dipole resonance. The behavior occurs only in the direction hosting larger resonance frequencies, e.g. armchair (AC) direction of BP and shorter side of graphene rectangles. In BP rectangles along AC direction, the two factors are competing, and thus can be applied cooperatively to tune plasmonic resonance, from dipole to higher order excitations. Besides, the manipulation can also be achieved by designing BP square rings, in which the interaction between outer and inner edges show great impact on mode excitations. Our studies further promote the understanding of plasmonics in two-dimensional materials, and will pave the way for particular plasmonic applications.

2019 ◽  
Vol 205 ◽  
pp. 03015
Author(s):  
K. Allison Thomas

We describe methods using frequency combs and cavities for recording two-dimensional ultrafast spectroscopy signals with high sensitivity. By coupling multiple frequency combs to modes of an optical resonator, cavity-enhanced 2D spectroscopy signals are naturally generated.


Author(s):  
N. Chinone ◽  
Y. Cho ◽  
R. Kosugi ◽  
Y. Tanaka ◽  
S. Harada ◽  
...  

Abstract A new technique for local deep level transient spectroscopy (DLTS) imaging using super-higher-order scanning nonlinear dielectric microscopy is proposed. Using this technique. SiCVSiC structure samples with different post oxidation annealing conditions were measured. We observed that the local DLTS signal decreases with post oxidation annealing (POA), which agrees with the well-known phenomena that POA reduces trap density. Furthermore, obtained local DLTS images had dark and bright areas, which is considered to show the trap distribution at/near SiCVSiC interface.


2018 ◽  
Author(s):  
Penny Perlepe ◽  
Rodolphe Clérac ◽  
Itziar Oyarzabal ◽  
Corine Mathonière

Nanophotonics ◽  
2020 ◽  
Vol 9 (16) ◽  
pp. 4719-4728
Author(s):  
Tao Deng ◽  
Shasha Li ◽  
Yuning Li ◽  
Yang Zhang ◽  
Jingye Sun ◽  
...  

AbstractThe molybdenum disulfide (MoS2)-based photodetectors are facing two challenges: the insensitivity to polarized light and the low photoresponsivity. Herein, three-dimensional (3D) field-effect transistors (FETs) based on monolayer MoS2 were fabricated by applying a self–rolled-up technique. The unique microtubular structure makes 3D MoS2 FETs become polarization sensitive. Moreover, the microtubular structure not only offers a natural resonant microcavity to enhance the optical field inside but also increases the light-MoS2 interaction area, resulting in a higher photoresponsivity. Photoresponsivities as high as 23.8 and 2.9 A/W at 395 and 660 nm, respectively, and a comparable polarization ratio of 1.64 were obtained. The fabrication technique of the 3D MoS2 FET could be transferred to other two-dimensional materials, which is very promising for high-performance polarization-sensitive optical and optoelectronic applications.


Sign in / Sign up

Export Citation Format

Share Document