Collaborative Study on the Analysis of Amyl p-Dimethylaminobenzoate in Suntan Preparations by Chromatography and Ultraviolet Spectrophotometry

1970 ◽  
Vol 53 (1) ◽  
pp. 84-86
Author(s):  
Henry M. Davis

Abstract A method for the determination of amyl p-dimethylaminobenzoate in suntan preparations was submitted for collaborative study. The sunscreen is isolated by partition chromatography and determined by UV spectrophotometry. The data of two collaborators were discarded. Results for the six collaborators show recoveries of 94-101% for samples containing from 10.2 to 23.1 mg sunscreen. The standard deviation varied from 0.18 to 0.72 and the coefficient of variation from 1.84 to 3.6%. It is recommended that the method be adopted as official first action.

1972 ◽  
Vol 55 (1) ◽  
pp. 163-165
Author(s):  
Dalia M Gilvydis

Abstract Dichlorophene is determined in veterinary preparations by a liquid-liquid extraction and UV quantitation. Eight collaborators each analyzed 4 commercial preparations and one synthetic mixture. The average recovery for dichlorophene in the synthetic mixture is 100.3% with a standard deviation of 2.13. The standard deviations obtained for the 5 samples range from 0.13 to 3.69 with coefficients of variation from 0.69 to 3.43. It is recommended that the method be adopted as official first action.


1980 ◽  
Vol 63 (2) ◽  
pp. 178-179
Author(s):  
William P Clinton ◽  
Paul H Manni ◽  
John M Ferry

Abstract A collaborative study was undertaken to define an acceptable routine working method for determination of mass loss in instant coffee. Fourteen laboratories of 24 invited to participate submitted results. The repeatability standard deviation and coefficient of variation were 0.026 and 0.7%, respectively. The reproducibility standard deviation and coefficient of variation were 0.153 and 3.8%, respectively. The method has been adopted as official first action.


1975 ◽  
Vol 58 (5) ◽  
pp. 937-940 ◽  
Author(s):  
E Patricia Sheppard ◽  
Clifton H Wilson

Abstract Separation by partition chromatography and determination by ultraviolet (UV) spectrophotometry have been applied to the analysis of 16 preservative chemicals used in cosmetic products. The method, adapted from the official first action method for hexachlorophene, 35.023–35.027, has broad applicability for the determination of preservatives in cosmetics. Among the chemical classes investigated, phenols, parabens, biphenyls, carbanilides, and salicylanilides are represented. The partition chromatographic technique does not separate 3,4’,5-tribromosalicylanilide (TBS) from hexachlorophene or Irgasan DP 300. However, the UV determination of these compounds was accomplished by utilizing an absorption maximum of TBS which does not coincide with that of the other 2 preservatives. Recoveries averaged 97% for all the compounds studied.


1973 ◽  
Vol 56 (3) ◽  
pp. 674-676
Author(s):  
Joseph H Graham

Abstract A highly specific, sensitive, and rapid method for the determination of dienestrol was studied by 13 collaborators. Dienestrol is separated from excipient matter, degradation products, and other drugs present by column partition chromatography, converted to a substituted indene by acid-induced isomerization, and determined by ultraviolet spectrophotometry. Standard deviations obtained for the 4 samples used in the study, containing approximately 0.1 and 0.5 mg dienestrol, ranged from 1.81 to 3.04. The most critical step in the method is the use of suitable ether. This method has been adopted as official first action.


1982 ◽  
Vol 65 (1) ◽  
pp. 115-118
Author(s):  
James J Karr ◽  
◽  
J B Audino ◽  
A A Carlstrom ◽  
L T Chenery ◽  
...  

Abstract The determination of diazinon insecticide in Knox Out 2FM formulation was studied collaboratively by 18 laboratories. Knox Out 2FM is a flowable microencapsulated insecticide formulation containing 23 wt% active ingredient. Analytical samples are first treated by grinding in a tissue grinder and then extracted in situ with acetonitrile. This preparative step breaks the capsules and allows the active ingredient to dissolve in the solvent. Single determinations on each of 2 closely matched samples were made by flame ionization gas-liquid chromatography. The standard deviation by analysts was 0.18 wt% and the coefficient of variation was 0.76%. The combined laboratory and analyst variation gave a standard deviation of 0.59 wt% and a coefficient of variation of 2.49%. The method has been adopted official first action.


1982 ◽  
Vol 65 (2) ◽  
pp. 224-226
Author(s):  
Duane H Strunk ◽  
Bertha M Timmel ◽  
Jack W Hamman ◽  
Arthur A Andreasen

Abstract A method for measuring color intensity of whisky was developed to replace the present AOAC method, which has become obsolete. The new method was collaboratively studied by 20 persons. Color intensity of whisky was measured as absorbance by a spectrophotometer, using a 1 cm cell, a bandwidth ≤10 nm, and a wavelength of 525 nm. Water was used as reference. Collaborator results appear acceptable for whisky samples that vary in color intensity from 29 to 374 CIU (absorbance X 1000 = Color Intensity Units (CIU)). The maximum standard deviation and coefficient of variation were 5.8 CIU and 6.68%, respectively. The method has been adopted official first action.


1963 ◽  
Vol 46 (2) ◽  
pp. 303-306
Author(s):  
T J Potts

Abstract A collaborative study was undertaken this year on the DMAB method for the colorimetric determination of urea in dry corn samples, which was compared with method 22.023-22.024. The DMAB method uses p-dimethylami-nobenzaldehyde as the color producer for spectrophotometry measurement. Mean values showed excellent recovery by both the official procedure and the DMAB procedure. Over-all standard deviation and coefficient of variation for all three dry corn samples containing urea indicated greater precision and accuracy by the DMAB procedure; collaborators expressed preference for this method. Further work is recommended to finalize the determination of urea in feeds.


1998 ◽  
Vol 81 (4) ◽  
pp. 763-774 ◽  
Author(s):  
Joanna M Lynch ◽  
David M Barbano ◽  
J Richard Fleming

Abstract The classic method for determination of milk casein is based on precipitation of casein at pH 4.6. Precipitated milk casein is removed by filtration and the nitrogen content of either the precipitate (direct casein method) or filtrate (noncasein nitrogen; NCN) is determined by Kjeldahl analysis. For the indirect casein method, milk total nitrogen (TN; Method 991.20) is also determined and casein is calculated as TN minus NCN. Ten laboratories tested 9 pairs of blind duplicate raw milk materials with a casein range of 2.42- 3.05℅ by both the direct and indirect casein methods. Statistical performance expressed in protein equivalents (nitrogen ⨯ 6.38) with invalid and outlier data removed was as follows: NCN method (wt%), mean = 0.762, sr = 0.010, SR = 0.016, repeatability relative standard deviation (RSDr) = 1.287℅, reproducibility relative standard deviation (RSDR) = 2.146%; indirect casein method (wt℅), mean = 2.585, repeatability = 0.015, reproducibility = 0.022, RSDr = 0.560℅, RSDR = 0.841; direct casein method (wt℅), mean = 2.575, sr = 0.015, sR = 0.025, RSDr = 0.597℅, RSDR = 0.988℅. Method performance was acceptable and comparable to similar Kjeldahl methods for determining nitrogen content of milk (Methods 991.20, 991.21,991.22, 991.23). The direct casein, indirect casein, and noncasein nitrogen methods have been adopted by AOAC INTERNATIONAL.


1973 ◽  
Vol 56 (5) ◽  
pp. 1164-1172
Author(s):  
Milan Ihnat ◽  
Robert J Westerby ◽  
Israel Hoffman

Abstract The distillation-spectrophotometric method of Hoffman for determining maleic hydrazide has been modified to include a double distillation and was applied to the determination of 1–30 ppm maleic hydrazide residues in tobacco and vegetables. Recoveries of 1–23 μg added maleic hydrazide were independent of weight of maleic hydrazide, but did depend on sample and sample weight. The following recoveries were obtained from 0.5 g sample: pipe tobacco, 84%; commercially dehydrated potato, 83%; cigar tobacco, 81%; dried potato, 76%; fluecured tobacco, 73%; dried carrot, 71%. In the absence of sample, the recovery was 82%. When appropriate standard curves were used, maleic hydrazide levels determined in tobacco samples were essentially independent of sample weight in the range 0.1–3 g. The mean relative standard deviation for a variety of field-treated and fortified tobacco samples containing 1–28 ppm maleic hydrazide was 3%. The precision and sensitivity of this procedure seem to be substantial improvements over official method 29.111–29.117. It is recommended that the present method be subjected to a collaborative study.


2002 ◽  
Vol 85 (4) ◽  
pp. 889-900 ◽  
Author(s):  
Eric Verdon ◽  
Pierric Couëdor ◽  
Pierre Maris ◽  
Michel Laurentie ◽  
P Batjoens ◽  
...  

Abstract A collaborative study involving 14 laboratories was conducted to determine residues of ampicillin in porcine muscle tissue by using a liquid chromatographic method developed for multipenicillin analysis that can quantitate 8 penicillin compounds (benzylpenicillin, phenoxymethylpenicillin, ampicillin, amoxicillin, nafcillin, oxacillin, cloxacillin, and dicloxacillin) at trace levels in muscle tissue. This method involves extraction of the penicillins with phosphate buffer, pH 9, followed cleanup and concentration on a C18 solid-phase extraction column and reaction with benzoic anhydride at 50°C and with 1,2,4-triazole and mercury(II) chloride solution, pH 9.0, at 65°C. The derivatized compounds are eluted isocratically on a C8 column with a mobile phase of acetonitrile and phosphate buffer (pH 6; 0.1M) containing sodium thiosulfate and the ion-pair reagent tetrabutylammonium hydrogen sulfate. The penicillins are detected by UV absorption at 325 nm. The limit of detection and the limit of determination (quantitation) of the method were calculated to be approximately 3–5 and 25 μg/kg, respectively, in accordance with the criteria of European Union (EU) Decision No. 93/256/EEC. In this first interlaboratory study, collaborators were instructed to monitor 4 different penicillin compounds (benzylpenicillin, phenoxymethylpenicillin, ampicillin, and amoxicillin) by analyzing 8 blind samples of muscle tissue in triplicate. These samples were prepared from 2 materials containing different concentrations of incurred ampicillin (63.5 μg/kg for material No. 1 and 358.1 μg/kg for material No. 2) and 1 blank material. The repeatability relative standard deviation and the reproducibility relative standard deviation were 10.2 and 17.4%, respectively, for material No. 1 and 7.0 and 16.0%, respectively, for material No. 2. These results demonstrate that the method is suitable for the determination of ampicillin residues in muscle tissue at the EU maximum residue limit (50 μg/kg) and above. However, the identification of positives by this procedure may need additional confirmation by techniques with greater specificity, such as liquid chromatography combined with mass spectrometry, or tandem mass spectrometry. Investigations regarding the basis of interlaboratory testing studies will further demonstrate the suitability of multiresidue methodology for detecting and quantitating other compounds in the family of penicillin antibiotics.


Sign in / Sign up

Export Citation Format

Share Document