scholarly journals Transmission of light through periodic arrays of square holes: From a metallic wire mesh to an array of tiny holes

2007 ◽  
Vol 76 (24) ◽  
Author(s):  
J. Bravo-Abad ◽  
L. Martín-Moreno ◽  
F. J. García-Vidal ◽  
E. Hendry ◽  
J. Gómez Rivas
1986 ◽  
Vol 108 (3) ◽  
pp. 446-449 ◽  
Author(s):  
G. A. Karim ◽  
M. G. Kibrya

The combustion of a homogeneous lean methane-air stream was investigated in a vertical, cylindrical combustor of 150 mm diameter in the presence of a metallic wire mesh. Eight metallic materials were deposited in turn onto a stainless steel wire mesh by electroplating. The potential improvement in the lean blowout limit due to catalytic effects was established separately from those due to the thermal and aerodynamic contributions of the wire mesh and its holder ring. The effectiveness of the various metallic surfaces tested in the lean combustion of methane was in the following descending order: Pt → Cu → Ag → brass → Cr → Cd → Ni → stainless steel. Moreover, it was confirmed that hydrogen was more sensitive to catalytic effects extending to relatively lower temperatures than methane.


2022 ◽  
Vol 170 ◽  
pp. 108599
Author(s):  
Xin Xue ◽  
Yuhan Wei ◽  
Fang Wu ◽  
Hongbai Bai ◽  
Chunhong Lu ◽  
...  

2013 ◽  
Vol 57 (2) ◽  
pp. 690-697 ◽  
Author(s):  
Zenghui Zhao ◽  
Yoav Peles ◽  
Michael K. Jensen
Keyword(s):  

2007 ◽  
Vol 253 (6) ◽  
pp. 3303-3310 ◽  
Author(s):  
Hong Sun ◽  
Xie Quan ◽  
Shuo Chen ◽  
Huimin Zhao ◽  
Yazhi Zhao

Author(s):  
J. R. Michael ◽  
C. H. Lin ◽  
S. L. Sass

The segregation of solute atoms to grain boundaries in polycrystalline solids can be responsible for embrittlement of the grain boundaries. Although Auger electron spectroscopy (AES) and analytical electron microscopy (AEM) have verified the occurrence of solute segregation to grain boundaries, there has been little experimental evidence concerning the distribution of the solute within the plane of the interface. Sickafus and Sass showed that Au segregation causes a change in the primary dislocation structure of small angle [001] twist boundaries in Fe. The bicrystal specimens used in their work, which contain periodic arrays of dislocations to which Au is segregated, provide an excellent opportunity to study the distribution of Au within the boundary by AEM.The thin film Fe-0.8 at% Au bicrystals (composition determined by Rutherford backscattering spectroscopy), ∼60 nm thick, containing [001] twist boundaries were prepared as described previously. The bicrystals were analyzed in a Vacuum Generators HB-501 AEM with a field emission electron source and a Link Analytical windowless x-ray detector.


Author(s):  
K. L. Merkle

The atomic structures of internal interfaces have recently received considerable attention, not only because of their importance in determining many materials properties, but also because the atomic structure of many interfaces has become accessible to direct atomic-scale observation by modem HREM instruments. In this communication, several interface structures are examined by HREM in terms of their structural periodicities along the interface.It is well known that heterophase boundaries are generally formed by two low-index planes. Often, as is the case in many fcc metal/metal and metal/metal-oxide systems, low energy boundaries form in the cube-on-cube orientation on (111). Since the lattice parameter ratio between the two materials generally is not a rational number, such boundaries are incommensurate. Therefore, even though periodic arrays of misfit dislocations have been observed by TEM techniques for numerous heterophase systems, such interfaces are quasiperiodic on an atomic scale. Interfaces with misfit dislocations are semicoherent, where atomically well-matched regions alternate with regions of misfit. When the misfit is large, misfit localization is often difficult to detect, and direct determination of the atomic structure of the interface from HREM alone, may not be possible.


Sign in / Sign up

Export Citation Format

Share Document