scholarly journals Effect of Temperature on H2 Evolution and Acetylene Reduction in Pea Nodules and in Isolated Bacteroids

1985 ◽  
Vol 77 (2) ◽  
pp. 335-338 ◽  
Author(s):  
Hans Bertelsen
Keyword(s):  
Acetylene Reduction ◽  
Effect Of Temperature ◽  
H2 Evolution

scholarly journals Nitrogenase of Klebsiella pneumoniae. Distinction between proton-reducing and acetylene-reducing forms of the enzyme: effect of temperature and component protein ratio on substrate-reduction kinetics

1977 ◽  
Vol 167 (2) ◽  
pp. 457-461 ◽  
Author(s):  
R N F Thorneley ◽  
R R Eady
Keyword(s):  
Klebsiella Pneumoniae ◽  
Acetylene Reduction ◽  
Electron Flow ◽  
Turnover Time ◽  
Effect Of Temperature ◽  
Lag Phase ◽  
H2 Evolution ◽  
Protein Ratio ◽  
Substrate Reduction ◽  
Fe Protein

Non-linear rates of acetylene reduction and concomitant H2 evolution were observed for the nitrogenase of Klebsiella pneumoniae at 10 degrees C. A lag phase of 1-4 min, dependent on the ratio of Mo-Fe protein to Fe protein present, occurred before linear rates of acetylene reduction were achieved. A complementary burst phase for concomitant H2 evolution in the presence of acetylene was also observed. When the proton was the only reducible substrate present, linear rates of H2 evolution were observed. N2 was a poor substrate under these conditions. Similar lag and burst phases occurred at 30 degrees C, but only when a large molar excess of Mo-Fe protein with respect to Fe protein was present. The results at 10 degrees C show that the binding of acetylene to the enzyme stimulates electron flow, but that these electrons, which initially reduce protons, can only reduce acetylene after a lag phase that cannot be accommodated in the turnover time calculated under steady-state conditions.

Acetylene reduction, H2 evolution and 15N2 fixation in the Alnus incana-Frankia symbiosis

Planta ◽  
1986 ◽  
Vol 167 (3) ◽  
pp. 382-386 ◽  
Author(s):  
A. Sellstedt
Keyword(s):  
Acetylene Reduction ◽  
Alnus Incana ◽  
H2 Evolution

scholarly journals Nitrogenase of Klebsiella pneumoniae nifV mutants. Investigation of the novel carbon monoxide-sensitivity of hydrogen evolution by the mutant enzyme

1983 ◽  
Vol 211 (3) ◽  
pp. 589-597 ◽  
Author(s):  
P A McLean ◽  
B E Smith ◽  
R A Dixon
Keyword(s):  
Klebsiella Pneumoniae ◽  
Acetylene Reduction ◽  
Competitive Inhibitor ◽  
H2 Production ◽  
Mutant Enzyme ◽  
Wild Type ◽  
H2 Evolution ◽  
Ph Optimum ◽  
Mofe Protein ◽  
Fe Protein

The MoFe protein of nitrogenase from Klebsiella pneumoniae nifV mutants, NifV- Kp1 protein, in combination with the Fe protein from wild-type cells, catalysed CO-sensitive H2 evolution, in contrast with the CO-insensitive reaction catalysed by the wild-type enzyme. The decrease in H2 production was accompanied by a stoicheiometric decrease in dithionite (reductant) utilization, implying that CO was not reduced. However, CO did not affect the rate of phosphate release from ATP. Therefore the ATP/2e ratio increased, indicating futile cycling of electrons between the Fe protein and the MoFe protein. The inhibition of H2 evolution by CO was partial; it increased from 40% at pH6.3 to 82% at pH 8.6. Inhibition at pH7.4 (maximum 73%) was half-maximal at 3.1 Pa (0.031 matm) CO. The pH optimum of the mutant enzyme was lower in the presence of CO. Steady-state kinetic analysis of acetylene reduction indicated that CO was a linear, intersecting, non-competitive inhibitor of acetylene reduction with Kii = 2.5 Pa and Kis = 9.5 Pa. This may indicate that a single high-affinity CO-binding site in the NifV- Kp1 protein can cause both partial inhibition of H2 evolution and total elimination of acetylene reduction. Various models to explain the data are discussed.

Nucleation of Disorder in Fe3Al Alloys

1967 ◽  
Vol 25 ◽  
pp. 312-313
Author(s):  
P. R. Swann ◽  
W. R. Duff ◽  
R. M. Fisher
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Annealing Temperature ◽  
Antiphase Domain ◽  
Effect Of Temperature ◽  
Domain Structures ◽  
Transmission Electron ◽  
Domain Boundaries ◽  
Higher Temperature ◽  
The One

Recently we have investigated the phase equilibria and antiphase domain structures of Fe-Al alloys containing from 18 to 50 at.% Al by transmission electron microscopy and Mössbauer techniques. This study has revealed that none of the published phase diagrams are correct, although the one proposed by Rimlinger agrees most closely with our results to be published separately. In this paper observations by transmission electron microscopy relating to the nucleation of disorder in Fe-24% Al will be described. Figure 1 shows the structure after heating this alloy to 776.6°C and quenching. The white areas are B2 micro-domains corresponding to regions of disorder which form at the annealing temperature and re-order during the quench. By examining specimens heated in a temperature gradient of 2°C/cm it is possible to determine the effect of temperature on the disordering reaction very precisely. It was found that disorder begins at existing antiphase domain boundaries but that at a slightly higher temperature (1°C) it also occurs by homogeneous nucleation within the domains. A small (∼ .01°C) further increase in temperature caused these micro-domains to completely fill the specimen.

The effect of temperature on high-resolution TEM image contrast

1995 ◽  
Vol 53 ◽  
pp. 640-641
Author(s):  
T. Geipel ◽  
W. Mader ◽  
P. Pirouz
Keyword(s):  
Form Factor ◽  
Inelastic Scattering ◽  
Accurate Method ◽  
Waller Factor ◽  
Effect Of Temperature ◽  
Specimen Thickness ◽  
Influence Of Temperature ◽  
Debye Waller Factor ◽  
Influence Of Temperature On ◽  
Atomic Form Factor

Temperature affects both elastic and inelastic scattering of electrons in a crystal. The Debye-Waller factor, B, describes the influence of temperature on the elastic scattering of electrons, whereas the imaginary part of the (complex) atomic form factor, fc = fr + ifi, describes the influence of temperature on the inelastic scattering of electrons (i.e. absorption). In HRTEM simulations, two possible ways to include absorption are: (i) an approximate method in which absorption is described by a phenomenological constant, μ, i.e. fi; - μfr, with the real part of the atomic form factor, fr, obtained from Hartree-Fock calculations, (ii) a more accurate method in which the absorptive components, fi of the atomic form factor are explicitly calculated. In this contribution, the inclusion of both the Debye-Waller factor and absorption on HRTEM images of a (Oll)-oriented GaAs crystal are presented (using the EMS software.Fig. 1 shows the the amplitudes and phases of the dominant 111 beams as a function of the specimen thickness, t, for the cases when μ = 0 (i.e. no absorption, solid line) and μ = 0.1 (with absorption, dashed line).

Utilization of the acetylene reduction assay to screen for tolerance of symbiotic N2 fixation to limiting P nutrition in common bean

1997 ◽  
Vol 99 (2) ◽  
pp. 227-232
Author(s):  
Vincent Vadez ◽  
Douglas P. Beck ◽  
Jesus H. Lasso ◽  
Jean-Jacques Drevon
Keyword(s):  
Common Bean ◽  
N2 Fixation ◽  
Acetylene Reduction ◽  
Acetylene Reduction Assay ◽  
Symbiotic N2 Fixation ◽  
P Nutrition ◽  
Reduction Assay

The development of dormancy in bulblets of Lilium speciosum generated in vitro. II. The effect of temperature

1990 ◽  
Vol 80 (3) ◽  
pp. 431-436 ◽  
Author(s):  
Isabelle Delvallee ◽  
Annie Paffen ◽  
Geert-Jan De Klerk
Keyword(s):  
Effect Of Temperature ◽  
Lilium Speciosum

Effect of Temperature on ADP-Induced Platelet Aggregation

1973 ◽  
Vol 29 (01) ◽  
pp. 183-189
Author(s):  
C. A Praga ◽  
E. M Pogliani
Keyword(s):  
Platelet Aggregation ◽  
Incubation Period ◽  
Room Temperature ◽  
Important Variable ◽  
Practical Significance ◽  
Effect Of Temperature ◽  
Induce Platelet Aggregation ◽  
Cuvette Holder ◽  
Exact Temperature

SummaryTemperature represents a very important variable in ADP-induced platelet aggregation.When low doses of ADP ( < 1 (μM) are used to induce platelet aggregation, the length of the incubation period of PRP in the cuvette holder of the aggregometer, thermostatted at 37° C, is very critical. Samples of the same PRP previously kept at room temperature, were incubated for increasing periods of time in the cuvette of the aggregometer before adding ADP, and a significant decrease of aggregation, proportional to the length of incubation, was observed. Stirring of the PRP during the incubation period made these changes more evident.To measure the exact temperature of the PRP during incubation in the aggre- gometer, a thermocouple device was used. While the temperature of the cuvette holder was stable at 37° C, the PRP temperature itself increased exponentially, taking about ten minutes from the beginning of the incubation to reach the value of 37° C. The above results have a practical significance in the reproducibility of the platelet aggregation test in vitro and acquire particular value when the effect of inhibitors of ADP induced platelet aggregation is studied.Experiments carried out with three anti-aggregating agents (acetyl salicyclic acid, dipyridamole and metergoline) have shown that the incubation conditions which influence both the effect of the drugs on platelets and the ADP breakdown in plasma must be strictly controlled.

Sign in / Sign up

Export Citation Format

Share Document