scholarly journals Bragg-edge attenuation spectra at voxel level from 4D wavelength-resolved neutron tomography

2020 ◽  
Vol 53 (1) ◽  
pp. 188-196 ◽  
Author(s):  
Chiara Carminati ◽  
Markus Strobl ◽  
Triestino Minniti ◽  
Pierre Boillat ◽  
Jan Hovind ◽  
...  

4D wavelength-resolved neutron tomography of a reference sample made of several polycrystalline materials, namely nickel, iron, titanium, lead, copper and aluminium, is presented. Data were acquired using the time-of-flight transmission imaging method at the IMAT beamline at the ISIS pulsed neutron source. Wavelength-dispersive tomography reconstruction was computed using filtered back projection, allowing wavelength-resolved total-cross-section retrieval for each voxel in the reconstructed volume of the sample. The need for background correction to enable quantitative results and analysis is discussed, and the achieved 3D spatial resolution with respect to the obtained Bragg-edge pattern quality is investigated.

2021 ◽  
Vol 11 (11) ◽  
pp. 5219
Author(s):  
Yosuke Sakurai ◽  
Hirotaka Sato ◽  
Nozomu Adachi ◽  
Satoshi Morooka ◽  
Yoshikazu Todaka ◽  
...  

As a new method for evaluating single crystals and oligocrystals, pulsed neutron Bragg-dip transmission analysis/imaging method is being developed. In this study, a single Bragg-dip profile-fitting analysis method was newly developed, and applied for analyzing detailed inner information in a crystalline grain position-dependently. In the method, the spectrum profile of a single Bragg-dip is analyzed at each position over a grain. As a result, it is expected that changes in crystal orientation, mosaic spread angle and thickness of a perfect crystal can be evaluated from the wavelength, the width and the integrated intensity of the Bragg-dip, respectively. For confirming this effectiveness, the method was applied to experimental data of position-dependent Bragg-dip transmission spectra of a Si-steel plate consisting of oligocrystals. As a result, inner information of multiple crystalline grains could be visualized and evaluated. The small change in crystal orientation in a grain, about 0.4°, could be observed by imaging the Bragg-dip wavelengths. By imaging the Bragg-dip widths, both another grain and mosaic block in a grain were detected. Furthermore, imaging results of the integrated intensities of Bragg-dips were consistent with the results of Bragg-dip width imaging. These small crystallographic changes have not been observed and visualized by previous Bragg-dip analysis methods.


IUCrJ ◽  
2018 ◽  
Vol 5 (6) ◽  
pp. 716-726 ◽  
Author(s):  
Timur E. Gureyev ◽  
Alexander Kozlov ◽  
Yakov I. Nesterets ◽  
David M. Paganin ◽  
Andrew V. Martin ◽  
...  

It is shown that the average signal-to-noise ratio (SNR) in the three-dimensional electron-density distribution of a sample reconstructed by coherent diffractive imaging cannot exceed twice the square root of the ratio of the mean total number of scattered photons detected during the scan and the number of spatially resolved voxels in the reconstructed volume. This result leads to an upper bound on Shannon's information capacity of this imaging method by specifying the maximum number of distinguishable density distributions within the reconstructed volume when the radiation dose delivered to the sample and the spatial resolution are both fixed. If the spatially averaged SNR in the reconstructed electron density is fixed instead, the radiation dose is shown to be proportional to the third or fourth power of the spatial resolution, depending on the sampling of the three-dimensional diffraction space and the scattering power of the sample.


2002 ◽  
Vol 35 (4) ◽  
pp. 497-504 ◽  
Author(s):  
Javier Roberto Santisteban ◽  
A. Steuwer ◽  
L. Edwards ◽  
P. J. Withers ◽  
M. E. Fitzpatrick

Stress measurement by neutron diffraction depends critically on knowledge of the unstressed lattice parameter (a0) of the specimen under study. As a result, measurement of stress profiles in components wherea0is not homogeneous throughout the sample, such as welds or carburized surfaces, can be particularly difficult. An efficient solution to this problem is proposed based on the pulsed neutron transmission diffraction technique. This technique exploits the sharp steps in intensity, the so-called Bragg edges, appearing in the transmitted neutron spectra of polycrystalline materials, such steps being produced by coherent scattering from lattice planes. The position of these Bragg edges as defined by the time-of-flight technique is used to determine precisely local interplanar distances. In this work it is shown that the unstressed lattice parameter of thin specimens subjected to plane stress fields can be defined by recording transmission spectra at different sample inclinations, in complete analogy with the sin2ψ technique used in X-ray diffraction. Moreover, by using an array of detectors it is possible to produce a radiographic `image' ofa0for plane specimens or thin sections out of three-dimensional ones. The capability of the technique is exemplified by mapping the changes ina0for a ferritic weld that was used as a round robin sample in an international program for standardization of stress measurements by neutron diffraction.


2020 ◽  
Vol 79 (Suppl 1) ◽  
pp. 1829.2-1829
Author(s):  
A. Blanken ◽  
C. J. Van der Laken ◽  
M. Nurmohamed

Background:Optical spectral transmission imaging (OST) is a new imaging method that measures inflammation in the hands of rheumatoid arthritis (RA) patients. OST might be used to assess disease activity instead of disease activity score 28 (DAS28) or ultrasonography (US). The advantage of OST is that it is fast and not operator dependent. Up to now OST has only been investigated cross-sectionally and it is unknown if and to what extent OST can detect inflammatory changes due to anti-inflammatory treatment for RA.Objectives:To compare OST measurements before and after 1 month of biological treatment for RA and to compare these OST changes with changes on US and disease activity.Methods:The HandScan device from Hemics, the Netherlands, was used to measure OST scores for 13 RA patients before and after 1 month of anti-inflammatory therapy. Treatment included tumor necrosis factor inhibitor (n=10), tocilizumab (n=2) and tofacitinib (n=1). OST scores range from 0-66 (one score for both hands) and are based on bilateral wrist, MCP and PIP joints. US was performed in the same joints as OST and semi-quantitatively scored on a scale of 0-3 for grey-scale (GS) synovitis and power Doppler (PD) signal. Joint scores of GS synovitis or PD were summed, resulting is a total GS synovitis score and a total PD score, both also ranging from 0-66. Furthermore, tender joint count 28 (TJC28), swollen joint count 28 (SJC28), DAS28, C-reactive protein (CRP) and erythrocyte sedimentation rate (ESR) were determined. Response to therapy was defined as achieving the minimal clinically interesting improvement of DAS28 (DAS28 difference after 1 month > -1) as proposed by Ward et al. [1]Results:Baseline OST was 17.73 ± 6.10 and this significantly decreased to 16.01 ± 6.68 (difference -1.71, 95%CI 0.05-3.38, p=0.045) after 1 month of therapy. This decrease was only present in patients who responded to therapy (n=8; OST decreased from 17.24 ± 5.98 to 14.26 ± 5.65, p=0.01) and not in non-responders (n=5; OST increased from 18.52 ± 6.90 to 18.83 ± 7.87, p=0.03).In the total group, also DAS28 (difference -1.59, 95%CI 0.74-2.45, p=0.002), SJC28 (difference 4.62, 95%CI 1.50-7.73, p=0.007), ESR (Wilcoxon Rank p=0.008) and CRP (Wilcoxon Rank p=0.03) significantly decreased after 1 month of therapy, but TJC28 did not (difference 2.62, 95%CI -2.7-7.91, p=0.30).OST change after 1 month of therapy significantly correlated with TCJ28 change (table 1). For GS synovitis the correlation coefficient nearly reached statistical significance. Changes in all other disease activity parameters were not correlated with OST change.Table 1.Correlation of change in OST measurement with change in disease activity after 1 months of anti-inflammatory therapySpearman rp-valueTotal GS synovitis0.540.06Total PD0.220.47DAS280.350.25SJC280.290.33TJC280.630.02ESR-0.420.15CRP-0.230.45Conclusion:OST scores significantly decreased after 1 month of anti-inflammatory therapy and only in the RA group that responded well to this therapy. This indicates that OST is capable of detecting therapy induced inflammatory changes in the hands of RA patients. Larger studies are needed to further assess the monitoring value of OST for therapy efficacy in RA patients.References:[1]Ward et al. 2015 Clinically important changes in individual and composite measures of rheumatoid arthritis activity: thresholds applicable in clinical trials. Ann Rheum Dis 74(9): p. 1691-6.Disclosure of Interests:Annelies Blanken: None declared, C.J. van der Laken: None declared, Michael Nurmohamed Grant/research support from: Not related to this research, Consultant of: Not related to this research, Speakers bureau: Not related to this research


2014 ◽  
Vol 60 ◽  
pp. 254-263 ◽  
Author(s):  
Hirotaka Sato ◽  
Yoshinori Shiota ◽  
Takashi Kamiyama ◽  
Masato Ohnuma ◽  
Michihiro Furusaka ◽  
...  

2003 ◽  
Vol 36 (5) ◽  
pp. 1159-1168 ◽  
Author(s):  
Axel Steuwer ◽  
Javier Roberto Santisteban ◽  
Philip J. Withers ◽  
Lyndon Edwards ◽  
Mike E. Fitzpatrick

The pulsed neutron transmission diffraction technique exploits the sharp steps in intensity (Bragg edges) appearing in the transmitted spectra of thermal neutrons through polycrystalline materials. In this paper the positions of these edges acquired by the time-of-flight (TOF) technique are used to measure accurately the interplanar lattice distances to a resolution of Δd/d≃ 10−4of specimens subjected toin situuniaxial tensile loading. The sensitivity of the method is assessed for elastically isotropic (b.c.c. ferritic) and anisotropic (f.c.c. austenitic) polycrystalline specimens of negligible and moderately textured steels. For the more anisotropic austenitic steel, the elastic anisotropy is studied with regard to a Pawley refinement, and compared with previous results from conventional neutron diffraction experiments on the same material. It is shown that the method can be used to determine anisotropic strains, diffraction elastic constants, the residual and applied stress state as well as the unstrained lattice parameter by recording transmission spectra at different specimen inclinations, by complete analogy with the sin2ψ technique frequently used in X-ray diffraction. The technique is shown to deliver reliable measures of strain even in the case of moderate texture and elastic anisotropy.


2015 ◽  
Vol 56 (8) ◽  
pp. 1147-1152 ◽  
Author(s):  
Hirotaka Sato ◽  
Tomoya Sato ◽  
Yoshinori Shiota ◽  
Takashi Kamiyama ◽  
Anton S. Tremsin ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document