scholarly journals Proposing New Planar-Type Search Coil for Permanent Magnet Synchronous Motor: Design and Application for Position Estimation

IEEE Access ◽  
2021 ◽  
Vol 9 ◽  
pp. 129078-129087
Author(s):  
Jun-Hyuk Im ◽  
Jin Hur
Keyword(s):  
Permanent Magnet ◽  
Permanent Magnet Synchronous Motor ◽  
Synchronous Motor ◽  
Position Estimation ◽  
Search Coil ◽  
Motor Design ◽  
Design And Application

scholarly journals Nonlinear Backstepping Control of Permanent Magnet Synchronous Motor with Rotor Speed and Position Estimation

2018 ◽  
Vol 3 (3) ◽  
pp. 133-142
Author(s):  
Abderrahmen KIRAD ◽  
Said Grouni ◽  
Omar MECHALI
Keyword(s):  
Permanent Magnet ◽  
High Performance ◽  
Permanent Magnet Synchronous Motor ◽  
Synchronous Motor ◽  
Backstepping Control ◽  
Position Estimation ◽  
Nonlinear Feedback ◽  
Precise Knowledge ◽  
The Stability ◽  
Nonlinear Backstepping Control

This paper presents a nonlinear backstepping control strategy used to ensure good dynamic behavior, high performance and the stability of the permanent magnet synchronous motor (PMSM). However, this control requires the precise knowledge of certain variables (speed, torque and position) that are difficult to access or sensors require additional mounting space, reduce reliability, increase the cost of the engine, and make maintenance difficult. Thus, an Extended Kalman Filter (EKF) approach is proposed for the estimation of speed and rotor position in the PMSM. The interesting simulation results obtained which are subjected to the load perturbation show very well the efficiency and the good performance of the nonlinear feedback control proposed and simulated in Matlab-Simulink.

scholarly journals Position Estimation of a PMSM in an Electric Propulsion Ship System Based on High-Frequency Injection

Electronics ◽  
2020 ◽  
Vol 9 (2) ◽  
pp. 276 ◽  
Author(s):  
Hongfen Bai
Keyword(s):  
Permanent Magnet ◽  
High Frequency ◽  
Electric Propulsion ◽  
Permanent Magnet Synchronous Motor ◽  
Estimation Algorithm ◽  
Synchronous Motor ◽  
Position Estimation ◽  
Second Order ◽  
Application Range ◽  
Rotor Position

To improve the operating performance of electric propulsion ships, the permanent magnet synchronous motor is commonly used as the propulsion motor. Additionally, position estimation without sensors can further improve the application range of the propulsion motor and the estimated results can represent the redundancy of measured values from mechanical sensors. In this paper, the high-frequency (HF) injection algorithm combined with the second-order generalized integrator (SOGI) is presented on the basis of analyzing the structure of the electric propulsion ship and the vector control of the motors. The position and rotor speed were estimated accurately by the approximate calculation of q-axis currents directly related to the rotor position. Moreover, the harmonics in the estimated position were effectively reduced by the introduction of the second-order generalized integrator. Then, the rotor position estimation algorithm was verified in MATLAB/Simulink by choosing different low speeds including speed reversal, increasing speed, and increasing load torque. Finally, the correctness of the proposed improved high-frequency injection algorithm based on the second-order generalized integrator was verified by the experimental propulsion permanent magnet synchronous motor (PMSM) system at low speed.

scholarly journals Research on sensorless control method of permanent magnet synchronous motor based on iterated cubature Kalman filter

2019 ◽  
Vol 103 (1) ◽  
pp. 003685041989027
Author(s):  
Shi Peicheng ◽  
Wang Chen ◽  
Zhang Rongyun ◽  
Wang Suo
Keyword(s):  
Kalman Filter ◽  
Permanent Magnet ◽  
Sensorless Control ◽  
Permanent Magnet Synchronous Motor ◽  
Estimation Method ◽  
Synchronous Motor ◽  
Position Estimation ◽  
Motor Speed ◽  
Rotor Position ◽  
Cubature Kalman Filter

Aiming at the problems of high cost, increased volume, low reliability, and environmental interference caused by sensor installation on permanent magnet synchronous motor, estimation method for motor speed and rotor position is proposed based on iterated cubature Kalman filter algorithm and applied to permanent magnet synchronous motor sensorless control. First, discrete mathematical model of permanent magnet synchronous motor in α-β coordinate system is established. Then, based on cubature Kalman filter and iterated cubature Kalman filter, simulation model of sensorless vector control system with dual closed-loop of permanent magnet synchronous motor speed and current is established. Also, simulation verification of two working conditions with given rotation speed and load is carried out. Finally, hardware experimental verification platform is built based on TMS320F28335 chip. Both simulation analysis and experimental results show that iterated cubature Kalman filter application to sensorless control of permanent magnet synchronous motor demonstrates good anti-load variation interference, stable motor operation, high motor speed and rotor position estimation accuracy, which suits the application with high requirement for precise motor control and mean important reference value and promotion significance.

Sign in / Sign up

Export Citation Format

Share Document