Three-phase Voltage-type PWM Rectifier Controller Design Based on Feedback Linearization

Author(s):  
Tongying Li ◽  
Hongbo Zhu
2013 ◽  
Vol 321-324 ◽  
pp. 917-920
Author(s):  
Guang Ya Liu ◽  
Xiao Song Li

Three-phase voltage source PWM rectifier generally adopts double closed loop control system. According to the high frequency characteristic of three-phase voltage source PWM rectifier, this paper put forward the setting method of current inner ring regulator and voltage outer ring regulator PI parameter. Finally, it is verified by simulation.


2016 ◽  
Vol 78 (6-2) ◽  
Author(s):  
Maher. G. M. Abdolrasol ◽  
M A Hannan ◽  
Azah Mohamed

This paper explains a deep comparison between two controller techniques firstly controller control on modulation index and the second controller use dq method. Both of these controller approaches have control on three phase voltage and use the same system unchanged. The system is a solar system together with a backup battery connected to a single housing unit. Particle Swarm Optimization (PSO) algorithm has been utilized to improve the controller performance by automatically finding its parameters in order to reduce the error in the proportional Integral (PI) controller. Optimization process has been done with a real recording data of housing unit demand in Malaka, Malaysia. System has been simulated and tested in MATLAB/Simulink environment with m-file runs PSO algorithm and simulate the system hundreds of times to get the best results showing in this paper. Comparisons were taking place in controller design and in the simulation results that express the strength and weaken points of each controller starts with THD voltage and current waveform and RMS voltage in each controller.  


Author(s):  
Zeng zhihui ◽  
Zhang yiming ◽  
Yu Fei ◽  
Feng jinlan

2015 ◽  
Vol 743 ◽  
pp. 172-175
Author(s):  
S.S. Shi ◽  
Z.W. Zhang ◽  
Liu Shu ◽  
T.Y. Yin ◽  
Y. Li

This article presents a double closed loop control system for three-phase voltage source<br />PWM rectifier based on a real-time workshop(RTW), introduces the debugging method of 64-bit<br />RTW platform. Then the simulation model is converted into the real-time code, and downloaded to<br />the platform controlled of DSP TMS320F2812 to verify the feasibility. The experimental results<br />agrees the simulation results. This method greatly reduces the project development cycle and cost.


Sign in / Sign up

Export Citation Format

Share Document