Influence of Ponderomotive Forces of Electromagnetic Waves on Thin Impedance Dipoles

2020 ◽  
Author(s):  
Yuriy Penkin ◽  
Victor Katrich ◽  
Sergey Berdnik ◽  
Mikhail Nesterenko ◽  
Svetlana Pshenichnaya
Keyword(s):  
Electromagnetic Waves ◽  
Ponderomotive Forces

On the generation of magnetic fields due to ponderomotive forces in astrophysical plasmas

2002 ◽  
Vol 67 (2-3) ◽  
pp. 129-138 ◽  
Author(s):  
A. ROY CHOWDHURY ◽  
M. KHURSHED ALAM ◽  
K. ROY CHOWDHURY ◽  
S. N. PAUL ◽  
B. A. BEGUM
Keyword(s):  
Magnetic Field ◽  
Growth Rate ◽  
Magnetic Fields ◽  
Electromagnetic Waves ◽  
Inhomogeneous Plasma ◽  
Astrophysical Plasma ◽  
Astrophysical Plasmas ◽  
Ponderomotive Forces ◽  
Collisional Interactions ◽  
The Magnetic Field

The generation of magnetic fields due to ponderomotive forces in astrophysical plasma consisting of electrons, ions and positrons is investigated theoretically. It is seen that collisional or non-collisional interactions (between electromagnetic waves and plasma particles) via ponderomotive forces in an inhomogeneous plasma can excite a magnetic field. The growth rate of the magnetic field is illustrated graphically for different values of the temperature and concentration of positrons in the plasma.

Seti Space Missions

1997 ◽  
Vol 161 ◽  
pp. 761-776 ◽  
Author(s):  
Claudio Maccone
Keyword(s):  
Electromagnetic Waves ◽  
Space Missions ◽  
Gravitational Lens ◽  
The Sun ◽  
Space Antenna ◽  
Focal Distance ◽  
Large Space ◽  
The Earth ◽  
Space Antennas ◽  
New Space

AbstractSETI from space is currently envisaged in three ways: i) by large space antennas orbiting the Earth that could be used for both VLBI and SETI (VSOP and RadioAstron missions), ii) by a radiotelescope inside the Saha far side Moon crater and an Earth-link antenna on the Mare Smythii near side plain. Such SETIMOON mission would require no astronaut work since a Tether, deployed in Moon orbit until the two antennas landed softly, would also be the cable connecting them. Alternatively, a data relay satellite orbiting the Earth-Moon Lagrangian pointL2would avoid the Earthlink antenna, iii) by a large space antenna put at the foci of the Sun gravitational lens: 1) for electromagnetic waves, the minimal focal distance is 550 Astronomical Units (AU) or 14 times beyond Pluto. One could use the huge radio magnifications of sources aligned to the Sun and spacecraft; 2) for gravitational waves and neutrinos, the focus lies between 22.45 and 29.59 AU (Uranus and Neptune orbits), with a flight time of less than 30 years. Two new space missions, of SETI interest if ET’s use neutrinos for communications, are proposed.

Microwaves: Application in Electron Microscopy

1990 ◽  
Vol 48 (3) ◽  
pp. 140-141
Author(s):  
Anthony S-Y Leong ◽  
David W Gove
Keyword(s):  
Electron Microscopy ◽  
Light Microscopy ◽  
Chemical Reactions ◽  
Electromagnetic Waves ◽  
Tissue Fixation ◽  
Primary Method ◽  
Dipolar Molecules ◽  
Wide Range ◽  
Time Required ◽  
Cryostat Sections

Microwaves (MW) are electromagnetic waves which are commonly generated at a frequency of 2.45 GHz. When dipolar molecules such as water, the polar side chains of proteins and other molecules with an uneven distribution of electrical charge are exposed to such non-ionizing radiation, they oscillate through 180° at a rate of 2,450 million cycles/s. This rapid kinetic movement results in accelerated chemical reactions and produces instantaneous heat. MWs have recently been applied to a wide range of procedures for light microscopy. MWs generated by domestic ovens have been used as a primary method of tissue fixation, it has been applied to the various stages of tissue processing as well as to a wide variety of staining procedures. This use of MWs has not only resulted in drastic reductions in the time required for tissue fixation, processing and staining, but have also produced better cytologic images in cryostat sections, and more importantly, have resulted in better preservation of cellular antigens.

Scattering and coupling effects of electromagnetic waves in 3D networks of spheres

1998 ◽  
Vol 1 (1) ◽  
pp. 45-52 ◽  
Author(s):  
M. Defos du Rau ◽  
F. Pessan ◽  
G. Ruffie ◽  
V. Vignéras-Lefebvre ◽  
J. P. Parneix
Keyword(s):  
Electromagnetic Waves ◽  
Coupling Effects ◽  
3D Networks

IR SPECTROSCOPY WITH SURFACE ELECTROMAGNETIC WAVES

1984 ◽  
Vol 45 (C5) ◽  
pp. C5-167-C5-178
Author(s):  
A. J. Sievers ◽  
Z. Schlesinger ◽  
Y. J. Chabal
Keyword(s):  
Ir Spectroscopy ◽  
Electromagnetic Waves ◽  
Surface Electromagnetic Waves

Evaluation of the accuracy of reconstruction of the electrophysical and geometric parameters of multilayer dielectric coatings by the multi-frequency radio wave method of a slow surface electromagnetic waves

2020 ◽  
pp. 51-58
Author(s):  
Aleksandr I. Kazmin ◽  
Pavel A. Fedjunin
Keyword(s):  
Radio Wave ◽  
Noise Level ◽  
Electromagnetic Waves ◽  
Dielectric Materials ◽  
Geometric Parameters ◽  
Experimental Investigations ◽  
Wave Method ◽  
Dielectric Coatings ◽  
Surface Electromagnetic Waves ◽  
Multilayer Dielectric

One of the most important diagnostic problems multilayer dielectric materials and coatings is the development of methods for quantitative interpretation of the checkout results their electrophysical and geometric parameters. The results of a study of the potential informativeness of the multi-frequency radio wave method of surface electromagnetic waves during reconstruction of the electrophysical and geometric parameters of multilayer dielectric coatings are presented. The simulation model is presented that makes it possible to evaluate of the accuracy of reconstruction of the electrophysical and geometric parameters of multilayer dielectric coatings. The model takes into account the values of the electrophysical and geometric parameters of the coating, the noise level in the measurement data and the measurement bandwidth. The results of simulation and experimental investigations of reconstruction of the structure of relative permittivitties and thicknesses of single-layer and double-layer dielectric coatings with different thicknesses, with different values of the standard deviation (RMS) of the noise level in the measured attenuation coefficients of the surface slow electromagnetic wave are presented. Coatings based on the following materials were investigated: polymethyl methacrylate, F-4D PTFE, RO3010. The accuracy of reconstruction of the electrophysical parameters of the layers decreases with an increase in the number of evaluated parameters and an increase in the noise level. The accuracy of the estimates of the electrophysical parameters of the layers also decreases with a decrease in their relative permittivity and thickness. The results of experimental studies confirm the adequacy of the developed simulation model. The presented model allows for a specific measuring complex that implements the multi-frequency radio wave method of surface electromagnetic waves, to quantify the potential possibilities for the accuracy of reconstruction of the electrophysical and geometric parameters of multilayer dielectric materials and coatings. Experimental investigations and simulation results of a multilayer dielectric coating demonstrated the theoretical capabilities gained relative error permittivity and thickness of the individual layers with relative error not greater than 10 %, with a measurement bandwidth of 1 GHz and RMS of noise level 0,003–0,004.

Remote diagnostics of vibrations of dynamic objects by Doppler microwave sensors

Metrologiya ◽  
2020 ◽  
pp. 25-42
Author(s):  
Dmitrii V. Khablov
Keyword(s):  
Intelligent Systems ◽  
Electromagnetic Waves ◽  
Continuous Monitoring ◽  
Phase Changes ◽  
Vibration Diagnostics ◽  
Remote Diagnostics ◽  
Active Vibration ◽  
Dynamic Objects ◽  
Microwave Sensors ◽  
Non Destructive

This paper describes a promising method for non-contact vibration diagnostics based on the use of Doppler microwave sensors. In this case, active irradiation of the object with electromagnetic waves and the allocation of phase changes using two-channel quadrature processing of the received reflected signal are used. The modes of further fine analysis of the resulting signal using spectral or wavelet transformations depending on the nature of the active vibration are considered. The advantages of this non-contact and remote vibration analysis method for the study of complex dynamic objects are described. The convenience of the method for machine learning and use in intelligent systems of non-destructive continuous monitoring of the state of these objects by vibration is noted.

The working standard of the unit of power of electromagnetic waves in the frequency range from 37,5 to 220 GHz

2020 ◽  
pp. 53-58
Author(s):  
A. V. Koudelny ◽  
I. M. Malay ◽  
V. A. Perepelkin ◽  
I. P. Chirkov
Keyword(s):  
Microwave Power ◽  
Electromagnetic Waves ◽  
Primary Standard ◽  
The State ◽  
Frequency Range ◽  
Working Standard ◽  
Extended Frequency Range ◽  
Effective Efficiency ◽  
Extended Frequency ◽  
Good Agreement

The possibility of using bolometric converters of microwave power from the State primary standard of the unit of power of electromagnetic waves in waveguide and coaxial paths GET 167-2017, which has a frequency range from 37,5 to 78,33 GHz, in an extended frequency range up to 220 GHz, is shown. Studies of semiconductor bolometric converters of microwave power in an extended frequency range have confirmed good agreement and smooth frequency characteristics of the effective efficiency factor of the converters. Based on the research results, the State working standard of the unit of power of electromagnetic waves of 0,1–10 mW in the frequency range from 37,5 to 220 GHz 3.1.ZZT.0288.2018 was approved. The technical characteristics of the working standard of the unit of power of electromagnetic oscillations in an extended frequency range from 37,5 to 220 GHz are given.

Sign in / Sign up

Export Citation Format

Share Document