Peculiarities of measuring the alpha particle activity of flat samples of metals, alloys and powders using gas flow proportional counters specifically the model 1950 manufactured by "Spectrum Sciences", USA

Author(s):  
S.M. Zakharyasah ◽  
Y.B. Tolstukhin ◽  
I.V. Fedotova
1997 ◽  
pp. 881-884
Author(s):  
Andrew J. Nelson ◽  
David Tingey ◽  
Takashi Shoji ◽  
Kazuaki Shimizu

1988 ◽  
Vol 23 (1-4) ◽  
pp. 249-252 ◽  
Author(s):  
U.J. Schrewe ◽  
H.J. Brede ◽  
P. Pihet ◽  
H.G. Menzel

2019 ◽  
Vol 14 (06) ◽  
pp. T06009-T06009
Author(s):  
O. Aviv ◽  
E. Daniely ◽  
Y. Barazani ◽  
T. Baziza ◽  
J. Koch

1988 ◽  
Vol 23 (1-4) ◽  
pp. 249-252
Author(s):  
U.J. Schrewe ◽  
H.J. Brede ◽  
P. Pihet ◽  
H.G. Menzel

1995 ◽  
Vol 39 ◽  
pp. 881-884
Author(s):  
Andrew J. Nelson ◽  
David Tingey ◽  
Takashi Shoji ◽  
Kazuaki Shimizu

Polypropylene windows stretched to 1-1.5 μm in thickness have been traditionally used for soft x-ray detection on gas flow proportional counters. Theoretical calculations show that significant transmission Improvement could result from a thinner window. The trade-offs to ultimate transmission have traditionally been reliability and durability. A 0.3 um window has been fabricated to show significant improvement for light element transmission, A supporting grid was used to back the film and provide additional support and durability to allow for pressure cycling during venting of the spectrometer chamber. Significant transmission improvements were observed for ultra soft x rays in the energy range below 1 KeV.


1998 ◽  
Vol 49 (9-11) ◽  
pp. 1117-1121 ◽  
Author(s):  
B. Denecke ◽  
G. Grosse ◽  
T. Szabo

Author(s):  
N. David Theodore ◽  
Mamoru Tomozane ◽  
Ming Liaw

There is extensive interest in SiGe for use in heterojunction bipolar transistors. SiGe/Si superlattices are also of interest because of their potential for use in infrared detectors and field-effect transistors. The processing required for these materials is quite compatible with existing silicon technology. However, before SiGe can be used extensively for devices, there is a need to understand and then control the origin and behavior of defects in the materials. The present study was aimed at investigating the structural quality of, and the behavior of defects in, graded SiGe layers grown by chemical vapor deposition (CVD).The structures investigated in this study consisted of Si1-xGex[x=0.16]/Si1-xGex[x= 0.14, 0.13, 0.12, 0.10, 0.09, 0.07, 0.05, 0.04, 0.005, 0]/epi-Si/substrate heterolayers grown by CVD. The Si1-xGex layers were isochronally grown [t = 0.4 minutes per layer], with gas-flow rates being adjusted to control composition. Cross-section TEM specimens were prepared in the 110 geometry. These were then analyzed using two-beam bright-field, dark-field and weak-beam images. A JEOL JEM 200CX transmission electron microscope was used, operating at 200 kV.


Author(s):  
A. R. Landa Canovas ◽  
L.C. Otero Diaz ◽  
T. White ◽  
B.G. Hyde

X-Ray diffraction revealed two intermediate phases in the system MnS+Er2S3,:MnEr2S4= MnS.Er2S3, and MnEr4S7= MnS.2Er2S3. Their structures may be described as NaCl type, chemically twinned at the unit cell level, and isostructural with CaTi2O4, and Y5S7 respectively; i.e. {l13} NaCl twin band widths are (4,4) and (4,3).The present study was to search for structurally-related (twinned B.) structures and or possible disorder, using the more sensitive and appropiate technigue of electron microscopy/diffraction.A sample with nominal composition MnEr2S4 was made by heating Mn3O4 and Er2O3 in a graphite crucible and a 5% H2S in Ar gas flow at 1500°C for 4 hours. A small amount of this material was thenannealed, in an alumina crucible, contained in sealed evacuated silica tube, for 24 days at 1100°C. Both samples were studied by X-ray powder diffraction, and in JEOL 2000 FX and 4000 EX microscopes.


Sign in / Sign up

Export Citation Format

Share Document