Research on Automatic Batch Weighing and Forensic Analysis System of Centralized Filter Membrane

2021 ◽  
Author(s):  
Zheng Zhao
Keyword(s):  
Forensic Analysis ◽  
Filter Membrane ◽  
Automatic Batch ◽  
Analysis System

The Application of Compound Document Storage Technology in Forensic Analysis System

2014 ◽  
Vol 610 ◽  
pp. 756-759
Author(s):  
Jiang Du ◽  
Bin Lang Chen ◽  
Zeng Qin
Keyword(s):  
Forensic Analysis ◽  
Computer Forensics ◽  
Electronic Data ◽  
Storage Technology ◽  
Image File ◽  
Disk Mirroring ◽  
Analysis System ◽  
And Storage ◽  
Document Storage

Due to the special nature of electronic data, we need to create a complete copy of the raw disks before computer forensics. There is two ways to create a copy. One is copy from Disk to disk, another is disk mirroring. The former capacity of the copy disk has fixed while image file of the latter is highly compressed already. Neither any of them can add the forensic analysis evidence; it will be handed over to the court as a whole set of evidence. This will affect the completeness and admissibility of the evidence. In this thesis, we will take the disk mirroring and storage technology into consideration by using the Compound Document storage technology, by this way we can add the evidence into the evidence copy which makes an “evidence gathered” effect. At the same time, it can highly compressed the original evidence, save the capacity and ensure the safety of the data.

Automated Image Analysis Of Nuclear And Cytoplasmic Changes In Exfoliated Cells From Tracheas Treated With Carcinogen

1977 ◽  
Vol 35 ◽  
pp. 220-221
Author(s):  
S.F. Stinson ◽  
J.C. Lilga ◽  
M.B. Sporn
Keyword(s):  
Image Analysis ◽  
Pattern Analysis ◽  
Relative Proportion ◽  
Automated Image Analysis ◽  
Image Analyzer ◽  
Cross Sectional ◽  
Exfoliated Cells ◽  
Neoplastic Lesions ◽  
Analysis System ◽  
Morphologic Criterion

Increased nuclear size, resulting in an increase in the relative proportion of nuclear to cytoplasmic sizes, is an important morphologic criterion for the evaluation of neoplastic and pre-neoplastic cells. This paper describes investigations into the suitability of automated image analysis for quantitating changes in nuclear and cytoplasmic cross-sectional areas in exfoliated cells from tracheas treated with carcinogen.Neoplastic and pre-neoplastic lesions were induced in the tracheas of Syrian hamsters with the carcinogen N-methyl-N-nitrosourea. Cytology samples were collected intra-tracheally with a specially designed catheter (1) and stained by a modified Papanicolaou technique. Three cytology specimens were selected from animals with normal tracheas, 3 from animals with dysplastic changes, and 3 from animals with epidermoid carcinoma. One hundred randomly selected cells on each slide were analyzed with a Bausch and Lomb Pattern Analysis System automated image analyzer.

Digital Processing of STEM Images

1981 ◽  
Vol 39 ◽  
pp. 236-237
Author(s):  
A. V. Crewe ◽  
M. Ohtsuki
Keyword(s):  
High Resolution ◽  
Low Dose ◽  
Assembly Language ◽  
Processing System ◽  
Principal Component ◽  
Digital Processing ◽  
Image Analysis System ◽  
Black And White ◽  
Analysis System ◽  
Dose Imaging

We have assembled an image processing system for use with our high resolution STEM for the particular purpose of working with low dose images of biological specimens. The system is quite flexible, however, and can be used for a wide variety of images.The original images are stored on magnetic tape at the microscope using the digitized signals from the detectors. For low dose imaging, these are “first scan” exposures using an automatic montage system. One Nova minicomputer and one tape drive are dedicated to this task.The principal component of the image analysis system is a Lexidata 3400 frame store memory. This memory is arranged in a 640 x 512 x 16 bit configuration. Images are displayed simultaneously on two high resolution monitors, one color and one black and white. Interaction with the memory is obtained using a Nova 4 (32K) computer and a trackball and switch unit provided by Lexidata.The language used is BASIC and uses a variety of assembly language Calls, some provided by Lexidata, but the majority written by students (D. Kopf and N. Townes).

Chemical Classification and Particle Sizing of Foundry Sands

1985 ◽  
Vol 43 ◽  
pp. 388-389
Author(s):  
D.S. DeMiglio
Keyword(s):  
Image Analysis ◽  
Energy Dispersive Spectrometer ◽  
Image Analysis System ◽  
Representative Sampling ◽  
Foundry Sands ◽  
Large Atomic Number ◽  
Backscattered Electron ◽  
Sand Particles ◽  
Analysis System ◽  
Reclamation System

Much progress has been made in recent years towards the development of closed-loop foundry sand reclamation systems. However, virtually all work to date has determined the effectiveness of these systems to remove surface clay and metal oxide scales by a qualitative inspection of a representative sampling of sand particles. In this investigation, particles from a series of foundry sands were sized and chemically classified by a Lemont image analysis system (which was interfaced with an SEM and an X-ray energy dispersive spectrometer) in order to statistically document the effectiveness of a reclamation system developed by The Pangborn Company - a subsidiary of SOHIO.The following samples were submitted: unreclaimed sand; calcined sand; calcined & mechanically scrubbed sand and unused sand. Prior to analysis, each sample was sprinkled onto a carbon mount and coated with an evaporated film of carbon. A backscattered electron photomicrograph of a field of scale-covered particles is shown in Figure 1. Due to a large atomic number difference between sand particles and the carbon mount, the backscattered electron signal was used for image analysis since it had a uniform contrast over the shape of each particle.

Automated high-resolution microscopy: the approaches so far

1987 ◽  
Vol 45 ◽  
pp. 58-61
Author(s):  
W. O. Saxton
Keyword(s):  
High Resolution ◽  
Early Stage ◽  
Automatic Recording ◽  
Microprocessor Control ◽  
Alternative Systems ◽  
Electron Image ◽  
Complete Automation ◽  
Analysis System ◽  
High Resolution Microscopy

Recent commercial microscopes with internal microprocessor control of all major functions have already demonstrated some of the benefits anticipated from such systems, such as continuous magnification, rotation-free diffraction and magnification, automatic recording of mutually registered focal series, and fewer control knobs. Complete automation of the focusing, stigmating and alignment of a high resolution microscope, allowing focal series to be recorded at preselected focus values as well, is still imminent rather than accomplished, however; some kind of image pick-up and analysis system, fed with the electron image via a TV camera, is clearly essential for this, but several alternative systems and algorithms are still being explored. This paper reviews the options critically in turn, and stresses the need to consider alignment and focusing at an early stage, and not merely as an optional extension to a basic proposal.

Forensic applications of IR infrared microscopic internal reflection spectroscopy

1992 ◽  
Vol 50 (2) ◽  
pp. 1528-1529
Author(s):  
Edward G. Bartick ◽  
John A. Reffner
Keyword(s):  
Specular Reflection ◽  
Forensic Analysis ◽  
Attenuated Total Reflection ◽  
Internal Reflection ◽  
Standard Size ◽  
Ir Microscopy ◽  
Ir Analysis ◽  
Plastic Explosives ◽  
Internal Reflection Spectroscopy ◽  
Reflectance Measurements

Since the introduction of commercial Fourier transform infrared (FTIR) microscopic systems in 1983, IR microscopy has developed as an important analytical tool in research, industry and forensic analysis. Because of the frequent encounter of small quantities of physical evidence found at crime scenes, spectroscopic IR microscopes have proven particularly valuable for forensic applications. Transmittance and reflectance measurements have proven very useful. Reflection-absorption, specular reflection, and diffuse reflection have all been applied. However, it has been only very recently that an internal reflection (IRS) objective has been commercially introduced.The IRS method, also known as attenuated total reflection (ATR), has proven very useful for IR analysis of standard size samples. The method has been applied to adhesive tapes, plastic explosives, and general applications in the analysis of opaque materials found as evidence. The small quantities or uncontaminated areas of specimens frequently found requiring forensic analysis will often be directly applicable to microscopic IRS analysis.

A flexible test grading and item analysis system

1974 ◽  
Vol 38 (12) ◽  
pp. 691-696
Author(s):  
GL Olde ◽  
CP Cole ◽  
JW Wittrock
Keyword(s):  
Item Analysis ◽  
Analysis System
Sign in / Sign up

Export Citation Format

Share Document