Orbital Characterization Study for the Hydrodynamic Micro Tweezers: Simulated Performance with an Active Particle

Author(s):  
Senanur Duzenli ◽  
Jiyan Surer ◽  
Ahmet Fatih Tabak
2017 ◽  
Vol 120 (3) ◽  
pp. 303-322
Author(s):  
D. Pienaar ◽  
B.M. Guy ◽  
C. Pienaar ◽  
K.S. Viljoen

Abstract Mineralogical and textural variability of ores from different sources commonly leads to processing inefficiencies, particularly when a processing plant is designed to treat ore from a single source (i.e. ore of a relatively uniform composition). The bulk of the Witwatersrand ore in the Klerksdorp goldfield, processed at the AngloGold Ashanti Great Noligwa treatment plant, is derived from the Vaal Reef (>90%), with a comparatively small contribution obtained from the Crystalkop Reef (or C-Reef). Despite the uneven contribution, it is of critical importance to ensure that the processing parameters are optimized for the treatment of both the Vaal and C-Reefs. This paper serves to document the results of a geometallurgical study of the C-Reef at the Great Noligwa gold mine in the Klerksdorp goldfield of South Africa, with the primary aim of assessing the suitability of the processing parameters that are in use at the Great Noligwa plant. The paper also draws comparisons between the C-Reef and the Vaal Reef A-facies (Vaal Reef) and attempts to explain minor differences in the recovery of gold and uranium from these two sources. Three samples of the C-Reef were collected in-situ from the underground operations at Great Noligwa mine for mineralogical analyses and metallurgical tests. Laboratory-scale leach tests for gold (cyanide) and uranium (sulphuric acid) were carried out using dissolution conditions similar to that in use at the Great Noligwa plant, followed by further diagnostic leaching in the case of gold. The gold in the ore was found to be readily leachable with recoveries ranging from 95% to 97% (as opposed to 89% to 93% for the Vaal Reef). Additional recoveries were achieved in the presence of excess cyanide (96% to 98%). The recovery of uranium varied between 72% and 76% (as opposed to 30% to 64% for the Vaal Reef), which is substantially higher than predicted, given the amount of brannerite in the ore, which is generally regarded as refractory. Thus, the higher uranium recoveries from the C-Reef imply that a proportion of the uranium was recovered by the partial dissolution of brannerite. As the Vaal Reef contain high amounts of chlorite (3% to 8%), which is an important acid consumer, it is considered likely that this could have reduced the effectiveness of the H2SO4 leach in the case of the ore of the Vaal Reef. Since the gold and uranium recoveries from the C-Reef were higher than the recoveries from the Vaal Reef, the results demonstrate that the processing parameters used for treatment of the Vaal Reef are equally suited to the treatment of the C-Reef. Moreover, small processing modifications, such as increased milling and leach retention times, may well increase the recovery of gold (particularly when e.g. coarse gold, or unexposed gold, is present).


1966 ◽  
Vol 241 (17) ◽  
pp. 4101-4109
Author(s):  
Leo P. Vernon ◽  
Elwood R. Shaw ◽  
Bacon Ke
Keyword(s):  

Author(s):  
Sumon Modak ◽  
Taimoor Khan

Abstract This study presents a novel configuration of a cuboidal quad-port ultra-wideband multiple-input and multiple-output antenna with WLAN rejection characteristics. The designed antenna consists of four F-shaped elements backed by a partial ground plane. A 50 Ω microstrip line is used to feed the proposed structure. The geometry of the suggested antenna exhibits an overall size of 23 × 23 × 19 mm3, and the antenna produces an operational bandwidth of 7.6 GHz (3.1–10.7 GHz). The notched band characteristic at 5.4 GHz is accomplished by loading a pair of spiral electromagnetic bandgap structures over the ground plane. Besides this, other diversity features such as envelope correlation coefficient, and diversity gain are also evaluated. Furthermore, the proposed antenna system provides an isolation of −15 dB without using any decoupling structure. Therefore, to validate the reported design, a prototype is fabricated and characterized. The overall simulated performance is observed in very close agreement with it's measured counterpart.


2021 ◽  
Vol 6 (18) ◽  
pp. 4533-4538
Author(s):  
Rajagopal Gomathi ◽  
Harindran Suhana ◽  
Deivanayagam Paradesi

Author(s):  
Marcos Aquino ◽  
Juan Guerra ◽  
Samanta Holanda ◽  
Humberto Andrade ◽  
Moises Melo ◽  
...  

Proceedings ◽  
2020 ◽  
Vol 69 (1) ◽  
pp. 38
Author(s):  
Celia Idres ◽  
Mustapha Kaci ◽  
Nadjet Dehouche ◽  
Idris Zembouai ◽  
Stéphane Bruzaud

This paper aims to investigate the effect of different chemical modifications of biocomposites based on poly(3-hydroxybutyrate-co-3-hydroxyhexanoate) (PHBH) and aloe vera bio-fibers incorporated at 20 wt%. The fiber surface was modified with alkaline, organosilanes, and combined alkaline/organosilanes. Surface morphology, thermal stability, water absorption capacity, and rheological behavior of the modified biocomposite materials were studied, and the results compared to both unmodified biocomposites and neat PHBH. The study showed that the modified biocomposites with both alkaline and organosilanes exhibited an improved surface morphology, resulting in a good fiber/matrix interfacial adhesion. As a result, increases in complex viscosity, storage modulus, and loss modulus were observed, whereas water absorption was reduced. Thermal stability remained almost unchanged, with the exception of the biocomposite treated with alkaline, where this property decreased significantly. Finally, the coupling of alkaline and organosilane modification is an efficient route to enhance the properties of PHBH biocomposites.


Sign in / Sign up

Export Citation Format

Share Document