Characterization and Wave Motion Simulations of MEMS Inertial Sensors using 6DOF Platform

2019 ◽  
Author(s):  
Luiz Felipe M. V. Moraes ◽  
Fabio N. Carvalho ◽  
Henrique P. P. Pereira
Keyword(s):  
Wave Motion ◽  
Inertial Sensors

Deadlift Recognition and Application based on Multiple Modalities using Recurrent Neural Network

2020 ◽  
Vol 2020 (17) ◽  
pp. 2-1-2-6
Author(s):  
Shih-Wei Sun ◽  
Ting-Chen Mou ◽  
Pao-Chi Chang
Keyword(s):  
Neural Network ◽  
Recurrent Neural Network ◽  
Network Structure ◽  
Inertial Sensors ◽  
Body Movement ◽  
The Body ◽  
Body Parts ◽  
Multimodal Sensing ◽  
Multiple Devices ◽  
Neural Network Structure

To improve the workout efficiency and to provide the body movement suggestions to users in a “smart gym” environment, we propose to use a depth camera for capturing a user’s body parts and mount multiple inertial sensors on the body parts of a user to generate deadlift behavior models generated by a recurrent neural network structure. The contribution of this paper is trifold: 1) The multimodal sensing signals obtained from multiple devices are fused for generating the deadlift behavior classifiers, 2) the recurrent neural network structure can analyze the information from the synchronized skeletal and inertial sensing data, and 3) a Vaplab dataset is generated for evaluating the deadlift behaviors recognizing capability in the proposed method.

A Preliminary Framework and Feasibility Study for Spacecraft Disturbance Source Detection and Isolation with Distributed Inertial Sensors

2021 ◽  
Author(s):  
Adam Augustyniak ◽  
David J. Hanley ◽  
Timothy W. Bretl ◽  
Neil J. Hejmanowski ◽  
David L. Carroll
Keyword(s):  
Feasibility Study ◽  
Inertial Sensors ◽  
Source Detection ◽  
Disturbance Source

A ROOM ACOUSTIC SIMULATION SYSTEM CONSIDERED WAVE MOTION CHARACTERISTIC

1996 ◽  
Vol 2 (2) ◽  
pp. 121-126 ◽  
Author(s):  
Masayoshi TSUBOI ◽  
Mitstoshi WATANABE ◽  
Shigeru HIRANO
Keyword(s):  
Wave Motion ◽  
Simulation System ◽  
Acoustic Simulation ◽  
Motion Characteristic

ИССЛЕДОВАНИЯ АКУСТИЧЕСКИХ ХАРАКТЕРИСТИК ВЕРХНЕГО СЛОЯ МОРЯ МЕТОДОМ МНОГОЧАСТОТНОГО АКУСТИЧЕСКОГО ЗОНДИРОВАНИЯ

2020 ◽  
Author(s):  
V.A. Bulanov ◽  
I.V. Korskov ◽  
A.V. Storozhenko ◽  
S.N. Sosedko
Keyword(s):  
High Frequency ◽  
Wave Motion ◽  
High Spatial Resolution ◽  
Wind Waves ◽  
Acoustic Parameter ◽  
Sea Surface ◽  
Near Surface ◽  
Acoustical Properties ◽  
Acoustic Spectroscopy ◽  
Sea Bottom

Описано применение акустического зондирования для исследования акустических характеристик верхнего слоя моря с использованием широкополосных остронаправленных инвертированных излучателей,устанавливаемых на дно. В основу метода положен принцип регистрации обратного рассеяния и отраженияот поверхности моря акустических импульсов с различной частотой, позволяющий одновременно измерятьрассеяние и поглощение звука и нелинейный акустический параметр морской воды. Многочастотное зондирование позволяет реализовать акустическую спектроскопию пузырьков в приповерхностных слоях моря,проводить оценку газосодержания и получать данные о спектре поверхностного волнения при различных состояниях моря вплоть до штормовых. Применение остронаправленных высокочастотных пучков ультразвукапозволяет разделить информацию о планктоне и пузырьках и определить с высоким пространственным разрешением структуру пузырьковых облаков, образующихся при обрушении ветровых волн, и структуру планктонных сообществ. Участие планктона в волновом движении в толще морской воды позволяет определитьпараметры внутренних волн спектр и распределение по амплитудам в различное время.This paper represents the application of acoustic probingfor the investigation of acoustical properties of the upperlayer of the sea using broadband narrow-beam invertedtransducers that are mounted on the sea bottom. Thismethod is based on the principle of the recording of thebackscattering and reflections of acoustic pulses of differentfrequencies from the sea surface. That simultaneouslyallows measuring scattering and absorption of the soundand non-linear acoustic parameter of seawater. Multifrequencyprobing allows performing acoustic spectroscopy ofbubbles in the near-surface layer of the sea, estimating gascontent, and obtaining data on the spectrum of the surfacewaves in various states of the sea up to a storm. Utilizationof the high-frequency narrow ultrasound beams allows us toseparate the information about plankton and bubbles and todetermine the structure of bubble clouds, created during thebreaking of wind waves, along with the structure of planktoncommunities with high spatial resolution. The participationof plankton in the wave motion in the seawater columnallows determining parameters of internal waves, such asspectrum and distribution of amplitudes at different times.

Density Wave Measurements in a Rectangular Clarifier

1983 ◽  
Vol 18 (1) ◽  
pp. 129-150 ◽  
Author(s):  
Mark K. Watson ◽  
R.R. Hudgins ◽  
P.L. Silveston
Keyword(s):  
Power Spectrum ◽  
Internal Wave ◽  
Internal Waves ◽  
Wave Motion ◽  
Wave Amplitude ◽  
Suspended Solids ◽  
Small Volume ◽  
Density Wave ◽  
Measure Concentration ◽  
Wave Measurements

Abstract Internal wave motion was studied in a laboratory rectangular, primary clarifier. A photo-extinction device was used as a turbidimeter to measure concentration fluctuations in a small volume within the clarifier as a function of time. The signal from this device was fed to a HP21MX minicomputer and the power spectrum plotted from data records lasting approximately 30 min. Results show large changes of wave amplitude as frequency increases. Two distinct regions occur: one with high amplitudes at frequencies below 0.03 Hz, the second with very small amplitudes appears for frequencies greater than 0.1 Hz. The former is associated with internal waves, the latter with flow-generated turbulence. Depth, velocity in the clarifier and inlet suspended solids influence wave amplitudes and the spectra. A variation with position or orientation of the probe was not detected. Contradictory results were found for the influence of flow contraction baffles on internal wave amplitude.

scholarly journals Wearable Technologies in Field Hockey Competitions: A Scoping Review

Sensors ◽  
2021 ◽  
Vol 21 (15) ◽  
pp. 5242
Author(s):  
Jolene Ziyuan Lim ◽  
Alexiaa Sim ◽  
Pui Wah Kong
Keyword(s):  
Heart Rate ◽  
Inertial Sensors ◽  
Wearable Devices ◽  
Field Hockey ◽  
Heart Rate Monitors ◽  
Search Terms ◽  
Physiological Demands ◽  
And Performance ◽  
Future Work ◽  
Skin Temperatures

The aim of this review is to investigate the common wearable devices currently used in field hockey competitions, and to understand the hockey-specific parameters these devices measure. A systematic search was conducted by using three electronic databases and search terms that included field hockey, wearables, accelerometers, inertial sensors, global positioning system (GPS), heart rate monitors, load, performance analysis, player activity profiles, and competitions from the earliest record. The review included 39 studies that used wearable devices during competitions. GPS units were found to be the most common wearable in elite field hockey competitions, followed by heart rate monitors. Wearables in field hockey are mostly used to measure player activity profiles and physiological demands. Inconsistencies in sampling rates and performance bands make comparisons between studies challenging. Nonetheless, this review demonstrated that wearable devices are being used for various applications in field hockey. Researchers, engineers, coaches, and sport scientists can consider using GPS units of higher sampling rates, as well as including additional variables such as skin temperatures and injury associations, to provide a more thorough evaluation of players’ physical and physiological performances. Future work should include goalkeepers and non-elite players who are less studied in the current literature.

scholarly journals A Piezoelectric Wave-Energy Converter Equipped with a Geared-Linkage-Based Frequency Up-Conversion Mechanism

Sensors ◽  
2020 ◽  
Vol 21 (1) ◽  
pp. 204
Author(s):  
Shao-En Chen ◽  
Ray-Yeng Yang ◽  
Guang-Kai Wu ◽  
Chia-Che Wu
Keyword(s):  
Power Generation ◽  
Wave Energy ◽  
Wave Motion ◽  
Wave Energy Converter ◽  
Gear Train ◽  
Piezoelectric Composite ◽  
Maximum Height ◽  
Resistive Load ◽  
Linkage Mechanism ◽  
Energy Converter

In this paper, a piezoelectric wave-energy converter (PWEC), consisting of a buoy, a frequency up-conversion mechanism, and a piezoelectric power-generator component, is developed. The frequency up-conversion mechanism consists of a gear train and geared-linkage mechanism, which converted lower frequencies of wave motion into higher frequencies of mechanical motion. The slider had a six-period displacement compared to the wave motion and was used to excite the piezoelectric power-generation component. Therefore, the operating frequency of the piezoelectric power-generation component was six times the frequency of the wave motion. The developed, flexible piezoelectric composite films of the generator component were used to generate electrical voltage. The piezoelectric film was composed of a copper/nickel foil as the substrate, lead–zirconium–titanium (PZT) material as the piezoelectric layer, and silver material as an upper-electrode layer. The sol-gel process was used to fabricate the PZT layer. The developed PWEC was tested in the wave flume at the Tainan Hydraulics Laboratory, Taiwan (THL). The maximum height and the minimum period were set to 100 mm and 1 s, respectively. The maximum voltage of the measured value was 2.8 V. The root-mean-square (RMS) voltage was 824 mV, which was measured through connection to an external 495 kΩ resistive load. The average electric power was 1.37 μW.

Sign in / Sign up

Export Citation Format

Share Document