New low cost structure for dual axis mount solar tracking system using adaptive solar sensor

Author(s):  
Alin Argeseanu ◽  
Ewen Ritchie ◽  
Krisztina Leban
2020 ◽  
Vol 15 (4) ◽  
pp. 613-619
Author(s):  
Li Kong ◽  
Yunpeng Zhang ◽  
Zhijian Lin ◽  
Zhongzhu Qiu ◽  
Chunying Li ◽  
...  

Abstract The present work aimed to select the optimum solar tracking mode for parabolic trough concentrating collectors using numerical simulation. The current work involved: (1) the calculation of daily solar radiation on the Earth’s surface, (2) the comparison of annual direct solar radiation received under different tracking modes and (3) the determination of optimum tilt angle for the north-south tilt tracking mode. It was found that the order of solar radiation received in Shanghai under the available tracking modes was: dual-axis tracking > north-south Earth’s axis tracking > north-south tilt tracking (β = 15°) > north-south tilt tracking (β = 45) > north-south horizontal tracking > east-west horizontal tracking. Single-axis solar tracking modes feature simple structures and low cost. This study also found that the solar radiation received under the north-south tilt tracking mode was higher than that of the north-south Earth’s axis tracking mode in 7 out of 12 months. Therefore, the north-south tilt tracking mode was studied separately to determine the corresponding optimum tilt angles in Haikou, Lhasa, Shanghai, Beijing and Hohhot, respectively, which were shown as follows: 18.81°, 27.29°, 28.67°, 36.21° and 37.97°.


Author(s):  
Sohaib R Awad ◽  
Mamoon A Al Jbaar ◽  
Mohammed A M Abdullah

2020 ◽  
Author(s):  
Orlando Soares de Santana Filho ◽  
Carlos Henrique Mota Martins ◽  
Thiago Henrique Felix C. Ribeiro Conceição ◽  
Alex Vinicius dos Reis Freitas Silva ◽  
Adriano Honorato Braga ◽  
...  

Solar energy is a renewable and inexhaustible source, besidescausing damage to nature, being clean and sustainable.Transform the electromagnetic radiation emitted by the Sunelectrical energy are used solar panels. In order to improveefficiency and performance of this capture, a low-cost wasbuilt, a single-axis solar tracking system for photovoltaicpanels. The solution uses the automation Arduino UNO R3,open hardware, two photosensitive sensors LDR GL-5528, inaddition to a servo motor capable of moving the surface of aphotovoltaic plate according to the detection of the highestincidence of light. The circuit and its components wereprogrammed using the Arduino IDE software, version 1.8.11.As a result, it was possible to follow the movement of thesun, differing from a static panel, thus ensuring greater sunshineon the solar plate, as a result of this traceablecontrol prototype.


2021 ◽  
pp. 193-204
Author(s):  
Marie Pascaline Sarr ◽  
Ababacar Thiam ◽  
Biram Dieng ◽  
El Hadji Ibrahima Cisse

Author(s):  
Anees Abu Sneineh ◽  
Wael A. Salah

This paper presents the design and implementation of a closed-loop solar tracker system. The demand for clean energy sources has increased along with the rising demand for electrical energy and the increasing amount of environment pollution triggered by fuel consumption. Among these sources, solar energy is considered the most feasible given its wide availability and easy operation in different environments. The main purpose of this study is to maximize the generated photovoltaic power and reduce CO<sub>2</sub> emissions by designing an efficient and low-cost solar tracking system. An aligned closed-loop solar tracker is designed and constructed to achieve the best accuracy. The proposed system shows more freedom in its movement to overcome the problems associated with the tilt of the frame-holder. A PIC microcontroller based on the Flowcode programming language is used, the position feedback is detected by using a photo-sensor, and the H-Bridge driver is used to control two DC motors. According to the experimental results, the proposed system shows significant improvements in efficiency compared with stationary solar tracking systems.


Author(s):  
Hachimenum Nyebuchi Amadi ◽  
Sebastian Gutierrez

Most rural dwellers in developing countries do not have access to adequate and regular supply of energy and most of these estimated two billion people are poor with no sustainable means of livelihood and therefore rely on wood fuel for their cooking and heating needs. And due to lack of energy, including electricity, socio-economic development is either absent or at abysmally low level. To foster rural development and improved living conditions among this populace, there is need for a reliable, low cost and environmentally risk-free source of energy. This work designed, implemented and evaluated the performance of a dual axis solar tracking system (DATS) using light dependent resistor (LDR) sensors, direct current (DC) motors and microcontroller to make it capable of uninterruptible electricity supply for rural applications. Results of the experiment show that the proposed system is more cost-effective and produces 31.4 % more energy than the single axis tracking system (SATS) and 67.9 % more than the fixed PV panel system (FPPS). Owing to the unique design of the proposed tracking system, solar energy can be tracked and stored continuously so that there is adequate electricity for the consuming population at all times. Though tested on a rural community in Abia State, Nigeria, the proposed system can be adapted to rural communities anywhere in the world.  


2020 ◽  
Vol 37 ◽  
pp. 100618 ◽  
Author(s):  
Chaowanan Jamroen ◽  
Preecha Komkum ◽  
Sompol Kohsri ◽  
Wuttinan Himananto ◽  
Siriwat Panupintu ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document