scholarly journals Optimal design of the solar tracking system of parabolic trough concentrating collectors

2020 ◽  
Vol 15 (4) ◽  
pp. 613-619
Author(s):  
Li Kong ◽  
Yunpeng Zhang ◽  
Zhijian Lin ◽  
Zhongzhu Qiu ◽  
Chunying Li ◽  
...  
Keyword(s):  
Numerical Simulation ◽  
Solar Radiation ◽  
Tracking System ◽  
Low Cost ◽  
Parabolic Trough ◽  
The North ◽  
Tracking Mode ◽  
Solar Tracking ◽  
East West

Abstract The present work aimed to select the optimum solar tracking mode for parabolic trough concentrating collectors using numerical simulation. The current work involved: (1) the calculation of daily solar radiation on the Earth’s surface, (2) the comparison of annual direct solar radiation received under different tracking modes and (3) the determination of optimum tilt angle for the north-south tilt tracking mode. It was found that the order of solar radiation received in Shanghai under the available tracking modes was: dual-axis tracking > north-south Earth’s axis tracking > north-south tilt tracking (β = 15°) > north-south tilt tracking (β = 45) > north-south horizontal tracking > east-west horizontal tracking. Single-axis solar tracking modes feature simple structures and low cost. This study also found that the solar radiation received under the north-south tilt tracking mode was higher than that of the north-south Earth’s axis tracking mode in 7 out of 12 months. Therefore, the north-south tilt tracking mode was studied separately to determine the corresponding optimum tilt angles in Haikou, Lhasa, Shanghai, Beijing and Hohhot, respectively, which were shown as follows: 18.81°, 27.29°, 28.67°, 36.21° and 37.97°.

Optical Analysis of a Heliostat Array With Linked Tracking

2013 ◽  
Vol 135 (3) ◽  
Author(s):  
M. T. Dunham ◽  
R. Kasetty ◽  
A. Mathur ◽  
W. Lipiński
Keyword(s):  
Concentration Ratio ◽  
Tracking System ◽  
Average Concentration ◽  
Solar Concentrator ◽  
Optical Performance ◽  
Optical Analysis ◽  
Optical Efficiency ◽  
The North ◽  
The Individual ◽  
East West

The optical performance of a novel solar concentrator consisting of a 400 spherical heliostat array and a linked two-axis tracking system is analyzed using the Monte Carlo ray-tracing technique. The optical efficiency and concentration ratio are compared for four different heliostat linkage configurations, including linkages of 1 × 1, 1 × 2, 2 × 2, 4 × 4, and 5 × 5 heliostats for 7-hour operation and the selected months of June and December. The optical performance of the concentrator decreases with the increasing number of heliostats in the individual groups due to increasing optical inaccuracies. In June, the best-performing linked configuration, in which 1 heliostat in the east-west direction and 2 heliostats in the north-south direction are linked, provides a monthly-averaged 7-hour optical efficiency and average concentration ratio of 79% and 511 suns, respectively. In December, the optical efficiency and the average concentration ratio decreases to 61% and 315 suns, respectively.

scholarly journals Efficient and Low-Cost Arduino based Solar Tracking System

2020 ◽  
Vol 745 ◽  
pp. 012016
Author(s):  
Sohaib R Awad ◽  
Mamoon A Al Jbaar ◽  
Mohammed A M Abdullah
Keyword(s):  
Tracking System ◽  
Low Cost ◽  
Solar Tracking

Assessment of the Energy Gain of Photovoltaic Systems by Using Solar Tracking in Equatorial Regions

2018 ◽  
Vol 140 (3) ◽  
Author(s):  
Freddy Ordóñez ◽  
Carlos Morales ◽  
Jesús López-Villada ◽  
Santiago Vaca
Keyword(s):  
Tracking System ◽  
Solar Irradiation ◽  
Pv Systems ◽  
Pv Array ◽  
Solar Arrays ◽  
The North ◽  
Operation Conditions ◽  
Solar Tracking ◽  
The One ◽  
The Impact

Solar tracking is a major alternative to increase the electric output of a photovoltaic (PV) module, and therefore, improves the global energy collected by PV systems. Nonetheless, solar-tracking PV systems require more resources and energy than static systems. Additionally, the presence of cloudiness and shadows from near buildings may reduce the profitability of these systems. Therefore, their feasibility must be assessed in order to justify their application. In equatorial latitudes, the sun's movement through the sky is in the zenith East–West axis. It may be advantageous, since the best tilt in such latitudes is the horizontal. In these terms, the main objective of this research is to numerically assess the performance of a PV array with solar tracking and under typical operation conditions in equatorial latitudes. For this, the assessment of the solar resource in Quito was analyzed in first place. Then, the comparison between three solar arrays was studied to evaluate the feasibility of solar tracking (two-axes tracking, horizontal one-axis tracking, and horizontal fixed). Additionally, the impact of cloudiness and shadows in the system was analyzed. The results showed that the horizontal one-axis tracking is the most beneficial option for equatorial latitudes as the two-axes tracking system only surpasses the gains of the one-axis tracking marginally. Furthermore, the use of a strategy to place the PV modules horizontally in cloudy conditions seems to be marginally advantageous. Finally, the shadows created from neighboring buildings in the East and West of the system may reduce considerably the solar irradiation on the PV-array (not the ones in the north and south).

scholarly journals Desenvolvimento de um Protótipo Automatizado de Detecção e Focalização de Raios Solares com Hardware Livre

2020 ◽  
Author(s):  
Orlando Soares de Santana Filho ◽  
Carlos Henrique Mota Martins ◽  
Thiago Henrique Felix C. Ribeiro Conceição ◽  
Alex Vinicius dos Reis Freitas Silva ◽  
Adriano Honorato Braga ◽  
...  
Keyword(s):  
Solar Energy ◽  
Electromagnetic Radiation ◽  
Tracking System ◽  
Low Cost ◽  
Servo Motor ◽  
Solar Panels ◽  
Open Hardware ◽  
Solar Tracking ◽  
Arduino Uno ◽  
And Performance

Solar energy is a renewable and inexhaustible source, besidescausing damage to nature, being clean and sustainable.Transform the electromagnetic radiation emitted by the Sunelectrical energy are used solar panels. In order to improveefficiency and performance of this capture, a low-cost wasbuilt, a single-axis solar tracking system for photovoltaicpanels. The solution uses the automation Arduino UNO R3,open hardware, two photosensitive sensors LDR GL-5528, inaddition to a servo motor capable of moving the surface of aphotovoltaic plate according to the detection of the highestincidence of light. The circuit and its components wereprogrammed using the Arduino IDE software, version 1.8.11.As a result, it was possible to follow the movement of thesun, differing from a static panel, thus ensuring greater sunshineon the solar plate, as a result of this traceablecontrol prototype.

Output Power Enhancement of Solar PV Panel Using Solar Tracking System

2019 ◽  
Vol 12 (1) ◽  
pp. 45-49
Author(s):  
Abhishek Kumar Tripathi ◽  
Mangalpady Aruna ◽  
Ch. S.N. Murthy
Keyword(s):  
Solar Radiation ◽  
Output Power ◽  
Tracking System ◽  
The Sun ◽  
Solar Pv ◽  
Design Development ◽  
Pv Panel ◽  
Solar Tracking ◽  
Power Enhancement ◽  
Panel Surface

Solar Photovoltaic (PV) energy conversion has gained much attention nowadays. The output power of PV panel depends on the condition under which the panel is working, such as solar radiation, ambient temperature, dust, wind speed and humidity. The amount of falling sunlight on the panel surface (i.e., solar radiation) directly affects its output power. In order to maximize the amount of falling sunlight on the panel surface, a solar tracking PV panel system is introduced. This paper describes the design, development and fabrication of the solar PV panel tracking system. The designed solar tracking system is able to track the position of the sun throughout the day, which allows more sunlight falling on the panel surface. The experimental results show that there was an enhancement of up to a 64.72% in the output power of the PV panel with reference to the fixed orientation PV panel. Further, this study also demonstrates that the full load torque of the tracking system would be much higher than the obtained torque, which is required to track the position of the sun. This propounds, that the proposed tracking system can also be used for a higher capacity PV power generation system.

Design and Implementation of a Low-Cost Mini Heliostat Solar Tracking System in West Africa

2021 ◽  
pp. 193-204
Author(s):  
Marie Pascaline Sarr ◽  
Ababacar Thiam ◽  
Biram Dieng ◽  
El Hadji Ibrahima Cisse
Keyword(s):  
West Africa ◽  
Tracking System ◽  
Low Cost ◽  
Design And Implementation ◽  
Solar Tracking

scholarly journals Design and implementation of an automatically aligned solar tracking system

2019 ◽  
Vol 10 (4) ◽  
pp. 2055
Author(s):  
Anees Abu Sneineh ◽  
Wael A. Salah
Keyword(s):  
Closed Loop ◽  
Tracking System ◽  
Low Cost ◽  
Electrical Energy ◽  
Clean Energy ◽  
Design And Implementation ◽  
Solar Tracking ◽  
Photo Sensor ◽  
Wide Availability ◽  
Solar Tracker

This paper presents the design and implementation of a closed-loop solar tracker system. The demand for clean energy sources has increased along with the rising demand for electrical energy and the increasing amount of environment pollution triggered by fuel consumption. Among these sources, solar energy is considered the most feasible given its wide availability and easy operation in different environments. The main purpose of this study is to maximize the generated photovoltaic power and reduce CO<sub>2</sub> emissions by designing an efficient and low-cost solar tracking system. An aligned closed-loop solar tracker is designed and constructed to achieve the best accuracy. The proposed system shows more freedom in its movement to overcome the problems associated with the tilt of the frame-holder. A PIC microcontroller based on the Flowcode programming language is used, the position feedback is detected by using a photo-sensor, and the H-Bridge driver is used to control two DC motors. According to the experimental results, the proposed system shows significant improvements in efficiency compared with stationary solar tracking systems.

scholarly journals Design and Performance Evaluation of a Dual-Axis Solar Tracking System for Rural Applications

2019 ◽  
Vol 3 (1) ◽  
Author(s):  
Hachimenum Nyebuchi Amadi ◽  
Sebastian Gutierrez
Keyword(s):  
Rural Communities ◽  
Rural Community ◽  
Tracking System ◽  
Low Cost ◽  
Cost Effective ◽  
Pv Panel ◽  
Dc Motors ◽  
Solar Tracking ◽  
And Performance ◽  
Rural Dwellers

Most rural dwellers in developing countries do not have access to adequate and regular supply of energy and most of these estimated two billion people are poor with no sustainable means of livelihood and therefore rely on wood fuel for their cooking and heating needs. And due to lack of energy, including electricity, socio-economic development is either absent or at abysmally low level. To foster rural development and improved living conditions among this populace, there is need for a reliable, low cost and environmentally risk-free source of energy. This work designed, implemented and evaluated the performance of a dual axis solar tracking system (DATS) using light dependent resistor (LDR) sensors, direct current (DC) motors and microcontroller to make it capable of uninterruptible electricity supply for rural applications. Results of the experiment show that the proposed system is more cost-effective and produces 31.4 % more energy than the single axis tracking system (SATS) and 67.9 % more than the fixed PV panel system (FPPS). Owing to the unique design of the proposed tracking system, solar energy can be tracked and stored continuously so that there is adequate electricity for the consuming population at all times. Though tested on a rural community in Abia State, Nigeria, the proposed system can be adapted to rural communities anywhere in the world.  

Sign in / Sign up

Export Citation Format

Share Document