Thermo-Chemical Treatment of Structural Steels in Different Types of Discharge

2021 ◽  
Author(s):  
A. S. Sergeeva ◽  
L. G. Petrova ◽  
V. M. Vdovin
Keyword(s):  
Chemical Treatment ◽  
Structural Steels ◽  
Different Types

scholarly journals Effects of cropping system and genotype on variability in important phytonutrients kontent of the barley grain for direct food use

2011 ◽  
Vol 49 (No. 10) ◽  
pp. 443-450 ◽  
Author(s):  
J. Ehrenbergerová ◽  
K. Vaculová ◽  
V. Psota ◽  
P. Havlová ◽  
V. Šerhantová
Keyword(s):  
Chemical Treatment ◽  
Cropping Systems ◽  
Starch Content ◽  
Cropping System ◽  
Barley Grain ◽  
Beta Glucan ◽  
Beta Glucans ◽  
Different Types ◽  
The Mean ◽  
Starch Composition

In a four-year period (1997–2000), selected phytonutrients, of which the beta-glucan content is most important for human health, were studied in caryopses of different types of barley varieties and lines (standard, waxy, hulless) from two cropping systems. It was significantly highest in the waxy variety Washonubet (4.93%). The whole group of waxy types of barley showed a significantly higher mean content of beta-glucans (4.75%) than the varieties with standard starch composition (4.12%), the starch content, however, was significantly higher in standard varieties (61.98%) than in waxy types (60.30%). The hulless varieties, however, had a significantly higher mean starch content (61.73%) than the hulled forms (61.07%) and a significantly higher protein content (13.82% versus 13.00%). The hulless intensive varieties and lines had a significantly higher content of beta-glucans (4.34%) and protein (13.95%) than the hulled intensive varieties (4.07%, 12.65%). Chemical treatment and fertilization increased significantly only the mean content of protein in caryopses (13.77%) compared to the variants with the absence of treatment (13.13%), the content of beta-glucans and starch increased insignificantly (by 0.12% and 0.27%). Years and varieties participated most in the variability of starch content (31.67%, 28.08%), varieties in the content of beta-glucans and protein (per 22%), and (21%) the interaction of varieties and years in the variability of these two nutrients.

scholarly journals Sexual and Asexual Propagation of Teucrium brevifolium

2018 ◽  
Vol 75 (2) ◽  
Author(s):  
Anastasia AKOUMIANAKI–IOANNIDOU ◽  
Aikaterini GERASIMIDOU ◽  
Alexandra SALTA
Keyword(s):  
Seed Germination ◽  
Medicinal Plant ◽  
Chemical Treatment ◽  
Stem Cuttings ◽  
Asexual Propagation ◽  
Different Types

The propagation with seeds and stem cuttings of Teucrium brevifolium were investigated in order to facilitate the use of the species in floricultural practice and as a medicinal plant. The seeds after they subjected to different types of treatments (dipping in H2SO4 for 15 min or in H2SO4 for 15 min and GA3 1000 mg l-1 for 10 min, 24 or 48h and untreated) cultured for germination in vitro at 5, 10, 15, 20, 25, and 30 °C. The cuttings were planted in a peat/perlite mixture 1:1 v/v in plastic square plug trays in order to study the rooting percentage. Seed germination was very low (2%) at temperatures of 15-25 °C, while chemical treatment with the concentrated H2SO4 for 15 min, increased germination to 8-10% at the same temperatures. Asexual propagation of the species resulted in a 52.5-61.5% rooting percentage, in all seasons except winter. Treatment with IBA 2000 mg l-1 increaseds rooting percentage.

Experiments to determine the relative Toxicity of Ammonium Chloro-acetate and related Chemicals to the Potato Eelworm (Heterodera schachtii)

1938 ◽  
Vol 16 (3) ◽  
pp. 177-180 ◽  
Author(s):  
Enid M. Smedley
Keyword(s):  
Acetic Acid ◽  
Pest Control ◽  
Chemical Treatment ◽  
Water Soluble ◽  
Heterodera Schachtii ◽  
Relative Toxicity ◽  
Different Types

Since 1935 a large number of chemicals including chloro-acetic acid and various water-soluble chloro-acetates, received from the Pest Control Committee of Imperial Chemical Industries, have been tested for their value in controlling the potato strain of Heterodera schachtii under the direction of Prof. R. T. Leiper, F.R.S.Soils from Yorkshire and Ayrshire were used in the experiments, as they are of very different types, and might conceivably respond differently to chemical treatment.

WEAR RESISTANCE CHARACTERISTICS OF THERMO-CHEMICALLY TREATED STRUCTURAL STEELS

Tribologia ◽  
2018 ◽  
Vol 273 (3) ◽  
pp. 171-178 ◽  
Author(s):  
Jan SENATORSKI ◽  
Jan TACIKOWSKI ◽  
Paweł MĄCZYŃSKI
Keyword(s):  
Wear Resistance ◽  
Chemical Treatment ◽  
Precipitation Hardening ◽  
Structural Steels ◽  
Wear Properties ◽  
Diffusion Layers ◽  
Surface Unit ◽  
Chemically Treated ◽  
Unit Loading

The article presents results of investigations of wear resistance by friction, employing the “3 cylinder – cone” method, of selected structural steels subjected to given thermo-chemical treatment, i.e. nitriding, carburizing, and precipitation hardening after nitriding. The investigated steels were C45, 21NiCrMo2, 18HGT, and 41Cr4. These materials, after thermo-chemical treatment undergo metallurgical characteristics of diffusion layers formed on steel. It was observed that proportionality exists between their wear resistance and the value of surface unit loading. Moreover, the friction – wear properties of these layers exhibited certain differences, depending on their microstructure and chemistry.

Paramagnetic Defects in Undoped Microcrystalline Silicon Deposited by the Hot-Wire Technique

1998 ◽  
Vol 507 ◽  
Author(s):  
P. Kanschat ◽  
K. Lips ◽  
R. Brüggemann ◽  
A. Hierzenberger ◽  
I. Sieber ◽  
...  
Keyword(s):  
Chemical Treatment ◽  
Defect Density ◽  
The Other ◽  
Donor Concentration ◽  
Dangling Bond ◽  
Hot Wire ◽  
Microcrystalline Silicon ◽  
Hydrogen Dilution ◽  
Different Types ◽  
Wet Chemical

ABSTRACTWe report on a study of ESR and conductivity on a series of hot-wire CVD microcrystalline silicon samples prepared with different hydrogen dilution of silane. We observe two different types of dangling bond defects in ESR in different microscopic environments. One type of defect is located at outer surfaces accessible to oxygen and/or chemicals, the other is located at inner boundaries presumably at columnar structures. We correlate changes of the defect density induced by either annealing, exposure to air or wet-chemical treatment with the morphology and electronic properties of the films. We find that annealing at 200 °C induces irreversible changes in donor concentration as monitored by an ESR signal at g = 1.9981±3.

The extinction time of a general birth and death process with catastrophes

1986 ◽  
Vol 23 (04) ◽  
pp. 851-858 ◽  
Author(s):  
P. J. Brockwell
Keyword(s):  
Laplace Transform ◽  
Size Distribution ◽  
Sufficient Conditions ◽  
Necessary And Sufficient Conditions ◽  
Death Process ◽  
Extinction Time ◽  
Birth And Death Process ◽  
Different Types ◽  
The Laplace Transform ◽  
Necessary And Sufficient

The Laplace transform of the extinction time is determined for a general birth and death process with arbitrary catastrophe rate and catastrophe size distribution. It is assumed only that the birth rates satisfyλ0= 0,λj> 0 for eachj> 0, and. Necessary and sufficient conditions for certain extinction of the population are derived. The results are applied to the linear birth and death process (λj=jλ, µj=jμ) with catastrophes of several different types.

Differentiating between different forms of moral obligations

2020 ◽  
Vol 43 ◽  
Author(s):  
Rajen A. Anderson ◽  
Benjamin C. Ruisch ◽  
David A. Pizarro
Keyword(s):  
Moral Character ◽  
Moral Obligations ◽  
Different Types

Abstract We argue that Tomasello's account overlooks important psychological distinctions between how humans judge different types of moral obligations, such as prescriptive obligations (i.e., what one should do) and proscriptive obligations (i.e., what one should not do). Specifically, evaluating these different types of obligations rests on different psychological inputs and has distinct downstream consequences for judgments of moral character.

Ultrastructural Investigations of the Contractile Filaments of Amoebae

1974 ◽  
Vol 32 ◽  
pp. 188-189
Author(s):  
P.L. Moore
Keyword(s):  
Cytoplasmic Streaming ◽  
Three Dimensional ◽  
Freeze Fracture ◽  
Amoeboid Movement ◽  
Different Types ◽  
Chemical Conditions ◽  
Complete Interpretation

Previous freeze fracture results on the intact giant, amoeba Chaos carolinensis indicated the presence of a fibrillar arrangement of filaments within the cytoplasm. A complete interpretation of the three dimensional ultrastructure of these structures, and their possible role in amoeboid movement was not possible, since comparable results could not be obtained with conventional fixation of intact amoebae. Progress in interpreting the freeze fracture images of amoebae required a more thorough understanding of the different types of filaments present in amoebae, and of the ways in which they could be organized while remaining functional.The recent development of a calcium sensitive, demembranated, amoeboid model of Chaos carolinensis has made it possible to achieve a better understanding of such functional arrangements of amoeboid filaments. In these models the motility of demembranated cytoplasm can be controlled in vitro, and the chemical conditions necessary for contractility, and cytoplasmic streaming can be investigated. It is clear from these studies that “fibrils” exist in amoeboid models, and that they are capable of contracting along their length under conditions similar to those which cause contraction in vertebrate muscles.

Study of the Molecular Architecture of Keratin Filaments by Electron Microscopy

1982 ◽  
Vol 40 ◽  
pp. 118-119
Author(s):  
U. Aebi ◽  
P. Rew ◽  
T.-T. Sun
Keyword(s):  
Electron Microscopy ◽  
Structural Organization ◽  
Cell Types ◽  
Structural Features ◽  
Molecular Architecture ◽  
The Past ◽  
Keratin Filaments ◽  
Different Types ◽  
10 Nm Filaments ◽  
Different Cell Types

Various types of intermediate-sized (10-nm) filaments have been found and described in many different cell types during the past few years. Despite the differences in the chemical composition among the different types of filaments, they all yield common structural features: they are usually up to several microns long and have a diameter of 7 to 10 nm; there is evidence that they are made of several 2 to 3.5 nm wide protofilaments which are helically wound around each other; the secondary structure of the polypeptides constituting the filaments is rich in ∞-helix. However a detailed description of their structural organization is lacking to date.

Sign in / Sign up

Export Citation Format

Share Document