Wave Flume Tests to Check a Semi-Analytical Method for Calculating Solitary Wave Loads on Horizontal Cylinders

Author(s):  
Pasquale Filianoti ◽  
Luana Gurnari ◽  
Francesco Aristodemo ◽  
Giuseppe Tripepi

In this work, the solitary wave loads on a submerged horizontal circular cylinder are studied by comparing new analytical results with ad-hoc experimental data. The proposed analytical solution has been recently proposed by Gurnari and Filianoti (2017) and represents an extension of the formulation developed by Filianoti and Piscopo (2008) to assess the solitary wave loads acting on a submerged breakwater and tested in a wave flume on a small-scale model (Filianoti and Di Risio, 2012). Here we deal with a submerged horizontal cylinder following the concept that a solitary wave is subjected to a slowdown passing over a submerged cylinder. A laboratory investigation was addressed to calibrate the adopted semi-analytical method. The speed of the solitary wave celerity crossing the solid submerged cylinder was measured for several wave amplitudes. In the adopted wave flume at the University of Calabria equipped by a piston-type wavemaker, an horizontal cylinder with diameter D = 0.127 m was posed with its center at a depth of 0.2 m. Twelve transducers measured the instantaneous pressures along the external contour of the body. A battery of wave gauges measured the free surface elevation to evaluate the celerity crossing the equivalent water cylinder. Tests confirmed the existence of the slowing down of the celerity of the wave pressure. In other words, we found that the pressure wave is nearly double the time necessary to cross the cylinder with respect to the time necessary to cover the same distance in the undisturbed field, for solitary waves amplitudes ranging from about 0.08 and 0.19 times the water depth. The slowing down increases the horizontal wave force on the solid body with respect to the Froude-Krylov one. Moreover, it appears that in the adopted experimental range the wave force is essentially inertial if compared to the drag one, enabling us to rely upon a simplified analytical model to obtain an effective estimate of the horizontal force produced by a solitary wave on a cylinder.

Author(s):  
Lisham Bonakdar ◽  
Hocine Oumeraci

Wave loads on a slender pile within a group of piles are studied by means of (i) large-scale laboratory tests carried out in the Large Wave Flume (GWK) of the Coastal Research Centre (FZK) in Hannover, and (ii) small scale experiments performed in 2 m-wide wave flume of Leichtweiss-Institute for Hydraulic Engineering and Water Resources (LWI), in Braunschweig, Germany. The small scale model tests (LWI) were scaled down (1:6.5) by Froude law from the large scale model tests (GWK). Scale and model effects are examined by comparing the results of small and large scale laboratory tests.


Author(s):  
Luana Gurnari ◽  
Pasquale Filianoti

Several authors have studied the solitary wave load on a submerged horizontal cylinder. In the present work, a semi analytical expression of the horizontal force exerted by a solitary wave on a horizontal cylinder is derived. The formula is based on the speed drop factor ƒr, that is the ratio (greater than one) between the time needed by the wave pressure to cross the solid body and the travel time across a transparent cylinder. The ƒr, is calculated numerically by means of the Boundary Element Method on assuming that a solitary wave and a periodic wave having the same wavelength undergoes the same slowing down. (Clearly the wavelength for the solitary wave is estimated approximately.) Abaci for the ƒr, as a function of the ratio between the diameter and the wavelength, for assigned A/d (= amplitude of the solitary wave / bottom depth) have obtained. In order to check the appropriateness of BEM, we carried out an experiment in a numerical wave flume, using the Computational Fluid Dynamics (CFD) technique.


1989 ◽  
Vol 16 (4) ◽  
pp. 467-476
Author(s):  
Najat Serhir-Taleb ◽  
Claude Marche

Creating, enlarging and excavating a harbour can modify the dynamic response of the basin. A verification of the resonance modes is common practice before undertaking the related work. This can be done numerically if the necessary assumptions are justifiable. It can be done on a small-scale model if the basin has an irregular shape or if the depth varies from one area to the other.A computer-programmed analytical method of resonance modes is presented. It is derived from the direct measure principle of successive oscillation superposition used in the laboratory. Validation is obtained by applying the method to existing theoretical solutions and to the analysis of a small creek of the Gaspe Peninsula where the importance of refraction in the analytical results is demonstrated. Key words: harbour, vibration, agitation, ocean waves, diffraction, refraction, numerical model, application. [Journal translation]


Author(s):  
Josh Davidson ◽  
Rui P. F. Gomes ◽  
Roberto Galeazzi ◽  
João C. C. Henriques

Abstract An active control method, to suppress the onset of pitch/roll parametric resonance on an oscillating water column (OWC) spar buoy, is proposed in this paper, which utilises a pressure relief valve at the top of the OWC air chamber. The paper examines the hypothesis that by opening the relief valve, to reduce the air chamber pressure difference and to decouple the dynamics of the spar buoy and the OWC within, the natural pitch/roll frequencies of the system will be shifted, allowing parametric resonance to be cancelled when its onset is detected. The paper reports on experiments, performed to test the stated hypothesis, with a small-scale model OWC spar buoy in a wave flume. Two configurations are considered and tested in a range of monochromatic waves (1) fully closed air chamber; (2) fully open chamber. The results partially confirm the hypothesis, demonstrating that the occurrence of parametric resonance observed for certain wave frequencies when the chamber is closed does not occur when the chamber is open. However, the change in the natural pitch/roll frequencies between the two configurations is very small, and parametric resonance occurs in both confurations for waves with twice this frequency.


2020 ◽  
Vol 14 (05) ◽  
pp. 2040001
Author(s):  
Qian Wang ◽  
Yong-Liu Fang ◽  
Hua Liu

Physical experiments are conducted to study the interaction between the tsunami-like waves and the horizontal plate. The surface evolution and wave-induced loads are measured to explore the hydrodynamic characteristics when different waves are employed to simulate the tsunami. The solitary wave, surge wave, and undular bore are generated in laboratory as the simplification of the offshore tsunami wave. The bottom-fixed plate places near the free surface. It is found that the elevated plate attenuates the solitary waves locally, while the submerged plate leads to the wave focus phenomenon. The plate has less influence on the surface variation of the surge wave propagating. Results of loads show the different loading process of each tsunami-like wave. The inertial wave force and the local pressure from the rising surface dominate the inline force and vertical force, respectively. The value of loads induced by the surge wave is less than that of the solitary wave. The undular bore is generated by the superimposition of the solitary wave on the surge wave. The part of the solitary wave plays a local role in the wave force, while the surge part dominates the surface evolution.


Author(s):  
Theide Wöffler ◽  
Moritz Kreyenschulte ◽  
Jan Oetjen ◽  
Klemens Uliczka ◽  
Holger Schüttrumpf

During the last years, an increased amount of damage has been observed on estuarine and riverine waterway structures such as groins or training walls in tidal waterways. The cause of these damages could be attributed to ship-induced long-periodic waves. Because of higher traffic volumes and increased ship dimensions these loads have risen. In contrast to short-periodic secondary waves, the long-periodic wave system is not taken into account in existing design approaches so far. In the framework of the project “Ship-induced long-periodic loads for the design of cover layers on maritime waterway structures” small-scale 2D physical model tests have been performed in order to quantify the specific overflow and overtopping rate taking into account different geometries, surface roughnesses and permeabilities of the structures as well as stationary overflow, short- and long-periodic waves. Furthermore, the stability of the structures under short- and long-periodic wave loads has been observed. These tests provide the basis for the design of cover layers on river structures in maritime waterways.


Author(s):  
Lorenzo Cappietti ◽  
Irene Simonetti ◽  
Andrea Esposito ◽  
Maximilian Streicher ◽  
Andreas Kortenhaus ◽  
...  

Wave-Overtopping loads on vertical walls, such as those located on top of a dike, have been investigated in several small-scale experiments in the past. A large-scale validation for a mild foreshore situation is still missing. Hence the WALOWA (WAve LOads on WAlls) experimental campaign was carried out to address this topic. This paper, first presents a description of the large-scale model, the measurement set-up and the experimental methodologies, then it focuses on the layer thicknesses and velocities of the flows created on the promenade by the wave overtopping. A set of resistive wave gauges, ultrasonic distance sensors and velocimeters have been used to conduct these measurements. Preliminary data analysis and results, related to a 1000 irregular waves long test, are discussed. The momentum flux of these flows is studied and its implications, for the wave-overtopping loads acting on the vertical walls, are highlighted.


2018 ◽  
Vol 2018 ◽  
pp. 1-9
Author(s):  
Fengde Wang ◽  
Wensheng Xiao ◽  
Qi Liu ◽  
Lei Wu ◽  
Zhanbin Meng

In order to determine whether a special sea area and its sea state are available for the jack-up riser with surface blowout preventers, an analytical method is presented to estimate the jack-up riser’s wave loading fatigue life in this study. In addition, an approximate formula is derived to compute the random wave force spectrum of the small-scale structures. The results show that the response of jack-up riser is a narrow band random vibration. The infinite water depth dispersion relation between wavenumber and wave frequency can be used to calculate the wave force spectrum of small-scale structures. The riser’s response mainly consists of the additional displacement response. The fatigue life obtained by the formula proposed by Steinberg is less than that of the Bendat method.


2011 ◽  
Vol 1 (32) ◽  
pp. 17
Author(s):  
Gisa Ludwigs ◽  
Hocine Oumeraci ◽  
Tijl Staal

Permeable revetments made of bonded mineral aggregates may increasingly be favoured compared to standard revetments. However, the physical processes associated with the water–structure–soil-interaction for a wide range of wave conditions are still not well understood. Therefore, systematic large-scale model tests have been performed in the Large Wave Flume (GWK) of the Coastal Research Centre (FZK) in Hannover, with the intention of improving the understanding of these processes.


Sign in / Sign up

Export Citation Format

Share Document