Fine modelling and control of three-phase PWM inverter based on average model method

2021 ◽  
Author(s):  
Yu Guo ◽  
Dong Dong ◽  
Yougui Guo
Author(s):  
José Luis Viramontes-Reyna ◽  
Josafat Moreno-Silva ◽  
José Guadalupe Montelongo-Sierra ◽  
Erasmo Velazquez-Leyva

This document presents the results obtained from the application of the law of Lens to correctly identify the polarity of the windings in a three-phase motor with 6 exposed terminals, when the corresponding labeling is not in any situation; Prior to identifying the polarity, it should be considered to have the pairs of the three windings located. For the polarity, it is proposed to feed with a voltage of 12 Vrms to one of the windings, which are identified randomly as W1 and W2, where W1 is connected to the voltage phase of 12 Vrms of the signal and W2 to the voltage reference to 0V; by means of voltage induction and considering the law of Lens, the remaining 4 terminals can be identified and labeled as V1, V2, U1 and U2. For this process a microcontroller and control elements with low cost are used.


Author(s):  
Jingwen Chen ◽  
Hongshe Dang

Background: Traditional thyristor-based three-phase soft starters of induction motor often suffer from high starting current and heavy harmonics. Moreover, both the trigger pulse generation and driving circuit design are usually complicated. Methods: To address these issues, we propose a novel soft starter structure using fully controlled IGBTs in this paper. Compared to approaches of traditional design, this structure only uses twophase as the input, and each phase is controlled by a power module that is composed of one IGBT and four diodes. Results: Consequently, both driving circuit and control design are greatly simplified due to the requirement of fewer controlled power semiconductor switches, which leads to the reduction of the total cost. Conclusion: Both Matlab/Simulink simulation results and experimental results on a prototype demonstrate that the proposed soft starter can achieve better performances than traditional thyristorbased soft starters for Starting Current (RMS) and harmonics.


Energies ◽  
2021 ◽  
Vol 14 (2) ◽  
pp. 282
Author(s):  
Seon-Ik Hwang ◽  
Jang-Mok Kim

The common-mode voltage (CMV) generated by the switching operation of the pulse width modulation (PWM) inverter leads to bearing failure and electromagnetic interference (EMI) noises. To reduce the CMV, it is necessary to reduce the magnitude of dv/dt and change the frequency of the CMV. In this paper, the range of the CMV is reduced by using opposite triangle carrier for ABC and XYZ winding group, and the change in frequency in the CMV is reduced by equalizing the dwell time of the zero voltage vector on ABC and XYZ winding group of dual three phase motor.


2007 ◽  
Vol 22 (4) ◽  
pp. 2108-2115 ◽  
Author(s):  
S. A. Saleh ◽  
T. S. Radwan ◽  
M. A. Rahman
Keyword(s):  

Sign in / Sign up

Export Citation Format

Share Document