Improvements in simulation of atmospheric boundary layer parameters through data assimilation in ARPS mesoscale atmospheric model

Author(s):  
D. Bala Subrahamanyam ◽  
Radhika Ramachandran ◽  
P. K. Kunhikrishnan
2019 ◽  
Vol 147 (5) ◽  
pp. 1581-1591 ◽  
Author(s):  
Qian Wang ◽  
Su-Ping Zhang ◽  
Shang-Ping Xie ◽  
Joel R. Norris ◽  
Jian-Xiang Sun ◽  
...  

Abstract A research vessel sailing across a warm eddy in the Kuroshio Extension on 13 April 2016 captured an abrupt development of stratocumulus under synoptic high pressure. Shipboard observations and results from regional atmospheric model simulations indicate that increased surface heat flux over the ocean eddy lowered surface pressure and thereby accelerated southeasterly winds. The southeasterly winds transported moisture toward the low pressure and enhanced the air–sea interface heat flux, which in turn deepened the low pressure and promoted low-level convergence and rising motion over the warm eddy. The lifting condensation level lowered and the top of the marine atmospheric boundary layer (MABL) rose, thereby aiding the development of the stratocumulus. Further experiments showed that 6°C sea surface temperature anomalies associated with the 400-km-diameter warm eddy accounted for 80% of the total ascending motion and 95% of total cloud water mixing ratio in the marine atmospheric boundary layer during the development of stratocumulus. The synthesis of in situ soundings and modeling contributes to understanding of the mechanism by which the MABL and marine stratocumulus respond to ocean eddies.


2021 ◽  
Author(s):  
Tobias Sebastian Finn ◽  
Gernot Geppert ◽  
Felix Ament

Abstract. We revise the potential of assimilating atmospheric boundary layer observations into the soil moisture. Previous studies often stated a negative assimilation impact of boundary layer observations on the soil moisture analysis, but recent developments in physically-consistent hydrological model systems and ensemble-based data assimilation lead to an emerging potential of boundary layer observations for land surface data assimilation. To explore this potential, we perform idealized twin experiments for a seven-day period in Summer 2015 with a coupled atmosphere-land modelling platform. We use TerrSysMP for these limited-area simulations with a horizontal resolution 1.0 km in the land surface component. We assimilate sparse synthetic 2-metre-temperature observations into the land surface component and update the soil moisture with a localized Ensemble Kalman filter. We show a positive assimilation impact of these observations on the soil moisture analysis during day-time and a neutral impact during night. Furthermore, we find that hourly-filtering with a three-dimensional Ensemble Kalman filter results in smaller errors than daily-smoothing with a one-dimensional Simplified Extended Kalman filter, whereas the Ensemble Kalman filter additionally allows us to directly assimilate boundary layer observations without an intermediate optimal interpolation step. We increase the physical consistency in the analysis for the land surface and boundary by updating the atmospheric temperature together with the soil moisture, which as a consequence further reduces errors in the soil moisture analysis. Based on these results, we conclude that we can merge the decoupled data assimilation cycles for the land surface and the atmosphere into one single cycle with hourly-like update steps.


2010 ◽  
Vol 10 (2) ◽  
pp. 5051-5090 ◽  
Author(s):  
S. Crumeyrolle ◽  
P. Tulet ◽  
L. Garcia-Carreras ◽  
C. Flamant ◽  
D. J. Parker ◽  
...  

Abstract. Aerosol properties were measured during an airborne campaign experiment that took place in June 2006 in West Africa within the framework of the African Monsoon Multidisciplinary Analyses (AMMA). The goal of the present study was to determine the process that facilitates the sedimentation of dust particles from the Saharan Air Layer (SAL) to the boundary layer. A significant change in the dust particle concentration measured along the meridian between Niamey (Niger) and Cotonou (Benin) was found in the boundary layer (~700 m), where the dust particle concentration increased in a zone where local emission is not possible. Moreover, the boundary layer top observed with the dropsondes launched with the F-F20 shows a strong relationship with the surface cover anomalies, with higher Boundary Layer (BL) tops over the warmer surfaces, such as croplands, as opposed to adjacent forest. A mesoscale atmospheric model with a new on-line dust parameterization, resulting from the Alfaro and Gomes (2001) parametrisation and AMMA observations, was used to interpret the impact of vegetation anomalies on dust particle sedimentation. The results of the simulation are consistent with the observations, with higher dust over the warm surface cover anomalies.


2017 ◽  
Vol 74 (7) ◽  
pp. 2363-2382 ◽  
Author(s):  
Lichuan Wu ◽  
Anna Rutgersson ◽  
Erik Nilsson

Abstract Over the ocean, atmospheric boundary layer turbulence can be altered by underlying waves. Under swell conditions, the impact of waves on the atmosphere is more complicated compared to that under wind-wave conditions. Based on large-eddy simulation (LES), the wind-following swell impact on the atmospheric boundary layer is investigated through three terms: swell-induced surface momentum flux, the vertical profile of swell-induced momentum flux, and the swell impact on atmospheric mixing. The swell-induced surface momentum flux displays a decreasing trend with increasing atmospheric convection. The swell-induced momentum flux decays approximately exponentially with height. Compared with atmospheric convection, the decay coefficient is more sensitive to wave age. Atmospheric mixing is enhanced under swell conditions relative to a flat stationary surface. The swell impact on the atmospheric boundary layer is incorporated into a turbulence closure parameterization through the three terms. The modified turbulence closure parameterization is introduced into a single-column atmospheric model to simulate LES cases. Adding only the swell impact on the atmospheric mixing has a limited influence on wind profiles. Adding both the impact of swell on the atmospheric mixing and the profile of swell-induced momentum flux significantly improves the agreement between the 1D atmospheric simulation results and the LES results, to some extent simulating the wave-induced low-level wind jet. It is concluded that the swell impact should be included in atmospheric numerical models.


2007 ◽  
Vol 25 ◽  
pp. 49-55 ◽  
Author(s):  
S. Argentini ◽  
I. Pietroni ◽  
G. Mastrantonio ◽  
A. Viola ◽  
S. Zilitinchevich

Sign in / Sign up

Export Citation Format

Share Document