Bender bar transducers for low‐frequency underwater sound sources

1979 ◽  
Vol 65 (S1) ◽  
pp. S127-S127
Author(s):  
C. A. Sheridan ◽  
O. L. Akervold
1994 ◽  
Author(s):  
Peter H. Rogers ◽  
Gary W. Caille ◽  
Thomas N. Lewis

2021 ◽  
Vol 263 (3) ◽  
pp. 3436-3447
Author(s):  
Dan Lin ◽  
Andrew Eng

Assumptions made on the ground types between sound sources and receivers can significantly impact the accuracy of environmental outdoor noise prediction. A guideline is provided in ISO 9613-2 and the value of ground factor ranges from 0 to 1, depending on the coverage of porous ground. For example, a ground absorption factor of 1 is suggested for grass ground covers. However, it is unclear if the suggested values are validated. The purpose of this study is to determine the sound absorption of different types of ground by measurements. Field noise measurements were made using an omnidirectional loudspeaker and two microphones on three different types of ground in a quiet neighborhood. One microphone was located 3ft from the loudspeaker to record near field sound levels in 1/3 and 1 octave bands every second. The other microphone was located a few hundred feet away to record far field sound in the same fashion as the near field microphone. The types of ground tested were concrete, grass, and grass with trees. Based on the measurement data, it was found that grass and trees absorb high frequency sound well and a ground factor of 1 may be used for 500Hz and up when using ISO 9613-2 methodology. However, at lower frequencies (125 Hz octave band and below), grassy ground reflects sound the same as concrete surfaces. Trees absorb more low frequency sound than grass, but less than ISO 9613-2 suggested.


Sensors ◽  
2018 ◽  
Vol 18 (11) ◽  
pp. 3674 ◽  
Author(s):  
Wei Lu ◽  
Yu Lan ◽  
Rongzhen Guo ◽  
Qicheng Zhang ◽  
Shichang Li ◽  
...  

A spiral sound wave transducer comprised of longitudinal vibrating elements has been proposed. This transducer was made from eight uniform radial distributed longitudinal vibrating elements, which could effectively generate low frequency underwater acoustic spiral waves. We discuss the production theory of spiral sound waves, which could be synthesized by two orthogonal acoustic dipoles with a phase difference of 90 degrees. The excitation voltage distribution of the transducer for emitting a spiral sound wave and the measurement method for the transducer is given. Three-dimensional finite element modeling (FEM)of the transducer was established for simulating the vibration modes and the acoustic characteristics of the transducers. Further, we fabricated a spiral sound wave transducer based on our design and simulations. It was found that the resonance frequency of the transducer was 10.8 kHz and that the transmitting voltage resonance was 140.5 dB. The underwater sound field measurements demonstrate that our designed transducer based on the longitudinal elements could successfully generate spiral sound waves.


2008 ◽  
Vol 617 ◽  
pp. 231-253 ◽  
Author(s):  
DANIEL J. BODONY ◽  
SANJIVA K. LELE

An analysis of the sound radiated by three turbulent, high-speed jets is conducted using Lighthill's acoustic analogy (Proc. R. Soc. Lond. A, vol. 211, 1952, p. 564). Computed by large eddy simulation the three jets operate at different conditions: a Mach 0.9 cold jet, a Mach 2.0 cold jet and a Mach 1.0 heated jet. The last two jets have the same jet velocity and differ only by temperature. None of the jets exhibit Mach wave characteristics. For these jets the comparison between the Lighthill-predicted sound and the directly computed sound is favourable for all jets and for the two angles (30° and 90°, measured from the downstream jet axis) considered. The momentum (ρuiuj) and the so-called entropy [p − p∞ − a∞2(ρ − ρ∞)] contributions are examined in the acoustic far field. It is found that significant phase cancellation exists between the momentum and entropy components. It is observed that for high-speed jets one cannot consider ρuiuj and (p′ − a∞2ρ′)δij as independent sources. In particular the ρ′ūxūx component of ρuiuj is strongly coupled with the entropy term as a consequence of compressibility and the high jet velocity and not because of a linear sound-generation mechanism. Further, in more usefully decoupling the momentum and entropic contributions, the decomposition of Tij due to Lilley (Tech. Rep. AGARD CP-131 1974) is preferred. Connections are made between the present results and the quieting of high-speed jets with heating.


2007 ◽  
Vol 274 (1626) ◽  
pp. 2703-2710 ◽  
Author(s):  
Kenneth K Jensen ◽  
Brenton G Cooper ◽  
Ole N Larsen ◽  
Franz Goller

The principal physical mechanism of sound generation is similar in songbirds and humans, despite large differences in their vocal organs. Whereas vocal fold dynamics in the human larynx are well characterized, the vibratory behaviour of the sound-generating labia in the songbird vocal organ, the syrinx, is unknown. We present the first high-speed video records of the intact syrinx during induced phonation. The syrinx of anaesthetized crows shows a vibration pattern of the labia similar to that of the human vocal fry register. Acoustic pulses result from short opening of the labia, and pulse generation alternates between the left and right sound sources. Spontaneously calling crows can also generate similar pulse characteristics with only one sound generator. Airflow recordings in zebra finches and starlings show that pulse tone sounds can be generated unilaterally, synchronously or by alternating between the two sides. Vocal fry-like dynamics therefore represent a common production mechanism for low-frequency sounds in songbirds. These results also illustrate that complex vibration patterns can emerge from the mechanical properties of the coupled sound generators in the syrinx. The use of vocal fry-like dynamics in the songbird syrinx extends the similarity to this unusual vocal register with mammalian sound production mechanisms.


2015 ◽  
Author(s):  
Kevin M. Lee ◽  
Andrew R. McNeese ◽  
Preston S. Wilson ◽  
Mark S. Wochner

Sign in / Sign up

Export Citation Format

Share Document