Soil-water characteristics of compacted sandy and cemented soils with and without vegetation

2015 ◽  
Vol 52 (9) ◽  
pp. 1331-1344 ◽  
Author(s):  
W.M. Yan ◽  
Guanghui Zhang
Keyword(s):  
Soil Water ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Rapid Development ◽  
Characteristic Curve ◽  
Degree Of Saturation ◽  
Material Density ◽  
Water Characteristics ◽  
Field And Laboratory Conditions ◽  
Humidity Monitoring

Experiments were undertaken to study the soil-water characteristics of compacted sandy soil (SS) and cemented soil (CS) in field and laboratory conditions. The influence of vegetation and material density on the development of negative pore-water pressure (PWP) and degree of saturation (Sr) in the studied materials was investigated. The field planting experiments demonstrated a promising survival rate of Schefflera heptaphylla in both types of material, while the (SS) promoted better growth of the seedlings than the cemented one. In the field study, PWP and Sr of the compacted SS responded noticeably and promptly to natural drying–wetting cycles. However, the responses in the CS were relatively mild. When subjected to the same drying–wetting cycles, PWP responded more slowly and to a smaller magnitude compared with that of the uncemented counterpart. In addition, Sr changed little in CS. An increase in the density of the SS promoted rapid development of negative PWP, while an opposite trend was observed for CS. Attempts have been made to explain the observations from the perspectives of material permeability and change in water content during a drying period in both soil types. Furthermore, in SS, the development of PWP (with a measurement limit of −90 kPa) was minimally affected by the presence of vegetation, while vegetation noticeably helped the development of negative PWP in CS. Bounds of the soil-water characteristic curve (SWCCs) of the studied materials were presented based on estimates from the drying and wetting scanning curves derived from the field monitoring. A corresponding laboratory study was carried out in an environmental chamber with controllable temperature and humidity. Monitoring results from the laboratory agreed qualitatively with those obtained from the field.

scholarly journals Effect of coarse content on shear behavior of unsaturated coarse granular soils

2014 ◽  
Vol 51 (12) ◽  
pp. 1371-1383 ◽  
Author(s):  
H.F. Zhao ◽  
L.M. Zhang
Keyword(s):  
Shear Strength ◽  
Soil Water ◽  
Pore Water ◽  
Critical State ◽  
Characteristic Curve ◽  
Degree Of Saturation ◽  
Shear Strength Parameters ◽  
Strength Parameters ◽  
Water Characteristics ◽  
Highly Nonlinear

The effects of coarse content on the microstructure, soil-water characteristics, shearing behavior, and critical state characteristics of three types of unsaturated coarse granular soil with different coarse contents are investigated in an integrated manner through an extensive laboratory test program. The tests were performed on samples with the same void ratio of 0.62. As the coarse content increases, the pore-size distribution of the soil changes from unimodal to bimodal. Accordingly, the soil-water characteristic curve (SWCC) changes from unimodal to bimodal. The whole drainage process of the bimodal SWCC is divided into four stages based on the role of the pore water. The contribution of suction to the peak state parameters and critical state parameters, except for the intercept of the critical state line in the stress plane (μ(s)) of a bimodal soil, reaches its maximum in the first drainage region. The pore water in the two pore series of a bimodal soil contributes to the shear strength differently during the desaturation process. Hence, the variations of the maximum dilatancy and the shear strength parameters with degree of saturation are highly nonlinear and μ(s) shows bimodal features. The contributions of suction to the shear strength parameters decrease with increasing coarse content.

A numerical study of coupled consolidation in unsaturated soils

1998 ◽  
Vol 35 (6) ◽  
pp. 926-937 ◽  
Author(s):  
Tai T Wong ◽  
Delwyn G Fredlund ◽  
John Krahn
Keyword(s):  
Soil Water ◽  
Pore Water ◽  
Unsaturated Soils ◽  
Pore Water Pressure ◽  
Numerical Study ◽  
Water Pressure ◽  
Characteristic Curve ◽  
Soil Column ◽  
Pressure Response ◽  
Soil Water Characteristic Curve

This paper first describes the numerical implementation of the coupled formulation for the theory of consolidation of unsaturated soils. The developed computer code is verified using the Mandel-Cryer problem and then is applied to the solution of coupled multidimensional consolidation problems. Using a parametric study, it is demonstrated that, in unsaturated soils, the Mandel-Cryer effect is suppressed and the consolidation process in unsaturated soils is affected significantly by the shape of the soil-water characteristic curve. Finally, the developed model is used to analyze the consolidation of an unsaturated-saturated soil column. Analysis results indicate that the classical "undrained" pore-water pressure response to an externally applied load only occurs in the saturated zone while the pore-water pressure response is subdued in the unsaturated zone. This paper also shows a method of deriving one of the two additional material parameters required for the analysis of unsaturated soils from laboratory test results.Key words: coupled consolidation, unsaturated soils, Mandel-Cryer effect, soil-water characteristic curve.

Measurement of Soil Suction and Soil-Water Characteristics of Bentonite-Sand Mixtures

2010 ◽  
Author(s):  
Pan Hu ◽  
Qing Yang ◽  
Maotian Luan
Keyword(s):  
Soil Water ◽  
Vapor Phase ◽  
Unsaturated Soils ◽  
Characteristic Curve ◽  
Phase Method ◽  
Soil Suction ◽  
Compacted Bentonite ◽  
Water Characteristics ◽  
Wide Range ◽  
High Level

The soil-water characteristic curve (SWCC) is a widely used experimental means for assessing fundamental properties of unsaturated soils for a wide range of soil suction values. The study of SWCC is helpful because some properties of unsaturated soils can be predicted from it. Nowadays, much attention has been paid to the behaviours of highly compacted bentonite-sand mixtures used in engineering barriers for high level radioactive nuclear waste disposal. It is very important to study the various performances of bentonite-sand mixtures in order to insure the safety of high-level radioactive waste (HLW) repository. After an introduction to vapor phase method and osmotic technique, a laboratory study has been carried out on compacted bentonite-sand mixtures. The SWCC of bentonite-sand mixtures has been obtained and analyzed. The results show that the vapor phase method and osmotic technique is suitable to the unsaturated soils with high and low suction.

scholarly journals Impact of the moisture content in medium sands on CPTU test results

2016 ◽  
Vol 48 (3) ◽  
pp. 221-231 ◽  
Author(s):  
Łukasz Zawadzki ◽  
Marek Bajda
Keyword(s):  
Moisture Content ◽  
Unsaturated Soils ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Degree Of Saturation ◽  
Test Results ◽  
Time Dynamic ◽  
Tip Resistance ◽  
The Impact ◽  
Resistance Value

Abstract Soils occurring in the soil “active zone” are in contact with the surface and are directly influenced by external factors (mainly climatic changes) that cause variation in their parameters over time. Dynamic and uncontrolled changes of soil properties e.g. due to rainfall and evapotranspiration processes may affect field test results leading to the misinterpretation of the obtained data. This paper presents investigations on the influence of moisture content changes in sandy soils on CPTU results. For this purpose, a field ground model has been constructed and five CPTU tests with a different moisture content of soil were carried out. During the investigations, the tip resistance (qc), friction on sleeve (fs), and pore water pressure (u2) were measured. Moreover, a TDR probe was applied to determine the distribution of the moisture content in the studied soil columns. Differences between CPT results obtained in saturated and unsaturated soils have been shown. Furthermore, a simple equation to correct the tip resistance value due to the impact of the degree of saturation has been proposed.

Soil-water characteristic curve and consolidation behavior for a compacted silt

2007 ◽  
Vol 44 (3) ◽  
pp. 266-275 ◽  
Author(s):  
Trinh Minh Thu ◽  
Harianto Rahardjo ◽  
Eng-Choon Leong
Keyword(s):  
Soil Water ◽  
Volume Change ◽  
Unsaturated Soils ◽  
Water Pressure ◽  
Characteristic Curve ◽  
Matric Suction ◽  
Confining Stress ◽  
Soil Water Characteristic Curve ◽  
Triaxial Cell ◽  
Isotropic Consolidation

Measurement of the soil-water characteristic curve (SWCC) in the laboratory is commonly conducted under zero confining pressure. However, in the field, the soil is under a confining stress. Therefore, it is important to study the effects of the confining stress on SWCC. In addition, the consolidation curve is normally generated under saturated conditions. However, the soil above the water table is usually unsaturated. Hence, it is also necessary to investigate the effects of matric suction on the characteristics of the consolidation curves. This paper presents the SWCCs under different net confining stresses and the isotropic consolidation curves under different matric suctions that describe the volume change characteristics of unsaturated soils with respect to stress state variables, net normal stress, and matric suction. A series of SWCCs was determined for statically compacted silt specimens in a triaxial cell apparatus under different net confining stresses. Isotropic consolidation tests under different matric suctions were also carried out. The results of the SWCC tests show that the air-entry value increased with increasing net confining stress. The yield points (i.e., yield suction, s0) obtained from the SWCC tests also increased with increasing net confining stress. The results of isotropic consolidation tests indicate the strong influence of matric suction on compressibility and stiffness of the compacted silt specimens.Key words: soil-water characteristic curve, isotropic consolidation, pore-water pressure, volume change, NTU mini suction probe, matric suction.

scholarly journals Numerical Simulation Of The Treatment Of Soil Swelling Using Grid Geocell Columns

2015 ◽  
Vol 23 (2) ◽  
pp. 9-18 ◽  
Author(s):  
Mohammed Y. Fattah ◽  
Raid R. Al-Omari ◽  
Haifaa A. Ali
Keyword(s):  
Finite Element ◽  
Pore Water ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Expansive Soil ◽  
Matric Suction ◽  
Degree Of Saturation ◽  
Axial Forces ◽  
Column Material ◽  
Cap Model

Abstract In this paper, a method for the treatment of the swelling of expansive soil is numerically simulated. The method is simply based on the embedment of a geogrid (or a geomesh) in the soil. The geogrid is extended continuously inside the volume of the soil where the swell is needed to be controlled and orientated towards the direction of the swell. Soils with different swelling potentials are employed: bentonite base-Na and bentonite base-Ca samples in addition to kaolinite mixed with bentonite. A numerical analysis was carried out by the finite element method to study the swelling soil's behavior and investigate the distribution of the stresses and pore water pressures around the geocells beneath the shallow footings. The ABAQUS computer program was used as a finite element tool, and the soil is represented by the modified Drucker-Prager/cap model. The geogrid surrounding the geocell is assumed to be a linear elastic material throughout the analysis. The soil properties used in the modeling were experimentally obtained. It is concluded that the degree of saturation and the matric suction (the negative pore water pressure) decrease as the angle of friction of the geocell column material increases due to the activity of the sand fill in the dissipation of the pore water pressure and the acceleration of the drainage through its function as a drain. When the plasticity index and the active depth (the active zone is considered to be equal to the overall depth of the clay model) increase, the axial movement (swelling movement) and matric suction, as a result of the increase in the axial forces, vary between this maximum value at the top of the layer and the minimum value in the last third of the active depth and then return to a consolidation at the end of the depth layer.

scholarly journals Behaviour of Unsaturated Subgrade Soil Under Highway Load

2019 ◽  
Vol 12 (1) ◽  
pp. 23-33
Author(s):  
Ghassan Nasser Jaffer
Keyword(s):  
Water Table ◽  
Pore Water Pressure ◽  
Layer Structure ◽  
Water Pressure ◽  
Degree Of Saturation ◽  
Fe Model ◽  
Center Line ◽  
Water Table Level ◽  
Subgrade Soil ◽  
Dynamic Loadings

This paper studied the application of 2-D Plaxis (v8.6, 2011) software on a pavement layer structure set on unsaturated subgrade soil. An axisymmetric finite element (FE) model was used to analyze the behavior of pavement layers subjected to dynamic loadings. The model was loaded with an incremental contact pressure from 50 to 550 kPa with different variable such as water table level (1,2 and 3m), suction of soil and degree of saturation (100, 90, 80, 70 and 20%). The results indicated that during loading on pavement layer with increases water table level and different degree of saturation the vertical settlement was decreased by about (11, 15, and 18%) for water table level= 1m, (9, 13, 16%) for water table level= 2m and (28%) for water table level= 3m (dry soil) respectively. The effect of degree of saturation on the vertical settlement is apparent at the lower value for water table level (1 and 2m) and the vertical settlement is decreased with increasing soil suction. The results also show the negative pore water pressure decreased with decreased of degree of saturation and development increases with depth and beginning of dynamic load. The effect of unsaturation greater at the center line of pavement layer and limited far away the center line.

Sign in / Sign up

Export Citation Format

Share Document