The photolysis of glyoxylic acid vapour has been studied at five wavelengths, 382, 366, 346, 275, and 239 nm, and pressures from about 1 to 6 Torr, at a temperature of 355 K. Major products were CO2 and CH2O, initially formed in almost equal amounts, while minor products were CO and H2. Except at 382 nm, the system was complicated by the rapid secondary photolysis of CH2O. Three primary processes are suggested, each involving internal H-atom transfer followed by dissociation.The absorption spectrum is reported and shows the three distinct absorption systems. A finely-structured spectrum from about 320 to 400 nm is attributed to a transition to the first excited π* ← n+ singlet state; a more diffuse absorption ranging from about 290 nm to a maximum at 239 nm is assigned to the π* ← n− state, while a much stronger absorption beginning below 230 nm is attributed to the π* ← π transition. Product ratios vary with wavelength and depend on which excited state is involved.The thermal decomposition was studied briefly in a static system at temperatures from 470 to 710 K and pressures from 0.4 to 8 Torr. Major products were again CO2 and CH2O, but the latter was always less than stoichiometric. First-order rate constants for the apparently homogeneous formation of CO2 are described by Arrhenius parameters log A (s−1) = 7.80 and E = 30.8 kcal/mol. Carbon monoxide and H2 were minor products, and the CO/CO2 ratio increased with increasing temperature and showed some surface enhancement at lower temperatures. The SF6-sensitized thermal decomposition of glyoxylic acid, induced by a pulsed CO2 laser, was briefly studied, with temperatures estimated to be in the 1100–1600 K range, and the CO/CO2 ratio increased with increasing temperature, continuing the trend observed in the static system.
Thermal decomposition of mercerized linter cellulose and its acetates obtained from a homogeneous reaction