A NEMATIC REPLICA OF A HOLOGRAPHIC POLARIZATION GRATING: MODELING OF THE IDEAL AND A CORRUGATED SURFACE

2006 ◽  
Vol 15 (01) ◽  
pp. 23-32 ◽  
Author(s):  
S. P. PALTO ◽  
M. I. BARNIK ◽  
A. V. ARBUZOV ◽  
B. A. UMANSKII ◽  
L. M. BLINOV

When a nematic liquid crystal layer is brought in contact with a photosensitive polymer, on which a holographic grating is recorded by two laser beams with opposite circular polarization, due to a spatial modulation of the direction of the local optical axis, the photopolymer modulates the anchoring conditions for NLC in a similar way. As a result, a similar grating is induced in NLC with the enhanced diffraction efficiency and specific diffraction properties controlled by electric field.6 Here we show that, even in the case of a typical finite value of the anchoring energy, the numerical modeling confirms the characteristic asymmetric diffraction of the circularly polarized reconstructing beam and exchange by energy between the zero and first-order diffracted beams. Some other properties, such as reduced diffraction efficiency, appearance of higher diffraction orders and too-large optical phase retardation of a nematic cell at the areas occupied by gratings, can also be modeled by assuming some corrugation of the surface.

2017 ◽  
Vol 10 (2) ◽  
pp. 333-357
Author(s):  
D.M. OLIVEIRA ◽  
N.A. SILVA ◽  
C.C. RIBEIRO ◽  
S.E.C. RIBEIRO

Abstract In this paper the simplified method to evaluate final efforts using γ z coefficient is studied considering the variation of the second order effects with the height of the buildings. With this purpose, several reinforced concrete buildings of medium height are analyzed in first and second order using ANSYS software. Initially, it was checked that the (z coefficient should be used as magnifier of first order moments to evaluate final second order moments. Therefore, the study is developed considering the relation (final second order moments/ first order moments), calculated for each story of the structures. This moments relation is called magnifier of first order moments, "γ", and, in the ideal situation, it must coincide with the γ z value. However, it is observed that the reason γ /γ z varies with the height of the buildings. Furthermore, using an statistical analysis, it was checked that γ /γ z relation is generally lower than 1.05 and varies significantly in accordance with the considered building and with the presence or not of symmetry in the structure.


2007 ◽  
Vol 364-366 ◽  
pp. 719-723
Author(s):  
Quan Liu ◽  
Jian Hong Wu ◽  
Ling Ling Fang ◽  
Chao Ming Li

A fused silica phase mask with the period of 1069nm, and ruled area 50×50mm2 has been fabricated by a new technique, which combines holographic-ion beam etching and reactive ion beam etching. This involves several steps: coating of substrates with controlled thickness of photoresist, formation of a grating mask by holograph interference exposure and development, and finally transferring etching of this mask into the fused silica substrate to form a permanent phase mask. Experimental measurements have shown that the zero order diffraction efficiency is less than 4% and the plus and minus first-order diffraction efficiency is more than 35%. Theoretical analysis has shown that these phase masks can be used for fabricating UV written Fiber Bragg Gratings.


2018 ◽  
Vol 83 (2) ◽  
pp. 213-220
Author(s):  
Sung Kim ◽  
Pankaj Attri ◽  
In Kim

In this paper, photosensitive materials for information storage devices are presented. The polymers were prepared using surface relief-grating (SRG) fabrication with a diode-pumped solid-state (DPSS) laser of 532 nm, and the diffraction efficiency (DE) of the polymers were assessed with a low-power DPSS laser at 633 nm. However, the diffraction efficiency of the azo-functionalized epoxy-based polymer was low, even after 15 min of exposure. To improve the efficiency and reduce the time it takes for the DE measurements of the photosensitive polymer, the polymer was combined ionic liquids (ILs). Various ILs, i.e., 1-methylimidazolium chloride ([Mim]Cl) from the imidazolium family of ILs and diethylammonium dihydrogen phosphate (DEAP), triethylammonium 4-aminotoluene-3-sulfonic acid (TASA) and tributylmethylammonium methyl sulphate (TBMS) from the ammonium family of ILs, were investigated. For the first time, it was observed that DE dramatically increased the DEAP?polymer mixture in 4 min compared to the polymer (alone) and other polymer?IL mixtures. Therefore, DEAP IL could help improve the efficiency of DE measurements in a shorter time.


1983 ◽  
Vol 132 ◽  
pp. 163-183 ◽  
Author(s):  
William S. Vorus

This paper proposes a high-Reynolds-number theory for the approximate analysis of timewise steady viscous flows. Its distinguishing feature is linearity. But it differs fundamentally from Oseen's (1910) well-known linear theory. Oseen flow is a variation on Stokes flow at the low-Reynolds-number limit.The theory is developed for a %dimensional body moving through an infinite incompressible fluid. The velocity-vorticity formulation is employed. A boundary integral expressing the body contour velocity is written in terms of Green functions of the approximate governing differential equations. The boundary integral contains three unknown boundary distributions. These are a velocity source density, the boundary vorticity, and the normal gradient of the boundary vorticity. The unknown distributions are determined as the solutions to a boundary-integral equation formed from the velocity integral by the prescription of zero relative fluid velocity on the body boundary.The linear integral-equation formulation is applied specifically to the case of thin bodies, such that the boundary condition is satisfied approximately on the streamwise coordinate axis. The integral equation is then reduced to its leading-order contribution in the limit of infinite Reynolds number. The unknown distributions uncouple in the first-order formulation, and analytic solutions are obtained. A most interesting result appears at this point: the theory recovers linearized airfoil theory in the first-order infinite-Reynolds-number limit; the airfoil integral equation determines one of the three contour distributions sought.The first-order theory is then demonstrated by application to two classical cases: the zero-thickness flat plate at zero incidence, and the circular cylinder.For the flat plate, the streamwise velocity near the plate predicted by the proposed linear theory is compared with that of Blasius's solution to the laminar boundary-layer equations (Schlichting 1968). The linear theory predicts a fuller profile, tending more toward the character expected of the timewise steady turbulent profile. This character is also exhibited in the predicted velocity distribution across the plate wake, which is compared with Goldstein's asymptotic boundary-layer solution (Schlichting 1968). The wake defect is more severe according to the proposed theory.For the case of the circular cylinder, application of the formulation is not truly valid, since the circular cylinder is not a thin body. The theory does, however, predict that the flow separates. The separation points are predicted to lie at position angles of approximately ± 135°, with angle measured from the forward stagnation point. This compares with the prediction of 109O from the Blasius series solution to the laminar boundary-layer equations (Schlichting 1968).The theory is next applied to the case of a non-zero-thickness flat plate with incidence. From the fully attached flow at zero incidence, the theory predicts that both Ieading-edge separation and reattachment and trailing-edge separation appear on the suction side at small angle. On increasing incidence, the forward reattachment point moves aft, and the aft separation point moves forward. Coalescence occurs near midchord, and the foil is thereafter fully separated.Finally, the first-order contribution to the far-field velocity at high Reynolds number is shown to be identically that corresponding to the ideal flow. This result, coupled with the recovery of linearized thin-foil theory in the near-field limit, is argued to support strongly the physical idea that the ideal flow is, in fact, the limiting state of the complete field flow at infinite Reynolds number. Flow separation can be viewed as present in the ideal flow limit; i t is simply embedded in the infinitesimally thin body-surface vortex sheets into which the entire viscous field collapses as vorticity convection overwhelms vorticity diffusion at the infinite-Reynolds-number limit.


2006 ◽  
Author(s):  
Yung-Hsun Wu ◽  
Ju-Hyun Lee ◽  
Yi-Hsin Lin ◽  
Hongwen Ren ◽  
Shin-Tson Wu

1970 ◽  
Vol 48 (18) ◽  
pp. 2135-2154 ◽  
Author(s):  
T. H. Cheung ◽  
Allan Griffin

Making use of the finite-temperature version of Beliaev's field-theoretical description of an interacting Bose gas, we sum the self-energy diagrams which correspond to the collisionless shielded potential approximation (SPA). This generalizes Bogoliubov's first-order results by replacing the bare repulsive interaction by a dynamically shielded interaction and includes the effect of the excited atoms. This theory is completely equivalent to that of Tserkovnikov if we use the ideal Bose gas approximation for the polarization function which screens the two-particle interaction. The excitation spectrum is found to have a single resonance. We do not find any convincing evidence for the additional high frequency second sound mode obtained by Tserkovnikov.


2021 ◽  
Vol 129 (4) ◽  
pp. 378
Author(s):  
Г.И. Грейсух ◽  
Е.Г. Ежов ◽  
О.А. Захаров ◽  
С.В. Казин

The image formed by a refractive-diffractive optical system for the mid-IR range (3–5 µm) is investigated. The effect of the side diffraction orders of the diffractive corrector on the quality of this image near the optical axis is estimated both by computer simulation and experimentally. It is shown that the side diffraction orders of a single-layer sawtooth relief-phase microstructure will not noticeably affect the image quality under the following condition: the diffraction efficiency of the microstructure at the central wavelength of the operating spectral range is close to unity, and within the entire indicated spectral range it does not drop below 0.67.


2020 ◽  
Vol 28 (17) ◽  
pp. 24399 ◽  
Author(s):  
Xiaolin Wu ◽  
Yuanqiang Peng ◽  
Huixin Qiu ◽  
Kaihui Chen ◽  
You Wu ◽  
...  

2003 ◽  
Author(s):  
C. Chou ◽  
W. C. Kuo ◽  
H. K. Teng ◽  
J. G. Chang ◽  
Y. S. Liao

Sign in / Sign up

Export Citation Format

Share Document